Date palm trees, being an important source of nutrition, are grown at a large scale in Saudi Arabia. The biomass waste of date palm, discarded of in a non-environmentally-friendly manner at present, can be used for biofuel generation through the fast pyrolysis technique. This technique is considered viable for thermochemical conversion of solid biomass into biofuels in terms of the initial investment, production cost, and operational cost, as well as power consumption and thermal application cost. In this study, a techno-economic analysis has been performed to assess the feasibility of converting date palm waste into bio-oil, char, and burnable gases by defining the optimum reactor design and thermal profile. Previous studies concluded that at an optimum temperature of 525 °C, the maximum bio-oil, char and gases obtained from pyrolysis of date palm waste contributed 38.8, 37.2 and 24% of the used feed stock material (on weight basis), respectively, while fluidized bed reactor exhibited high suitability for fast pyrolysis. Based on the pyrolysis product percentage, the economic analysis estimated the net saving of USD 556.8 per ton of the date palm waste processed in the pyrolysis unit. It was further estimated that Saudi Arabia could earn USD 44.77 million per annum, approximately, if 50% of the total date palm waste were processed through fast pyrolysis, with a payback time of 2.57 years. Besides that, this intervention will reduce 2029 tons of greenhouse gas emissions annually, contributing towards a lower carbon footprint.

Power generation from fossil fuels is the biggest challenge in the next half of the century. Alternative power generation techniques such as solar photovoltaic (PV) show potential to act as a future fuel with a challenge to efficiently convert the harvested solar energy into electrical power. This investigation conclusively focused on setting a 2.160-kW solar PV system capable of working at a higher efficiency by developing a mechanical structure that optimizes power production and minimizes energy losses. In addition to that, solar PV system efficiencies at various tracking positions, performance coefficients during rainy and sunny days, and system degradation rates have also been investigated. The PVsyst v6.8 simulation tool was used to obtain the simulated results, which were compared with the actual experimental results. The parameters considered for the investigations include ambient temperature, irradiance, solar PV module surface temperature, solar PV voltage and current, wind velocity, and atmospheric turbidity. The solar PV system was evaluated based on two modes, namely, M₁ (no tracking/fixed type) and M₂ (manual tracking by changing the position of the solar PV system every hour). The predictive results obtained using PVsyst v6.8 concluded that total energy production from the installed system was 3,242 kWh/yr and 3,984 kWh/yr for M₁ and M₂, respectively. The performance ratio (PR), obtained from simulation, was 72% and 78% for M₁ and M_2, respectively, which was consistent with the experimental results, i.e., 70% and 72% for M₁ and M₂, respectively. Similarly, the power conversion efficiencies under standard temperature and conditions for both modes, simulated and experimental, were found to be 16.50% and 12.75%, respectively. The estimated degradation rate was observed in the range of −0.6% to −5.0%.