The paper is focused on the Fe for Co substitution effect on the redox and catalytic properties in the perovskite structure of GdFeO3. The solid oxides with the composition GdFe1−xCoxO3 (x = 0; 0.2; 0.5; 0.8; 1) were obtained by the sol-gel method and characterized by various methods: X-ray diffraction (XRD), temperature-programmed reduction (H2-TPR), N2 sorption, temperature-programmed desorption of oxygen (TPD-O2), simultaneous thermal analysis (STA), and X-ray photoelectron spectroscopy (XPS). The H2-TPR results showed that an increase in the cobalt content in the GdFe1−xCoxO3 (x = 0; 0.2; 0.5; 0.8; 1) leads to a decrease in the reduction temperature. Using the TPD-O2 and STA methods, the lattice oxygen mobility is increasing in the course of the substitution of Fe for Co. Thus, the Fe substitution in the perovskite leads to an improvement in the oxygen reaction ability. Experiments on the soot oxidation reveal that catalytic oxidation ability increases in the series: GdFe0.5Co0.5O3 ˂ GdFe0.2Co0.8O3 ˂ GdCoO3, which is in good correlation with the increasing oxygen mobility according to H2-TPR, TPD-O2, and STA results. The soot oxidation over GdFeO3 and GdFe0.8Co0.2O3 is not in this range due to the impurities of iron oxides and higher specific surface area.
The effect of the substitution of cobalt into the GdFeO3 perovskite structure on the selective hydrogenation of CO was investigated. A series of GdCoxFe1−xO3 (x = 0; 0.2; 0.5; 0.8; 1) samples were synthesized by sol-gel technology and characterized by XRD, BET specific area, DSC, TG, EDX and XPS. The experimental data made it possible to reveal a correlation between the state of iron and cobalt atoms, the fractions of surface and lattice oxygen, and catalytic characteristics. It has been found that varying the composition of GdCoxFe1−xO3 complex oxides leads to a change in the oxygen-metal binding energy in Gd-O-Me, the ratio of metals in various oxidation states, and the amount of surface and lattice oxygen, which affects the adsorption and catalytic characteristics of complex oxides.
The effect of strontium substitution in the structure of the complex oxide Gd2SrFe2O7 on the production of light olefins by CO hydrogenation was investigated. Perovskite-type oxides Gd2−xSr1+xFe2O7 (x = 0; 0.1; 0.2; 0.3; 0.4) were synthesized by sol–gel technology and characterized by XRD, Mössbauer spectroscopy, BET specific area, acidity testing, and SEM. The experimental data revealed a correlation between the state of iron atoms, acidity, and catalytic performance. It was found that with an increase in the content of Sr2+ in the perovskite phase, the basicity of the surface and the oxygen diffusion rate increased. This contributed to the CO dissociative adsorption, formation of active carbon, and its further interaction with atomic hydrogen.
4 December 2020 in Russian Journal of Physical Chemistry A
GdMn1 –xFexO3 (x = 0, 0.2, 0.5, 0.8, 1) perovskite oxides were prepared by a sol–gel method. The catalytic activity in dry reforming of methane was examined. XRD, BET, TPR, and TGA techniques have been used to characterize structural properties, reducibility and carbonization of the catalyst. The H2-TPR data show that an increase in the Mn content in the series of GdMn1 –xFexO3 compounds (x = 0, 0.2, 0.5, 0.8, 1) leads to a decrease in the reduction temperature. The study of the catalytic properties in the reaction of dry reforming of methane (DRM) showed that the catalytic activity of the studied compounds depends on the Fe content and increases in the series: GdMnO3 < GdMn0.8Fe0.2O3 < GdMn0.2Fe0.8O3 < GdFeO3.