Plastic clays in subgrade may cause major engineering defects such as excessive heave or settlement during the wet season that contribute to the formation of uneven geometry at the pavement surface. Soil stabilization is often a requisite to ameliorate the engineering properties of soft soils or reactive clays. This study investigates the application of nano-silica and nano-alumina to improve the California bearing ratio (CBR) of a local clay. The clay was treated with cement (2%–8%), with nano-additive (0.1%–1.5%) and with cement and nano-additive (3% cement + 0.1%–1.5% nano-additive). The compacted sample was cured for 7 days and subjected to soaked and unsoaked CBR tests. The soaked CBR of the nontreated clay increased by 49% and 27% for 1% nano-silica and 1% nano-alumina treated clay, respectively. Although 3% cement addition improved the CBR of the soaked clay by 28%, the combination of 3% cement with 1% nano-silica and nano-alumina resulted in 196% and 164% increase in the soaked CBR of the nontreated clay, respectively. The combination of nano-additives and cement yielded the same soaked CBR as if 6%–7% cement would have been used. Clay treated with 1% nano-silica and 3% cement achieved the highest CBR value within the tested samples and the sample treated with 1% nano-alumina and 3% cement achieved the lowest free swell potential. The scanning electron microscopy (SEM) micrographs of the treated clay showed the formation of uniform fabric with fewer pore spaces and calcium silicate hydrate (CSH)/calcium aluminate hydrate (CAH) products within the fabric of nano-additive treated clay.
Low bearing capacity soils may pose serious construction concerns such as reduced bearing capacity and excessive hydro-associated volume changes. Proper soil remediation techniques must be planned and implemented before commencing any construction on low bearing capacity soils. Environmentally friendly soil stabilizers are gradually replacing traditional soil stabilizers with high carbon dioxide emissions such as lime and cement. This study investigated the use of an alternative pozzolanic mix of nano-additives (i.e., nano-silica and nano-alumina) and cement to reduce the usage of cement for achieving competent soil stabilization outcomes. A series of unconfined compressive strength (UCS), direct shear, and durability tests were conducted on marl specimens cured for 1, 7, and 28 days stabilized with nano-additives (0.1~1.5%), 3% cement, and combined 3% cement and nano-additives. The UCS and shear strength of stabilized marl increased with nano-additives up to a threshold nano-additive content of 1% which was further intensified with curing time. Nano-additive treated cemented marl specimens showed long durability under the water, while the cemented marl decomposed early. The microfabric inspection of stabilized marl specimens showed significant growth of calcium silicate hydrate (CSH) products within the micro fabric of nano-silica treated marl with reduced pore-spaces within aggregated particles. The results confirmed that nano-additives can replace cement partially to achieve multi-fold improvement in the strength characteristics of the marl.