The Longtan Formation of the Upper Permian in the Sichuan Basin has become a significant target for shale gas exploration in recent years. Multiple methods, including outcrop observations, thin sections, total organic matter content, X-ray diffraction and scanning electron microscopy were used to investigate the mineralogy, shale lithofacies assemblages and their relationships with the deposition environment. The mineral composition of the Longtan Formation has strong mineral heterogeneity. The TOC values of the Longtan Formation have a wide distribution range from 0.07% to 74.67% with an average value of 5.73%. Four types of shale lithofacies assemblages of the Longtan Formation could be distinguished, as clayey mudstone (CLS), carbonaceous shale (CAS), siliceous shale (SS) and mixed shale (MS) on the basis of mineral compositions. The TOC values of various types of shale lithofacies assemblages in the Longtan Formation varied widely. The shore swamp of the Longtan Formation is most influenced by the terrestrial input and mainly develops CLS and MS. The tidal flat is influenced by the terrestrial input and can also deposit carbonate minerals, developing CLS, CAS and MS. The shallow water melanged accumulation shelf develops CAS and MS, dominated by clay and carbonate minerals. The deep water miscible shelf develops CLS and SS, whose mineral composition is similar to that of the shore swamp, but the quartz minerals are mainly formed by chemical and biological reactions, which are related to the Permian global chert event. The depositional environment of the Longtan Formation controls the shale mineral assemblage of the Longtan Formation and also influences the TOC content.

The Upper Triassic Chang-7 Member of the Ordos Basin contains typical tight sandstone reservoirs. Reservoir quality is affected by diagenesis, which is a critical factor in tight oil exploration. In this study, the Chang-7 Member tight sandstones were studied by a variety of experimental methods, including thin sections, scanning electron microscopy (SEM), and X-ray diffraction (XRD), to determine the reservoir characteristics and diagenesis and discuss their influences on the reservoir quality. The Chang-7 Member sandstones are mainly lithic arkose and feldspathic litharenite with an average porosity and permeability of 7.17% and 0.13 mD, respectively. The pore type is mainly primary intergranular pores, and the secondary pores are feldspar dissolved pores, which are relatively developed, with pore radii of 2–20 µm. Diagenesis of Chang-7 Member tight reservoirs mainly includes compaction, quartz cementation, carbonate cementation, clay mineral cementation, and dissolution. The diagenetic stage develops into Mesodiagenesis A. The average porosity loss from compaction and cementation of sandstone in the Chang-7 Member is 15.93% and 18.67%, respectively. With the increase in burial depth, the porosity and permeability of the reservoir gradually decrease. In mesodiagenesis, the authigenic illite and carbonate cementation compacts the reservoir. The acid fluid carried by the two stages of oil and gas filling during diagenesis dissolved feldspar and carbonate cement, which plays a certain role in transforming the tight reservoir.

Diagenesis and pore evolution of tight sandstone reservoir is one of the most important issues surrounding clastic reservoirs. The tight sandstone of the Shanxi Formation is an important oil and gas producing layer of the Upper Paleozoic in Ordos Basin, and its densification process has an important impact on reservoir quality. This study determined the physical properties and diagenetic evolution of Shanxi Formation sandstones and quantitatively calculated the pore loss in the diagenetic process. Microscopic identification, cathodoluminescence, and a scanning electron microscope were used identify diagenesis, and the diagenesis evolution process was clarified along with inclusion analysis. In addition, reservoir quality was determined based on the identification of pore types and physical porosity. Results show that rock types are mainly sublitharenite and litharenite. The reservoir has numerous secondary pores after experiencing compaction, cementation, and dissolution. We obtained insight into the relationship between homogenous temperature and two hydrocarbon charges. The results indicated that there were two hydrocarbon charges in the Late Triassic–Early Jurassic (70–90 °C) and Middle Jurassic–Early Cretaceous (110–130 °C) before reservoir densification. The quantitative calculation of pore loss shows that the average apparent compaction, cementation, and dissolution rates are 67.36%, 22.24%, and 80.76%, respectively. Compaction directly affected the reservoir tightness, and intense dissolution was beneficial to improve the physical properties of the reservoir.

The deposition of the Lower Cambrian argillaceous rocks on the Kongquehe slope provides a good opportunity to reconstruct the paleoenvironmental conditions of the Tarim Basin. To explore the paleoredox conditions, paleoclimate, and provenance of this deposit, 21 samples were collected from Well A, and the concentrations of major and trace elements were analyzed. The V/(V + Ni), V/Cr, Ni/Co, U/Th, Uau, and V/Sc ratios indicated that the sediments in the water body from the Lower Cambrian were in a reducing environment, and the degree of reduction weakened from the bottom to the top. The Sr/Cu, Mg/Ca, and Fe/Mn ratios in the sediments revealed that the Lower Cambrian was mainly characterized by a warm and humid paleoclimate, and there may be a paleoclimatic transition toward drought conditions as recorded by the sediments of Xidashan Formation. The chemical alteration index, compositional variation index, plagioclase alteration index values, and Th/U and K/Rb ratios of the Lower Cambrian mudstone all reflected that the parent rock in the study area was mainly subject to low- to medium-degree chemical weathering. Longitudinally, the Lower Cambrian gradually increased and then weakened from Xishanbulake Formation to Xidashan Formation. The ratios of trace elements and rare earth elements as well as Th–Sc–Zr/10, Th–Co–Zr/10, and ∑REE–La/Yb diagrams all showed that the mudstones of Xishanbulake and Xidashan Formations of the Lower Cambrian in the study area have a common parent rock type, mainly sedimentary rocks rich in felsic minerals. Additionally, the structural setting discrimination diagrams of SiO₂–K₂O/Na₂O, Th–Sc–Zr/10, Th–Co–Zr/10, and La–Th–Sc showed that the structural setting of the Lower Cambrian mudstone deposition is mainly a continental island arc environment and has the characteristics of an active continental margin.

This study investigated, in detail, the characteristics of the Late Triassic fine-grained sediments in the third member of the Xujiahe Formation (Xu-3 Member), in the Western Sichuan Depression, and the paleoenvironmental evolution during their deposition through petrological interpretation, mineralogical composition characterization, and element geochemical analysis. According to the mineralogical composition, the Xu-3 Member can be divided into two petrological types, namely clayey fine-grained felsic sedimentary rocks and lime fine-grained felsic sedimentary rocks. The main mineral components are siliceous, clay, and carbonate minerals. Through the cluster analysis of major elements, all samples could be divided into two types with different major elemental characteristics. Trace elements exhibited distinct Sr depletion, relative enrichment of large ion lithophile elements, and high field strength elements. Two REE enrichment patterns were observed, which could be attributed to differences in the provenance area and tectonic background. The paleoclimate of the sedimentary area was warm and humid, but it was hotter and drier in the southern and central parts of the depression. The change trend of paleo-productivity was consistent with the paleoclimate. The waters in the sedimentary environment were mainly brackish water to saline water, with fresh water in the southern part of the depression. The paleo-redox conditions of the waters were mainly sub-oxidation to sub-reduction, but the southern part of the depression was more oxidative. The provenance area experienced a moderate degree of chemical weathering under a warm and humid paleoclimate, same as the depositional area. However, the depositional environments differed between the northern and south-central parts of the depression.