A depth-resolved Raman spectroscopy technique was used to study the residual stress profiles in polycrystalline silicon nitride that was irradiated with Xe (167 MeV, 1 × 1011 cm−2 ÷ 4.87 × 1013 cm−2) and Bi (710 MeV, 1 × 1011 cm−2 ÷ 1 × 1013 cm−2) ions. It was shown that both the compressive and tensile stress fields were formed in the irradiated specimen, separated by a buffer zone that was located at a depth that coincided with the thickness of layer, amorphized due to multiple overlapping track regions. The compressive stresses were registered in a subsurface region, while at a greater depth, the tensile stresses were recorded and their levels reached the maximum value at the end of ion range. The size of the amorphous layer was evaluated from the dose dependence of the full width at half maximum (FWHM) (FWHM of the dominant 204 cm−1 line in the Raman spectra and scanning electron microscopy.
The world is currently facing a drinking water problem. Human activity, climate change and pollution of existing water bodies are exacerbating the problem. The scientists around the world are currently trying to purify water using effective and inexpensive methods. One such method is membrane distillation. Membrane distillation is a versatile thermally driven membrane separation process. This method of water purification has the potential to remove salts and other non-volatile components. The work is concerned with the desalination of salt solutions by membrane distillation using ion-track membranes based on polyethylene terephthalate (PET). PET ion-track membranes (PET TMs) were modified by photoinitiated graft polymerization of 2,2,3,3,4,4,4-heptafluorobutyl methacrylate (HFBMA) to make them hydrophobic. Optimal polymerization conditions (monomer concentration, reaction time) were determined, which led to an increase of water CA from 51 to 105°. The obtained membranes were used to purify the solution from NaCl. The effect of salt concentration as well as membrane properties on performance and degree of purification was studied. The results show that large pore size PET TMs modified with HFBMA has the potential to desalinate water in an efficient manner.
Copper(II) oxide nanoparticles with an average size of 52 ± 5 nm are synthesized by wet combustion of the extract of coronate saw-wort (Serratula coronata L.) growing on the territory of Central Kazakhstan. The complex study of the structure and composition of the synthesized nanoparticles by scanning electron microscopy, energy-dispersive spectroscopy, and X-ray phase analysis shows that the nanoparticles contain no additional impurities, have the monoclinic structure, and possess a high degree of crystallinity; the average size of crystallites is 28 ± 4 nm. Catalytic activity is tested in methylene blue dye degradation under exposure to visible light (500 W, 7500 lm). The degradation efficiency is studied as a function of catalyst mass and initial dye concentration. It is shown that even at a catalyst loading of 10 mg more than 54% of the dye degrades in the reaction mixture. The study of catalyst stability demonstrates that the efficiency of degradation decreases by 6.1 and 33.3% after the second and fifth test cycle, respectively.
A multiscale modeling is applied to investigate structural changes caused by impacts of swift heavy ions in Si3N4 nanoclusters imbedded into amorphous and crystalline silicon nitride matrices. The approach combines the Monte Carlo code TREKIS describing the excitation kinetics of electronic and atomic subsystems and a classical molecular dynamics tracing subsequent relaxation of lattice atoms. Ion impacts in amorphous and crystalline Si3N4 result in formation of a cylindrical amorphous region of a reduced material density, surrounded by a shell with an increased density. The track diameter inside a nanosized inclusion in crystalline or amorphous matrices was found smaller than in surrounding materials, which can be explained by a heat confinement by grain boundaries.
Electrochemical sensors have been developed based on polyethylene terephthalate track-etched membranes (PET TeMs) modified by photograft copolymerization of N-vinylformamide (N-VFA) and trimethylolpropane trimethacrylate (TMPTMA). The modification, structure and properties of the modified PET TeMs were thoroughly characterized using scanning electron microscopy (SEM) and atomic force microscopy (AFM), thermogravimetric analysis (TGA), Fourier-transform infrared (FTIR) spectroscopy, gas permeability measurements and contact angle analysis. Optimal membrane modification was achieved using C = 10% (N-VFA), 60 min of UV irradiation and a UV lamp distance of 10 cm. Furthermore, the modified membranes were implemented in a two-electrode configuration for the determination of Eu3+, Gd3+, La3+ and Ce3+ ions via square-wave anodic stripping voltammetry (SW-ASV). The sensors exhibited a linear detection range from 10−7 M to 10−3 M, with limits of detection of 1.0 × 10−6 M (Eu3+), 6.0 × 10−6 M (Gd3+), 2.0 × 10−4 M (La3+) and 2.5 × 10−5 M (Ce3+). The results demonstrated a significant enhancement in electrochemical response due to the grafted PET TeMs-g-N-PVFA-TMPTMA structure, and the sensor showed practical applicability and consistent performance in detecting rare earth ions in tap water.
