Dima Kilani

Dr. Dima Kilani

Khalifa University of Science and Technology, Abu Dhabi, Abū Z̧aby, United Arab Emirates
orcid

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
19 September 2016 in IEEE Transactions on Circuits and Systems I: Regular Papers
Verified
Journal Article
Closed access
DKDima Kilani
Dima Kilani
Mohammad AlhawariMohammad Alhawari
Mohammad Alhawari
BMBaker Mohammad
Baker Mohammad
HSHani Saleh
Hani Saleh
MIMohammed Ismail
Mohammed Ismail
This paper introduces an efficient reconfigurable, multiple voltage gain switched-capacitor dc-dc buck converter as part of a power management unit for wearable electronics. The proposed switched-capacitor converter has an input voltage of 0.6 V to 1.2 V generated from an energy harvesting source. The switched-capacitor converter utilizes pulse frequency modulation to generate multiple regulated output voltage levels, namely 1 V, 0.8 V, and 0.6 V based on two reconfigurable bits over a wide range of load currents from 10 μA to 800 μA. The switched-capacitor converter is designed and fabricated in 65-nm low-power CMOS technology and occupies an area of 0.493 mm 2 . The design utilizes a stack of MIM and MOS capacitances to optimize the circuit area and efficiency. The measured peak efficiency is 80% at a load current of 800 μA and regulated load voltage of 1 V.

22 August 2018 in IEEE Transactions on Circuits and Systems I: Regular Papers
Verified
Journal Article
Closed access
DKDima Kilani
Dima Kilani
BMBaker Mohammad
Baker Mohammad
Mohammad AlhawariMohammad Alhawari
Mohammad Alhawari
HSHani Saleh
Hani Saleh
MIMohammed Ismail
Mohammed Ismail
This paper presents an area- and power-efficient dual-output switched capacitor (DOSC) dc-dc buck converter for wearable biomedical devices. The DOSC converter has an input voltage range between 1.05 and 1.4 V and generates two simultaneous regulated output voltages of 1 and 0.55 V. The DOSC consists of two main blocks: a switched capacitor regulator and an adaptive time multiplexing (ATM) controller. The switched capacitor regulator generates a single regulated voltage using pulse frequency modulation based on a predetermined reference voltage. In addition, the ATM controller generates two simultaneous output voltages and eliminates the reverse current using pulse width modulation during the switching between the output voltages. Addressing the reverse current problem is important to reduce the output voltage droop and improve the performance. The proposed converter supports load currents of 10-350 μA and 1-10 μA at load voltages of 1 and 0.55 V, respectively. The DOSC circuit is fabricated in 65-nm CMOS, and it occupies an active area of 0.27 mm 2 . Measured results show that a peak efficiency of 78% is achieved at a load power of 300 μW.

3 May 2022 in Energies
Verified
Journal Article
Open access
PDF file
DKDima Kilani
Dima Kilani
BMBaker Mohammad
Baker Mohammad
Mohammad AlhawariMohammad Alhawari
Mohammad Alhawari
This paper presents a switched inductor (SI) DC–DC boost regulator designed for thermoelectric generator (TEG) applications. To boost and regulate the output voltage, two feedback loops are implemented which control the duty cycle of the SI clock. The first loop consists of a pulse skip modulation (PSM) controller that compares the load voltage and reference voltage. Based on the comparison output, the PSM will either pass or bypass the modulated pulse width signal generated from the second loop. The second loop replaces the conventional circuit design of the pulse width modulation (PWM) with a voltage-to-time converter (VTC). The VTC converts the difference between load and supply voltage to time delay resulting in a modulated pulse width. This work is the first to report on utilizing VTC circuit in the SI boost regulator. The proposed SI boost regulator is designed using 65 nm CMOS technology which converts the TEG voltage of 50 mV to support dynamic voltage scaling in the range of 0.6 V to 0.8 V. The PSM and PWM controller loops can tune the duty cycle of the clock in the range of 0 to 70%. It achieves a peak efficiency of 60.9% at 30 μW load power. Comparing the proposed single-stage SI boost regulator with the conventional two cascaded stages of switched-inductor boost converter followed by switched capacitor regulator, the area is reduced by 9.6× and power efficiency is increased by 1.35×.

1 August 2019 in Microelectronics Journal
Verified
Journal Article
Closed access
DKDima Kilani
Dima Kilani
MAMohammad Alhawari
Mohammad Alhawari
BMBaker Mohammad
Baker Mohammad
HSHani Saleh
Hani Saleh
MSMihai Adrian Sanduleanu
Mihai Adrian Sanduleanu
MIMohammed Ismail
Mohammed Ismail

20 December 2021 in IEEE Access
Verified
Journal Article
Open access
DKDima Kilani
Dima Kilani
BMBaker Mohammad
Baker Mohammad
YHYasmin Halawani
Yasmin Halawani
MTMohammed F. Tolba
Mohammed F. Tolba
HSHani Saleh
Hani Saleh
This paper presents a novel cross-coupling capacitor processing unit (C3PU) that supports analog-mixed signal in-memory computing to perform multiply-and-accumulate (MAC) operations. The C3PU consists of a capacitive unit, a CMOS transistor, and a voltage-to-time converter (VTC). The capacitive unit serves as a computational element that holds the multiplier operand and performs multiplication once the multiplicand is applied at the terminal. The multiplicand is the input voltage that is converted to a pulse width signal using a low power VTC. The transistor transfers this multiplication where a voltage level is generated. A demonstrator of $5 \times 4$ C3PU array that is capable of implementing 4 MAC units is presented. The design has been verified using Monte Carlo simulation in 65 nm technology. The $5 \times 4$ C3PU consumed energy of 66.4 fJ/MAC at 0.3 V voltage supply with an error of 5.7%. The proposed unit achieves lower energy and occupies a smaller area by $3.4\times $ and $3.6\times $ , respectively, with similar error value when compared to a digital-based $8 \times 4$ -bit fixed point MAC unit. The C3PU has been utilized through an iris flower classification utilizing an artificial neural network which achieved a 90% classification accuracy compared to ideal accuracy of 96.67% using MATLAB.

1 May 2018
Verified
Conference Paper
Closed access
DKDima Kilani
Dima Kilani
Mohammad AlhawariMohammad Alhawari
Mohammad Alhawari
BMBaker Mohammad
Baker Mohammad
HSHani Saleh
Hani Saleh
MIMohammed Ismail
Mohammed Ismail
This paper presents an area and power efficient multioutput switched capacitor (MOSC) DC-DC buck converter targeting ultra-low power and IoT devices. The MOSC converter has a variable input voltage range between 1.05V to 1.4V and generates regulated simultaneous multiple output voltage levels of 1V and 0.55V. Adaptive digital time multiplexing controller is employed to enable multiple power domains. In addition, a pulse frequency modulation is utilized to regulate the output voltages over a wide range of load current. The proposed converter supports a load current of 10μA to 350μA and to 10μA at a load voltage of 1V and 0.55V, respectively. Adaptive time multiplexing and pulse width modulation are implemented through a finite state machine to eliminate the reverse current issue. This problem arises during the switching from a low load voltage of 0.55V to a high load voltage of 1V. The MOSC circuit is fabricated in 65nm CMOS technology and it occupies an active area of 0.27mm 2 . Moreover, both MIM and MOS capacitors are utilized to further reduce the area of MOSC converter. Measured results shows that the peak efficiency of 78% is achieved at a load power of 300μW.