This paper investigates the potential for increasing the uplift resistance of buried pipelines through the addition of radial fins on the pipe circumference. Experiments conducted in loose sand showed that fins extending by 20% of the pipe diameter increase the vertical peak uplift resistance by up to 25%, depending on embedment depth and fin configuration. A limit equilibrium solution – based on known values of peak friction and dilation angles – predicts the uplift resistance within 13% of the measurements. The trends of peak uplift resistance with embedment and fin configuration were also replicated in numerical analyses conducted using a non-associated Mohr–Coulomb soil model. The numerically predicted peak uplift resistances were within 10 and 21% of the experimental values for rough and smooth interfaces, respectively. Soil failure mechanisms from the numerical analyses were broadly consistent with that assumed in the limit equilibrium solution. However, the experimentally observed mechanisms differed subtly, with a limited extent of lifted soil above the pipe and circulatory flow occurring from above to beneath the pipe. This mechanism was approached in the numerical analyses for a smooth interface by specifying a small negative dilation angle, which had minimal effect on the predicted peak uplift resistance.
1 November 2019 in Journal of Geotechnical and Geoenvironmental Engineering
This study establishes the drained bearing capacity of pipelines embedded up to one diameter into the seabed subject to combined vertical-horizontal loading. Nonassociated flow finite-element analyses are used to calculate the peak breakout resistance in a frictional Mohr–Coulomb seabed. Critical state friction angles and dilation angles ranging from 25° to 45° and from 0° to 25°, respectively, are considered. Analytical expressions are fitted to the results as a function of embedment depth and soil properties, and compare well with experimental measurements from previous studies. The horizontal bearing capacity at small vertical loads is also predicted well via upper-bound limit analysis using the Davis reduced friction angle that accounts for the peak friction and dilation angles. The analytical relationships presented in this study provide simple predictive tools for estimating the bearing capacity of pipelines on free-drained sandy seabeds. These fill a void in knowledge for pipeline stability and buckling design by providing general relationships between drained strength properties and pipeline bearing capacity. The insight gained through the good comparison with limit analysis techniques also gives confidence in the use of simple numerical techniques to predict the bearing capacity of pipelines for more wide-ranging (i.e., nonflat) seabed topography.
In order to design unburied pipelines, pipeline engineers require information about lateral and axial seabed resistances (normally known as ‘friction factors’) prior to and during operation. Geotechnical engineers must provide this information based on knowledge of pipeline properties, seabed conditions and metocean conditions. Accurate prediction of the seabed resistances requires accurate prediction of pipeline embedments. This paper discusses how pipeline embedments and geometries can change from the as-laid state as the result of sediment mobility around pipelines and demonstrates how these embedment changes will change the pipe-soil friction factors using a series of numerical analyses. Sediment mobility tends to cause a general trend of increasing pipe embedment, which is beneficial for hydrodynamic stability but can be onerous for thermal buckling. Recommendations are provided to accommodate these effects in design, without unnecessary levels of over-conservatism.