Ti and solution treated Mg alloys such as AZ31B (ST), AZ61 (ST), AZ80 (ST) and AZ91 (ST) were successfully bonded at 475 °C by spark plasma sintering, which is a promising new method in welding field. The formation of Ti3Al intermetallic compound was found to be an important factor in controlling the bonding strength and galvanic corrosion resistance of dissimilar materials. The maximum bonding strength and bonding efficiency at 193 MPa and 96% were obtained from Ti/AZ91 (ST), in which a thick and uniform nano-level Ti3Al layer was observed. This sample also shows the highest galvanic corrosion resistance with a measured galvanic width and depth of 281 and 19 µm, respectively. The corrosion resistance of the matrix on Mg alloy side was controlled by its Al content. AZ91 (ST) exhibited the highest corrosion resistance considered from its corrode surface after corrosion test in Kroll’s etchant. The effect of Al content in Mg alloy on bonding strength and corrosion behavior of Ti/Mg alloy (ST) dissimilar materials is discussed in this work.
Ti-6%Al-4%V (Ti64) alloy powder coated with vapor grown carbon fibers was consolidated to fabricate titanium matrix composites by spark plasma sintering, followed by hot extrusion process. Four compositions of the additive vapor grown carbon fibers were 0.1, 0.2, 0.3 and 0.4 wt. %. The microstructure was changed from the full lamellar of monolithic Ti64 alloy to the bimodal structure by addition of vapor grown carbon fibers to Ti64 alloy. The changing of microstructure was attributed by an α-stabilize effect of carbon (vapor grown carbon fiber). Almost all the vapor grown carbon fibers reacted with Ti and result in formation of Ti6C3.75 carbide phases detected by x-ray diffractometer and energy dispersive spectrometer. Hardness was improved by effect of solid solution strengthening of carbon in the Ti matrix and reached the maximum value of 495.8 Hv. 0.2%YS and UTS were significantly increased by addition of 0.1 wt. % vapor grown carbon fiber. However, they were not much improved when more vapor grown carbon fiber content was applied. Ductility of the sample was affected by a change in microstructure when 0.1 wt. % of vapor grown carbon fibers was added because the bimodal structure shows higher ductility compared to the full lamellar structure. The carbide precipitation in TMCs was not much contributed in improving of strength and decreased a ductility of material.