The catalytic properties of complex perovskite-type gadolinium and strontium oxides in carbon dioxide reforming of methane and the production of gaseous olefins by carbon monoxide hydrogenation have been studied. Samples of Gd2SrFe2O7 and Gd2–xSr1+xFe2O7 (х = 0.1; 0.2; 0.3; and 0.4) have been obtained by the sol–gel method and ceramic technology, and have been characterized by means of X-ray diffraction, scanning electron microscopy, photon correlation spectroscopy, Mössbauer spectroscopy, and N2 adsorption–desorption analysis. It has been shown that the sol–gel method allows us to produce samples with better catalytic characteristics than ceramic systems. The nonisovalent substitution of Gd3+ for Sr2+ distorts the structure of complex oxide, resulting in the emergence of the heterovalent state of iron atoms (Fe3+ and Fe4+) reflected in the values of reactant conversion and selectivity for the target products. A sample of Gd2–xSr1+xFe2O7 with х = 0.3 displays the highest catalytic activity in dry reforming of methane reforming, along with the highest selectivity for unsaturated hydrocarbons (ethylene and propylene) in hydrogenation of carbon monoxide.
Perovskite-type complex oxides GdFeO3 and GdCo0.5Fe0.5O3 synthesized by the sol–gel method and gadolinium ferrite modified with cobalt oxide (5 wt %) are studied as catalysts for the dry reforming of methane. Single-phase catalysts with the perovskite orthorhombic crystal structure and an average particle size of 100–200 nm are synthesized. Catalytic activity testing shows that the surface modification of gadolinium ferrite with cobalt, as well as the introduction of Co directly into the crystal structure to form a GdCo0.5Fe0.5O3 solid solution, leads to the formation of new catalytically active sites and provides an increase in the activity of GdFeO3. The sample with cobalt oxide deposited on the surface is highly resistant to coking.
The catalytic activity of nanostructured perovskite-type ferrites of gadolinium and strontium, has been studied. The intercorrelation between the catalytic activity and the method used to obtain ferrites has been shown: the products formation rates are higher in the samples obtained by a ceramic technology, while the sol-gel method makes it possible to obtain ferrites with a greater hydrogen selectivity, which is accounted for by their nanocrystalline state and porous structure. It is shown that the specific catalytic activity of the catalysts, which are prepared by the same method and are of approximately the same chemical composition, is constant. It is shown that a nonisovalent replacement of gadolinium by strontium causes symmetry lowering in the perovskite structure and the appearance of a heterovalent state of iron atoms, which affects ferrite catalytic activity.
In this paper, the features of catalytic cracking of propane with a step-wise change in the composition of the catalyst from Pr2Zr2O7 to Yb2Zr2O7 were considered. For the research, samples of catalysts Pr2Zr2O7, (Pr0.75Yb0.25)2Zr2O7, (Pr0.5Yb0.5)2Zr2O7, (Pr0.25Yb0.75)2Zr2O7 and Yb2Zr2O7 were synthesized and analyzed. Analysis of the results from catalytic experiments showed that for the catalyst (Pr0.25Yb0.75)2Zr2O7, at a temperature of 700 °C, the conversion of propane reaches values of 100%, but for Yb2Zr2O7, this indicator decreases to 84%. The selectivity for ethylene is consistently reduced from 85% to 28% in several catalysts (Pr0.75Yb0.25)2Zr2O7 > Pr2Zr2O7 > (Pr0.5Yb0.5)2Zr2O7 >(Pr0.25Yb0.75)2Zr2O7 > Yb2Zr2O7. An increase in the number of surface adsorption centers leads to a predominant rupture of the C–C bond in the propane molecule with the formation of ethylene. When ytterbium ions are introduced into the catalyst, the amount of ethylene in the reaction products decreases, but the selectivity for propylene increases in the series Pr2Zr2O7 < (Pr0.75Yb0.25)2Zr2O7 < (Pr0.5Yb0.5)2Zr2O7 < Yb2Zr2O7 < (Pr0.25Yb0.75)2Zr2O7, which is associated with a decrease in the binding energy of carbon atoms in propane with the catalytic center during adsorption.
The effect of the substitution of cobalt into the GdFeO3 perovskite structure on the selective hydrogenation of CO was investigated. A series of GdCoxFe1−xO3 (x = 0; 0.2; 0.5; 0.8; 1) samples were synthesized by sol-gel technology and characterized by XRD, BET specific area, DSC, TG, EDX and XPS. The experimental data made it possible to reveal a correlation between the state of iron and cobalt atoms, the fractions of surface and lattice oxygen, and catalytic characteristics. It has been found that varying the composition of GdCoxFe1−xO3 complex oxides leads to a change in the oxygen-metal binding energy in Gd-O-Me, the ratio of metals in various oxidation states, and the amount of surface and lattice oxygen, which affects the adsorption and catalytic characteristics of complex oxides.