Deformable and miniaturized energy storage devices are essential for powering soft electronics. Herein, we fabricate deformable micro supercapacitors (MSCs) based on eutectic gallium-indium liquid metal (EGaIn) current collectors with integrated graphene. The well-define interdigitated electrode patterning with controlled gap is successfully realized by using the laser ablation because of a strong laser absorption of graphene and EGaIn. By judicious control of gap size between neighboring interdigitated electrodes and mass loading of graphene, we achieve a high areal capacitance (1336 µF cm−2) with reliable rate performance. In addition, owing to the intrinsic liquid characteristics of EGaIn current collector, the areal capacitance of fabricated MSC retains 90% of original value even after repetitive folding and 20% stretching up to 1000 cycles. Finally, we successfully integrate deformable MSC with a commercial light-emitting diode to demonstrate the feasibility of MSC as a deformable power source. The fabricated MSCs operate stably under various mechanical deformations, including stretching, folding, twisting, and wrinkling.
28 March 2024 in IEEE Antennas and Wireless Propagation Letters
This paper proposes a novel rhombic dual-polarized and dual-band patch antenna array design for 5G mmWave mobile devices as an antenna-in-package (AiP). The proposed antenna consists of a stacked patch and a parasitic patch that are designed to operate at dual frequencies (28 and 39GHz). An asymmetric stack-up strategy is used to maximize antenna performance within the constraints of the form factor. To address the limitations of elongated asymmetrical structures, the rhombic patch is utilized to achieve dual-polarization capabilities. The RF front-end module (RFFE), which integrates the proposed AiP (1×4 array antenna), is also fabricated and tested for its gain and beam-steering performance. The results show a maximum gain of 10.4 dBi at the lower band (LB) and 11.0 dBi at the higher band (HB) with beam-steering capabilities of ±45 degrees in both bands.
Nanostructures for a piezoresistive pressure sensor should be considered in terms of the interdigitated contacts formed through face-to-face assembly of the two electrodes to improve pressure-detecting performances.
High- k polymeric layers with UV-assisted organic azide fluorine-based crosslinkers lead to dramatic improvements in the electrical performance of OFETs and integrated devices.
The field of printed electronics for highly integrated circuits and energy devices demands very fine and highly conductive electric interconnections. In this study, conductive lines having a high cross-sectional aspect ratio were printed via the inkjet printing of Ag nanoparticle inks assisted by a laser-induced selective surface wetting technique: a hydrophobic layer of self-assembled monolayer-treated ZnO nanorods was coated on a glass substrate and selectively ablated by a laser to form micro-channels for the inkjet, whose surface energy changed from 36.3 mJ/m2 to 51.5 mJ/m2 before and after the laser irradiation. With the varying width of the laser-ablated channels and pitch of jetted ink drops, the 3D shapes of the printed silver lines were measured to investigate their effects on the widths, heights, and uniformities of the printed patterns. The results showed that the present technique realized a uniform line of 35 μm width and 0.46 μm average thickness, having an aspect ratio of 0.013, which is 7.6 times higher than that printed on bare glass.