Ricardo Osorio Oliveros

Mr. Ricardo Osorio Oliveros

orcid

Research Focus & Metrics

Academic Career Length

1Year (2026-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
26 February 2026 in Progress in Additive Manufacturing
Verified
Journal Article
Open access
PDF file
LCLuis D Cedeno
Luis D Cedeno
MMMariana Macías-Naranjo
Mariana Macías-Naranjo
RORicardo Osorio Oliveros
Ricardo Osorio Oliveros
JSJesús A. Sandoval-Robles
Jesús A. Sandoval-Robles
CRCiro Rodriguez
Ciro Rodriguez
EGErika Garcia-Lopez
Erika Garcia-Lopez

14 January 2026 in Progress in Additive Manufacturing
Verified
Journal Article
Open access
PDF file
LCLuis D Cedeno
Luis D Cedeno
MMMariana Macías-Naranjo
Mariana Macías-Naranjo
RORicardo Osorio Oliveros
Ricardo Osorio Oliveros
JSJesús A. Sandoval-Robles
Jesús A. Sandoval-Robles
CRCiro Rodriguez
Ciro Rodriguez
EGErika Garcia-Lopez
Erika Garcia-Lopez
This study investigates the influence of laser polishing (LP) as a post-processing method for enhancing the surface quality of Laser Powder Bed Fusion (LPBF) components. Cylindrical specimens were manufactured using LPBF processing parameters (i.e., laser power of 150 and 170 W, and point distance of 20 and 30 μm) for a range of specific energies between 5.0 and 8.5 J/mm2. After this process, LP treatment was performed on the top surfaces at energy densities ranging from 0.142 to 0.475 J/mm. Surface characterization was performed by measuring surface roughness (Ra, Rz), height, and surface topography quality. Apparent density and cross-sectional surface porosity of the LPBF were quantified. The results indicated that higher specific energy values (> 7.5 J/mm2) during the LPBF process produced samples with lower surface roughness, reduced porosity (1.42–1.97%), and increased density (7.30–7.36 g/cm2). LP post-processing demonstrated that an energy per unit length of 0.225 J/mm was most effective at reducing the ten-point mean roughness and height across all sample types. The maximum reduction in ten-point surface roughness achieved was 52.5% (from 70.71 μm to 33.58 μm) in samples with a specific energy of 5.33 J/mm2. Microhardness measurements revealed that LP slightly softened the near-surface region (≈ 4 μm depth) in high-porosity samples, while samples with porosity below 2% exhibited higher and more uniform hardness profiles up to 1000 μm. Our findings reveal that LP effectiveness is strongly dependent on initial surface quality and porosity of LPBF components, emphasizing the importance of post-processing stages for achieving a superior surface finish.