Mineralisation of calcium phosphates in bone has been proposed to proceed via an initial amorphous precursor phase which transforms into nanocrystalline, carbonated hydroxyapatite. While calcium phosphates have been under intense investigation, the exact steps during the crystallisation of spherical amorphous particles to platelet-like bone apatite are unclear. Herein, we demonstrate a detailed transformation mechanism of amorphous calcium phosphate spherical particles to apatite platelet-like crystals, within the confined nanodomains of a bone-inspired nanocomposite. The transformation is initiated under the presence of humidity, where nanocrystalline areas are formed and crystallisation advances via migration of nanometre sized clusters by forming steps at the growth front. We propose that such transformation is a possible crystallisation mechanism and is characteristic of calcium phosphates from a thermodynamic perspective and might be unrelated to the environment. Our observations provide insight into a crucial but unclear stage in bone mineralisation, the origins of the nanostructured, platelet-like bone apatite crystals.
We study the influence of the heteroepitaxial interface on the defect content of nonpolar -plane GaN grown on -plane sapphire, using transmission electron microscopy techniques and the topological theory of interfacial defects. The structural mismatch is accommodated in different ways along distinct in-plane directions. For the misfit along the [0001] direction of GaN, the basal stacking faults constitute the principal relaxation mechanism, through their delimiting partial dislocations. The misfit along is relaxed by misfit dislocations that have out-of-plane Burgers vectors causing rotational misorientations of the epilayer about [0001]. These misorientations lead to the introduction of low-angle tilt grain boundaries which are defect sources through their associated primary lattice dislocations. Furthermore, semipolar nanocrystals can nucleate on sapphire -plane nanofacets, causing the introduction of threading dislocations (TDs) and stacking faults, when these nanocrystals are overgrown by the nonpolar epilayer. The semipolar nanocrystals bear a high-symmetry 90° orientation relative to the nonpolar epilayer. The interfacial dislocations at the nonpolar/semipolar boundaries have suitable Burgers vectors to become TDs. These grain boundaries also promote the introduction of stacking faults and pockets of cubic GaN. The coexistence of semipolar orientation variants leads to twin boundaries and associated dislocations.
Semipolar (11-22)-oriented InGaN/GaN quantum dots (QDs) emitting in the 380–620 nm spectral range were synthesized by plasma-assisted molecular-beam epitaxy. The influence of the growth temperature on the properties of InGaN QDs has been investigated by photoluminescence and transmission electron microscopy. Growth temperatures low enough to prevent indium desorption provide a favorable environment to semipolar plane (11-22) to enhance the internal quantum efficiency of InGaN/GaN nanostructures.
GaN quantum dots (QDs) grown in semipolar AlN by plasma-assisted molecular-beam epitaxy were studied by transmission electron microscopy (TEM) and scanning transmission electron microscopy techniques. The embedded -grown QDs exhibited pyramidal or truncated-pyramidal morphology consistent with the symmetry of the nucleating plane, and were delimited by nonpolar and semipolar nanofacets. It was also found that, in addition to the surface, QDs nucleated at depressions comprising facets. This was justified by ab initio density functional theory calculations showing that such GaN/AlN facets are of lower energy compared to . Based on quantitative high-resolution TEM strain measurements, the three-dimensional QD strain state was analyzed using finite-element simulations. The internal electrostatic field was then estimated, showing small potential drop along the growth direction, and limited localization at most QD interfaces.
Heteroepitaxial non-polar III-Nitride layers may exhibit extensive anisotropy in the surface morphology and the epilayer microstructure along distinct in-plane directions. The structural anisotropy, evidenced by the “M”-shape dependence of the x-ray rocking curve widths on the beam azimuth angle, was studied by combining transmission electron microscopy observations, Raman spectroscopy, high resolution x-ray diffraction, and atomic force microscopy in a-plane GaN epilayers grown on r-plane sapphire substrates by plasma-assisted molecular beam epitaxy (PAMBE). The structural anisotropic behavior was attributed quantitatively to the high dislocation densities, particularly the Frank-Shockley partial dislocations that delimit the I1 intrinsic basal stacking faults, and to the concomitant plastic strain relaxation. On the other hand, isotropic samples exhibited lower dislocation densities and a biaxial residual stress state. For PAMBE growth, the anisotropy was correlated to N-rich (or Ga-poor) conditions on the surface during growth, that result in formation of asymmetric a-plane GaN grains elongated along the c-axis. Such conditions enhance the anisotropy of gallium diffusion on the surface and reduce the GaN nucleation rate.