Karthick Murukesan

Mr. Karthick Murukesan

orcid

Research Focus & Metrics

Academic Career Length

15Years (2012-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
28 June 2019 in IEEE Electron Device Letters
Verified
Journal Article
Closed access
LELoizos Efthymiou
Loizos Efthymiou
KMKarthick Murukesan
Karthick Murukesan
GGiorgia Longobardi
Giorgia Longobardi
FUFlorin Udrea
Florin Udrea
ASAyman Shibib
Ayman Shibib
KTKyle Terrill
Kyle Terrill
In this letter we investigate by means of experimental results and TCAD simulations the threshold voltage instability due to off-state drain stress in p-GaN gate AlGaN/GaN-on-Si HEMTs. When the drain of the p-GaN HEMT is biased in the off-state the threshold voltage (Vth) shows a linear increase up to ∼ 40%. This increase saturates at drain bias voltages above 50V. The positive Vth shift is attributed to the ionization of acceptor traps in the AlGaN region below the p-GaN gate with the source of these trapping sites suggested to be the p-GaN gate out-diffused Mg dopant atoms. The ionization of the Mg acceptors due to high electric field during off-state bias and the removal of the generated holes from the AlGaN region through the gate contact creates the charge conditions for a positive Vth shift. The sharp decrease in the gate drain capacitance (Cgd) for VD < 50V, the simulated gate edge electric field reaching its peak for a drain voltage bias VD ∼ 50V and the positive threshold voltage shift observed for negative gate stress further validate the proposed model.

10 September 2021 in IEEE Journal of the Electron Devices Society
Verified
Journal Article
Open access
KMKarthick Murukesan
Karthick Murukesan
LELoizos Efthymiou
Loizos Efthymiou
FUFlorin Udrea
Florin Udrea
For large scale testability of p-GaN HEMTs it is essential to investigate threshold voltage (Vth) instability from the perspective of the measurement induced instability. In this paper the impact of accumulated gate bias stress during standard transfer characteristic measurements (ID-VG) in a p-GaN AlGaN/GaN-on-Si normally off HEMT is quantitatively analysed and modelled. This illustrates the associated threshold voltage (Vth) instabilities and leads to a better understanding of the Vth measurement challenges of a p-GaN HEMT. Upon an application of a constant gate bias close to nominal Vth the drain current ID shows an initial marginal rise, followed by a short stable period (IDstable-Tzone) and a steep decay period. The effective bias history built on the gate stack varies when pulse on-time (Ton) or step time (Tstep), corresponding to pulsed or DC step ID-VG measurements, are varied. We find that this can lead to a Vth variation of up to 20%. It is also observed that the choice of Ton and Tstep determines whether ID is measured in IDstable-Tzone or the rise or decay periods. Measurement induced Vth instability is attributed to trapping of 2DEG electrons at the AlGaN barrier and we demonstrate that an ohmic gate contact, in comparison to the Schottky gate contact, may compensate for the trapped 2DEG electrons by hole injection across the AlGaN barrier. Experimental results of Vth stability under the same stress conditions for a Schottky and ohmic gate contact are supported by a detailed TCAD analysis.

15 October 2024 in Journal of Physics D: Applied Physics
Verified
Journal Article
Open access
KMKarthick Murukesan
Karthick Murukesan
LELoizos Efthymiou
Loizos Efthymiou
FUFlorin Udrea
Florin Udrea
In this report, a comprehensive review of the variations in threshold voltage (V TH) that could arise due to different V TH measurement techniques, V TH measurement bias conditions and V TH extraction techniques is made. Notably, a standard deviation of 15% is observed in threshold voltage values due to variations in measurement methodology and bias conditions. This variation is attributed to the change in the dynamic gate charge conditions across the gate stack and lateral electric field conditions across the gate and drain, which occur due to the change in measurement conditions and the bias conditions, respectively. No significant variations arise due to the V TH extraction technique. Additionally, a simplified physical interpretation of the gate stack in normally off p-GaN gate/AlGaN/GaN on Si high electron mobility transistors is made. The formation of the two-dimensional electron gas, the charge balance within the p-GaN/AlGaN/GaN gate stack and an analytical expression for the threshold voltage are reviewed and examined. Furthermore, various trapping mechanisms within the gate stack are reviewed to comprehend the dynamic conditions potentially contributing to threshold voltage instability during nominal operation.

1 June 2014
Verified
Conference Paper
Closed access
KMKarthick Murukesan
Karthick Murukesan
SKSandeep Kumbhar
Sandeep Kumbhar
AKA K Kapoor
A K Kapoor
ADA Dhaul
A Dhaul
SSSaravanan S.
Saravanan S.
BAB M Arora
B M Arora
A systematic investigation of POCl 3 based diffusion optimization for the formation of homogeneous emitters in P type c-Si solar cells is presented. The gas composition, exhaust rates, flat zone temperature profile have been varied to achieve uniform sheet resistance across each wafer and wafers along the boat. A one standard deviation of ~ 5 ohm/square has been achieved on 125 mm × 125 mm mono like wafers from the initial variation of 37 ohm/square. In addition to the sheet resistance, secondary ion mass spectroscopy, ellipsometry, life time and emitter saturation current density measurements are performed for better understanding of the optimization.

1 June 2012
Verified
Conference Paper
Closed access
KMKarthick Murukesan
Karthick Murukesan
DRD V Sridhara Rao
D V Sridhara Rao
KMK Muraleedharan
K Muraleedharan
AKA K Kapoor
A K Kapoor
ADA Dhaul
A Dhaul
BAB M Arora
B M Arora
Diffusion of boron into silicon produces a layer of silicon boride just above the diffused region. By using transmission electron microscopy, it is shown that the boride layer has island morphology, which could be result of precipitation/clustering of boron beyond critical concentration. X ray diffraction measurement suggests the layer to be composed of mixed phase consisting of amorphous matrix of silicon boride with some SiBx crystalline fraction. Fourier transform infrared spectroscopy (FTIR) and secondary ion mass spectrometry (SIMS) measurements provide additional insight into the nature of the surface region.

18 October 2024 in Electronics
Verified
Journal Article
Open access
PDF file
KMKarthick Murukesan
Karthick Murukesan
FUFlorin Udrea
Florin Udrea
In this study, we propose a simple measurement technique to quantitatively measure the time taken by threshold voltage of normally-off p-GaN AlGaN/GaN HEMTs to recover from a nominal operational gate stress-induced instability. The proposed technique eliminates the requirement to perform a full transfer characteristic sweep post-stress, thereby eliminating the measurement-induced instability effect, often colluding precise recovery time measurement. The rate of recovery and extracted recovery times hold significance in empirically correlating the location of traps in the p-GaN or AlGaN barrier region causing VTH instability. The gate of the HEMT is stressed at nominal operational drive voltages 1.5 V, 2 V, and 4 V for various time intervals from 500 μs to 100 s, and the time taken for the drain current to recover to prestress levels measured at near-threshold voltage (~1.1 VTH) is measured as the threshold voltage recovery time. With increasing gate stress voltages, 2DEG gets trapped at relatively deeper trap energy levels at the AlGaN/GaN interface requiring more emission time during the process of recovery, mandating larger recovery times. At higher stress voltage of 4 V, the Schottky gate leakage current is high enough enabling injected holes to cross the AlGaN barrier and counter-compensate for the deeply trapped 2DEG, requiring relatively the same recovery times as lower stress voltages where the gate leakage is negligibly small. With increasing stress time, the amount of 2DEG trapped increases, requiring more recovery time to de-trap and beyond a certain time, saturation of the trap density occurs causing the recovery time to plateau.