Depth-resolved Raman piezospectroscopy was used to study residual mechanical stress profiles in polycrystalline silicon and aluminum nitrides irradiated with 710 MeV bismuth ions to fluences of 1×1012, 2×1012, and 1×1013 cm-2. It was found that stress fields of opposite signs are formed in the irradiated Si3N4 layer, separated by a buffer zone located at a depth coinciding with the thickness of the sample layer, amorphized at high ion fluences due to multiple overlapping of track regions. At great depths, tensile stresses witch magnitude reaches their maximum value in the region of the end of the ion range are detected. In contrast to Si3N4, radiation-stimulated changes in mechanical stresses in AlN were within the measurement error throughout the entire thickness of the irradiated layer, except of the near-surface region. The observed effect is associated with the different structural sensitivity of silicon and aluminum nitrides to high-density ionization - the formation of amorphous latent tracks in Si3N4 and their absence in AlN. Методы рамановской пьезоспектроскопии с пространственным разрешением в данной работе были использованы для изучения профилей остаточных механических напряжений в поликристаллических нитридах кремния и алюминия, облученных высокоэнергетическими ионами висмута c энергией 710 МэВ до флюенсов 1 × 1012, 2 × 1012 и 1 × 1013 см-2. По результатам установлено, что в облученном слое Si3N4 формируются поля напряжений различного знака, разделенные буферной зоной, находящейся на глубине, совпадающей с толщиной слоя образца, аморфизованного при высоких флюенсах ионов за счет многократного перекрытия трековых областей. На больших глубинах регистрируются растягивающие напряжения, уровень которых достигает максимального значения в области конца пробега ионов. Показано что, в отличие от Si3N4, уровень радиационно-стимулированного изменения механических напряжений в AlN был в пределах ошибки измерений по всей толщине облученного слоя, только за исключением приповерхностной области. Наблюдаемый эффект связывается с разной структурной чувствительностью нитридов кремния и алюминия к воздействию ионизации высокой плотности – образованием аморфных латентных треков в Si3N4 и их отсутствием в AlN. Кеңістіктік ажыратылымдылығы бар Рамандық пьезоспектроскопия әдістері 1 × 1012, 2 × 1012 және 1 × 1013 см-2 флюенске дейін энергиясы 710 МэВ жоғары энергиялы висмут иондарымен сәулеленген бұл жұмысьа поликристалды кремний мен алюминий нитридтеріндегі қалдық механикалық кернеулердің профильдерін зерттеу үшін пайдаланылды. Сәулеленген Si3 N4 қабатында трек аудандарының бірнеше рет қабаттасуы есебінен иондардың жоғары флюенсі кезінде аморфизацияланған үлгі қабатының қалыңдығына сәйкес келетін тереңдікте орналасқан тректік аймақпен бөлінген түрлі белгілердің кернеу өрістері қалыптасатыны зерттеу нәтижесінде анықталды. Үлкен тереңдікте созылу кернеулері тіркелетіні көрсетілді, олардың деңгейі иондар жүгірісінің соңындағы аймақтағы максималды мәнге жететіні анықталды. Si3 N4 - тен айырмашылығы, AlN - дегі механикалық кернеулердің радиациялық - ынталандырылған өзгеру деңгейі беттік аймақты қоспағанда, сәулеленген қабаттың бүкіл қалыңдығы бойынша өлшеу қатесінің шегінде болды. Байқалатын әсер кремний мен алюминий нитридтерінің жоғары тығыздықтағы ионизация әсеріне әртүрлі құрылымдық сезімталдығымен – Si3 N4 - те аморфты латентті тректердің түзілуімен және олардың AlN-де болмауымен байланысты деген қортынды жасалды.