In this letter we investigate by means of experimental results and TCAD simulations the threshold voltage instability due to off-state drain stress in p-GaN gate AlGaN/GaN-on-Si HEMTs. When the drain of the p-GaN HEMT is biased in the off-state the threshold voltage (Vth) shows a linear increase up to ∼ 40%. This increase saturates at drain bias voltages above 50V. The positive Vth shift is attributed to the ionization of acceptor traps in the AlGaN region below the p-GaN gate with the source of these trapping sites suggested to be the p-GaN gate out-diffused Mg dopant atoms. The ionization of the Mg acceptors due to high electric field during off-state bias and the removal of the generated holes from the AlGaN region through the gate contact creates the charge conditions for a positive Vth shift. The sharp decrease in the gate drain capacitance (Cgd) for VD < 50V, the simulated gate edge electric field reaching its peak for a drain voltage bias VD ∼ 50V and the positive threshold voltage shift observed for negative gate stress further validate the proposed model.
With Gallium Nitride (GaN) device technology for power electronics applications being ramped up for volume production, an increasing amount of research is now focused on the performance of GaN power devices in circuits. In this study, an enhancement mode GaN high electron mobility transistor (HEMT) is switched in a clamped inductive switching configuration with the aim of investigating the source of oscillatory effects observed. These arise as a result of the increased switching speed capability of GaN devices compared to their silicon counterparts. The study identifies the two major mechanisms (Miller capacitance charge and parasitic common source inductance) that can lead to ringing behaviour during turn-off and considers the effect of temperature on the latter. Furthermore, the experimental results are backed by SPICE modelling to evaluate the contribution of different circuit components to oscillations. The study concludes with good design techniques that can suppress the effects discussed.
20 May 2019 in Japanese Journal of Applied Physics
This paper analyzes the possible physical mechanisms responsible of high vertical leakage in GaN-on-Si power transistors. Vertical leakage and back bias measurement are presented and compared against TCAD simulations with the aim of identifying the physical phenomena and parameters that impact the vertical leakage. An easy-to-implement TCAD approach for simulating the non-ideality of the AlN nucleation layer and AlN/Si interface is introduced. Finally, a method to largely suppress the vertical leakage via implantation of highly doped p ++ wells at the AlN/Si interface is proposed and investigated via TCAD simulations. The suggested technique allows for a reduction of five orders of magnitude in the leakage current when a p ++ surface doping in excess of 5 × 10 19 cm −3 is implanted at the Si-substrate surface. In this work, a normally-on HEMT is investigated but the analysis can be extended to any GaN-on-Si power device.
29 September 2017 in IEEE Transactions on Electron Devices
The physical mechanisms involved in the trapping and de-trapping processes associated with surface donor traps in gallium nitride (GaN) transistors are discussed in this paper. The paper challenges the conventional transient techniques adopted for extrapolating the trap energy level via experiments and TCAD simulations. Transient TCAD simulations were employed to reproduce the time-dependent electrical behavior of a metal-on-insulator field-effect transistor and explain the influence of the electric field and energy barrier on the transient time associated with the trapping and de-trapping mechanisms of surface traps. The comparison between three test structures and the relative variation of the trapping and de-trapping times with the bias and trap parameters leads to the suggestion of a proposed test structure and bias configuration to accurately extrapolate the energy level of surface traps in GaN transistors.
25 March 2019 in IEEE Transactions on Electron Devices
This paper investigates the advantages and disadvantages of bonding pad over active area (BPOA) layout over a conventional layout for lateral AlGaN/GaN HEMTs designed for use in power applications. Extensive analysis of the performance of a BPOA device, both experimentally and supported by 3-D TCAD model simulations, reveals that while it can offer a higher current capability per unit area, it can lead to other disadvantages compared to a conventional design when considering reliability aspects.
This study presents a detailed analysis of the Plasma‐enhanced chemical vapour deposition (PECVD) silicon‐nitride/semiconductor interface of gallium nitride (GaN) transistors through the study of the transfer characteristics of a large‐gate‐area metal‐insulator‐semiconductor field‐effect transistor (MISFET).
I
d –
V
g measurements were performed on several MISFETs across the wafer and for all of them the authors observed strong hysteresis between forward and reverse sweeps and a double kink. These features indicate the presence of traps beneath the gate electrode. Neither the hysteresis nor the kinks were seen in the measured high‐electron‐mobility transistor (HEMT) characteristics suggesting that the passivation/semiconductor interface is electrically responsible for them. The transfer characteristics of the MISFET have been reproduced using a technology computer‐aided design (TCAD) deck that includes fixed charges and donor traps at the passivation/semiconductor interface. The impact of these charges on the
I
d –
V
g and their influence on the formation of a surface‐inversion layer is here explained through extensive TCAD simulations. This study has also been extended to different temperatures between 35 and 75°C to investigate the change in the transfer characteristics at elevated temperatures. It is shown that the hysteresis observed between forward and reverse sweeps and the transconductance decrease significantly with increasing temperature.