We develop a method for the prediction of flow fields based on local particle image velocimetry (PIV) measurement. High spatial resolution can be achieved by focusing PIV on local flow regions; however, it is difficult for standard dynamic mode decomposition (DMD) to predict the temporally resolved flow field based on limited information in sub-domain. In this regard, the local flow field is embedded using time-delay to augment the spatial dynamics. As such, both high temporally and spatially resolved flow fields can be faithfully obtained from local PIV measurement using the DMD method. Using fabricated patterns, we demonstrate that DMD with time-delay embedding can faithfully predict dynamic patterns over a long time interval, whereas the standard DMD can only match the ground truth briefly following initiation. Using PIV measurement of a wake flow and a highly dynamic sweeping jet flow, the DMD with time-delay embedding can increase the temporal resolution up to 100 times with a prediction error rate of approximately 8%. Compared with wake flow, where unsteady flow patterns are relatively weak, a sweeping jet flow demonstrates that the prediction performance is improved even more significantly using time-delay embedding compared with standard DMD when the flow is highly dynamic. For sweeping jet flow, the prediction error rate can drop from 56% using standard DMD to 8.3% by embedding a time-delay smaller than five steps, for a small cost of calculation time. In addition, the DMD with time-delay embedding shows robustness to small noise. For data with high noise whose signal-to-noise ratio is 15, the method has an error rate of less than 5%.
1 July 1996 in Journal of Magnetism and Magnetic Materials
In positron emission tomography (PET) image reconstruction, the accurate system response matrix (SRM) is one of the key factors for reconstructing high-quality images. To reduce the influence of various factors on the spatial resolution, this paper focuses on calculating the SRM based on Monte Carlo (MC) simulation and proposes a method based on system geometric symmetry to reduce the simulation time. We split the symmetry into two types: intra-ring symmetry and inter-axis symmetry, a total of 208 times the symmetry is used. According to the standards formulated by the American National Electrical Manufacturers Association (NEMA), the spatial resolution and image quality are assessed by simulation experiments. Results of point source measurement show that the full width at half maximum (FWHM) range in each direction is about 1.1–1.3 mm, the average value is about 1.2 mm. In Derenzo phantom imaging, the MC method can clearly distinguish the 1.2 mm rods. To assess image quality, we calculated the uniformity of the image, contrast recovery coefficients (CRC), and coefficient of variation (COV). At the same time, we compared with the ray tracing (RT) and pixel drive (PD) models. In general, the MC method achieves better results in simulation experiments than RT and PD methods.
Riemannian gradient descent (RGD) is a simple, popular and efficient algorithm for leading eigenvector computation [AMS08]. However, the existing analysis of RGD for eigenproblem is still not tight, which is O(log(n/epsilon)/Delta^2) due to [Xu et al., 2018]. In this paper, we show that RGD in fact converges at rate O(log(n/epsilon)/Delta), and give instances to shows the tightness of our result. This improves the best prior analysis by a quadratic factor. Besides, we also give tight convergence analysis of a deterministic variant of Oja's rule due to [Oja, 1982]. We show that it also enjoys fast convergence rate of O(log(n/epsilon)/Delta). Previous papers only gave asymptotic characterizations [Oja, 1982; Oja, 1989; Yi et al., 2005]. Our tools for proving convergence results include an innovative reduction and chaining technique, and a noisy fixed point iteration argument. Besides, we also give empirical justifications of our convergence rates over synthetic and real data.
Dynamic stall is a critical limiting factor for airfoil aerodynamics and a challenging problem for active flow control. In this experimental study, dynamic stall was measured by high-frequency surface pressure tapes and pressure-sensitive paint (PSP). The influence of the oscillation frequency was examined. Dynamic mode decomposition (DMD) with time-delay embedding was proposed to predict the pressure field on the oscillating airfoil based on scattered pressure measurements. DMD with time-delay embedding was able to reconstruct and predict the dynamic stall based on scattered measurements with much higher accuracy than standard DMD. The reconstruction accuracy of this method increased with the number of delay steps, but this also prolonged the computation time. In summary, using the Koopman operator obtained by DMD with time-delay embedding, the future dynamic pressure on an oscillating airfoil can be accurately predicted. This method provides powerful support for active flow control of dynamic stall.