Anant Agarwal

Dr. Anant Agarwal

orcid

Research Focus & Metrics

Academic Career Length

36Years (1991-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 November 2021 in IEEE Access
Verified
Journal Article
Open access
SYSusanna Yu
Susanna Yu
MWMarvin H. White
Marvin H. White
AAAnant Agarwal
Anant Agarwal
We measure interface trap density near the conduction band edge and fixed oxide charge in commercial, packaged, 4H-SiC 1.2 kV planar Power MOSFETs. These traps determine the device threshold voltage, performance, and reliability. The subthreshold slope is used to extract interface trap density at the SiO 2 -SiC interface near the conduction band edge from three vendors, which varies from $5.8\times 10 ^{12}$ to $9.3\times 10 ^{12}$ cm $^{-2}\cdot $ eV −1 . Good agreement is obtained with threshold voltage measurements from 25°C to 150°C as devices with the highest interface trap densities exhibit the largest threshold voltage reduction over temperature. Fixed positive oxide charge, $N_{ot}$ , balanced with interface traps and substrate doping, varies from $3.3\times 10 ^{12}$ cm −2 to $3.7\times 10 ^{12}$ cm −2 . At high temperatures, electrons captured in interface traps emit to the conduction band and lower the threshold voltage together with fixed oxide charges, which are as high as interface trap densities. Thus, device design should be considered for a suitable threshold voltage to ensure the device does not operate in a Normally-ON condition and to protect against gate voltage surges. Therefore, more focus on characterization and reduction of the interface trap density and fixed oxide charge is needed to enable further improvement in effective electron mobility of SiC MOSFETs.

20 January 2022 in IEEE Journal of Emerging and Selected Topics in Power Electronics
Verified
Journal Article
Open access
DXDiang Xing
Diang Xing
BHBoxue Hu
Boxue Hu
MKMinseok Kang
Minseok Kang
YZYue Zhang
Yue Zhang
SNSuvendu Nayak
Suvendu Nayak
AAAnant Agarwal
Anant Agarwal
This article presents the short-circuit (SC) capability evaluation of TO-247-3 packaged silicon carbide (SiC) metal–oxide–semiconductor field-effect transistors (MOSFETs) based on tests under different drain biases and gate biases. Compared with the 900-V Si super-junction MOSFET and the 1200-V Si trench-gate field-stop insulated gate bipolar transistor (IGBT), SiC devices show higher saturation current per die area, which requires more rigorous chip design consideration to reach an acceptable SC withstand time (SCWT). The test results also reveal that the SC withstand capability of SiC MOSFETs can still be enhanced. Thus, in both chip design and detection circuits, several novel approaches investigated in recent years, which could potentially improve SC ruggedness of SiC device-based systems, are discussed at the end of this article.

2 March 2009 in Materials Science Forum
Verified
Journal Article
Closed access
PDF file
BHBrett A. Hull
Brett A. Hull
CJCharlotte Jonas
Charlotte Jonas
SRSei Hyung Ryu
Sei Hyung Ryu
MDMrinal K. Das
Mrinal K. Das
MOMichael J. O'Loughlin
Michael J. O'Loughlin
CSCharles Scozzie
Charles Scozzie
Large area (8 mm x 7 mm) 1200 V 4H-SiC DMOSFETs with a specific on-resistance as low as 9 m•cm2 (at VGS = 20 V) able to conduct 60 A at a power dissipation of 200 W/cm2 are presented. On-resistance is fairly stable with temperature, increasing from 11.5 m•cm2 (at VGS = 15 V) at 25°C to 14 m•cm2 at 150°C. The DMOSFETs exhibit avalanche breakdown at 1600 V with the gate shorted to the source, although sub-breakdown leakage currents up to 50 A are observed at 1200 V and 200°C due to the threshold voltage lowering with temperature. When switched with a clamped inductive load circuit from 65 A conducting to 750 V blocking, the turn-on and turn-off energies at 150°C were less than 4.5 mJ.

3 April 2012 in IEEE Transactions on Power Electronics
Verified
Journal Article
Open access
TGTanya Gachovska
Tanya Gachovska
JHJerry L. Hudgins
Jerry L. Hudgins
ABAngus Bryant
Angus Bryant
ESEnrico Santi
Enrico Santi
HMH. Alan Mantooth
H. Alan Mantooth
AAAnant Agarwal
Anant Agarwal
This paper presents a physics-based model of a silicon carbide bipolar junction transistor and verification of its validity through experimental testing. The Fourier series solution is used to solve the ambipolar diffusion equation in the transistor collector region. The model is realized using MATLAB and Simulink. The experimental results of static operation and also the simulated and experimental results of switching waveforms are given.

9 December 2021 in Energies
Verified
Journal Article
Open access
PDF file
HMHema Lata Rao Maddi
Hema Lata Rao Maddi
SYSusanna Yu
Susanna Yu
SZShengnan Zhu
Shengnan Zhu
TLTianshi Liu
Tianshi Liu
LSLimeng Shi
Limeng Shi
AAAnant Agarwal
Anant Agarwal
This article provides a detailed study of performance and reliability issues and trade-offs in silicon carbide (SiC) power MOSFETs. The reliability issues such as threshold voltage variation across devices from the same vendor, instability of threshold voltage under positive and negative gate bias, long-term reliability of gate oxide, screening of devices with extrinsic defects by means of gate voltage, body diode degradation, and short circuit withstand time are investigated through testing of commercial devices from different vendors and two-dimensional simulations. Price roadmap and foundry models of SiC MOSFETs are discussed. Future development of mixed-mode CMOS circuits with high voltage lateral MOSFETs along with 4−6× higher power handling capability compared to silicon circuits has been described.

30 August 2022 in Materials
Verified
Journal Article
Open access
PDF file
SZShengnan Zhu
Shengnan Zhu
TLTianshi Liu
Tianshi Liu
Junchong FanJunchong Fan
Junchong Fan
HMHema Lata Rao Maddi
Hema Lata Rao Maddi
MWMarvin H. White
Marvin H. White
AAAnant Agarwal
Anant Agarwal
650 V SiC planar MOSFETs with various JFET widths, JFET doping concentrations, and gate oxide thicknesses were fabricated by a commercial SiC foundry on two six-inch SiC epitaxial wafers. An orthogonal P+ layout was used for the 650 V SiC MOSFETs to reduce the ON-resistance. The devices were packaged into open-cavity TO-247 packages for evaluation. Trade-off analysis of the static and dynamic performance of the 650 V SiC power MOSFETs was conducted. The measurement results show that a short JFET region with an enhanced JFET doping concentration reduces specific ON-resistance (Ron,sp) and lowers the gate-drain capacitance (Cgd). It was experimentally shown that a thinner gate oxide further reduces Ron,sp, although with a penalty in terms of increased Cgd. A design with 0.5 μm half JFET width, enhanced JFET doping concentration of 5.5×1016 cm−3, and thin gate oxide produces an excellent high-frequency figure of merit (HF-FOM) among recently published studies on 650 V SiC devices.