The accidental contamination of food and food packaging surfaces with SARS-CoV-2 is of increasing concern among scientists and consumers, particularly in relation to fresh foods that are consumed without further cooking. The use of chemical sanitizers is often not suitable for these kinds of commodities; therefore, a non-thermal sanitation technology could help to increase safety in relation to the food supply chain. Cold plasma has proven to be a promising strategy for virus inactivation. This research is aimed at evaluating the ability of a cold plasma sanitation system to inactivate SARS-CoV-2 RNA on packaged foods. Two different plastic materials were investigated and subjected to 5- and 10-min exposure to plasma after experimental inoculum of the RNA. In addition to viral degradation, possible changes in the performance of the materials were evaluated. Shelf-life of the foods, after exposure of the packages to plasma, was also investigated. Results showed that 10 min of exposure was sufficient to almost completely eliminate the viral RNA from package surfaces. The treatment did not produce any significant variation in packaging material performance or the shelf-life of the tested packaged products, indicating the potentiality of this treatment for the decontamination of packaged products.
Cold atmospheric plasma (CAP) is a non-thermal technology that could be applied for food decontamination from both biological (microorganisms) and chemical (pesticides, food allergens, mycotoxins) contaminants, thanks to the production of reactive species (RS). However, RS could also promote the onset and the progress of food lipid oxidation, which may limit the quality and acceptability of the final products. The aim of this work was to assess the oxidation degree of pistachio kernels after treatment in a surface dielectric barrier discharge (SDBD). Two different operative conditions for CAP generation were investigated, resulting in the production of high (800 ppm) or low (300 ppm) concentrations of ozone. Limited amounts of hydroperoxides (3.00–4.22 mEq O2/kg), thiobarbituric acid reactive substances (TBARS, 0.072–0.600 mg TEP/g oil), and phytosterol oxidation products (POPs, 14.43–17.20 μg/g) were observed in lipids of both control and plasma processed pistachios. Plasma treatments did not significantly affect the total fatty acid composition and the amounts of identified unsaponifiable matter constituents (4-desmethylsterols, 4,4-dimethylsterols, 4-methylsterols), except for an unexpected significant increase of γ-tocopherol content in extracted oils. These findings contribute to gaining further knowledge for the scale-up of CAP technology to industrial processing.
Bioaerosols (aerosolized particles with biological origin) are strongly suspected to play a significant role in the transmission of Severe Acute Respiratory Syndrome Coronavirus 2 (SARS‐CoV‐2), especially in closed indoor environments. Thus, control technologies capable of effectively inactivating bioaerosols are urgently needed. In this regard, cold atmospheric pressure plasma (CAP) can represent a suitable option, thanks to its ability to produce reactive species, which can exert antimicrobial action. In this study, results; on the total inactivation of SARS‐CoV‐2 contained in bioaerosols treated using CAP generated in air are reported, demonstrating the possible use of CAP systems for the control of SARS‐CoV‐2 diffusion through bioaerosols.
20 October 2023 in Plasma Chemistry and Plasma Processing
The food industry, as a consequence of globalization and in particular with the outbreak of the COVID-19 pandemic, is calling for additional measures to reduce the risks of contamination throughout the steps of the food chain. Several methods are used to avoid this problem, such as hot water or chemical procedures. However, they have some disadvantages like high economic costs or the fact that they are not eco-friendly technologies. For those reasons, novel strategies are being sought in order to substitute or work in synergy with conventional decontamination systems. Cold atmospheric pressure plasma (CAP) can be produced by many various sources for a wide range of different applications, including decontamination. In this study, a Large-Area Surface Dielectric Barrier Discharge plasma source has been used with the aim of inactivating Staphylococcus epidermidis inoculated on polypropylene food packaging samples inside a treatment chamber. Moreover, electrical and chemical analysis of the plasma source has been carried out, as well as temperature measurements. A homogenous distribution of the reactive species inside the treatment chamber was suggested, achieving almost 2 log of bacteria reduction for every plasma treatment. Finally, it was suggested that the inactivation rates reached were not caused by the thermal effect. Thus, it is strongly believed that CAP could be an eco-friendly, cheap, and sustainable technology for food packaging and food tools decontamination.
Cold plasma (CP) is a non-thermal technology, successfully used to decontaminate and extend the shelf-life of various foods. However, CP can cause quality deterioration in sensitive matrices, such as fish products. This research aimed to evaluate the effect of CP treatment obtained using different gas mixtures (80% Ar/20% O2, or 80% N2/20% O2) with a surface dielectric barrier discharge (SDBD) on the decontamination of spoilage microflora, the main quality indices and the sensory acceptability of seabream (Spaurus aurata L.) fillets during refrigerated storage. At the beginning and at the end of the shelf life, lipid and protein oxidation indices and the fatty acid profile were evaluated. Results showed that, despite a low initial microbial decontamination (0.2–0.3 Log CFU/g), an inhibition of the growth of the main spoilage bacteria was observed resulting in an increase of the microbiological shelf life of around 40% for both treatments. Although a slight increase in lipid and protein oxidation was observed (up to around 5 mg MDA/kg and 4 nmol/mg of protein for TBARs and carbonyl content respectively), the sensory acceptability was higher for plasma treated samples, while the fatty acid profile was not affected and only a slight variation in the surface colour was observed (L* value increase by 3 points), confirming that CP could represent an interesting strategy to extend the shelf life of seafood products with minimal impact on quality and nutritional value.
The current level of packaging consumption imposes a need to fabricate single-use food packaging with renewable and compostable materials, such as bio-polyesters (e.g., polylactic acid, PLA and polybutylene succinate, PBS) or cellulose, but their use is still problematic. Fabrication of bio-compostable composites can specifically address impeding challenges, and adhesive lamination, achieved with compostable glue, is becoming more and more popular with respect to the less versatile hot lamination. In this context, plasma activation, a chemical-free oxidation technique of a material’s surface, is used to increase the affinity of three different biomaterials (cellulose, PLA and PBS) toward a compostable polyurethane adhesive to decrease its amount by gluing bio-polyesters to cellulose. Optical Microscopy reveals activation conditions that do not affect the integrity of the materials, while Water Contact Analyses confirm the activation of the surfaces, with contact angles decreased to roughly 50 deg in all cases. Unexpectedly, ζ-potential analyses and subtractive infrared spectroscopy highlight how the activation performed superficially etches cellulose, while for both PLA and PBS, a general decrease in surface potential and an increase in superficial hydroxyl group populations confirm the achievement of the desired oxidation. Thus, we rationalize continuous activation conditions to treat PLA and PBS and to glue them to neat cellulose. While no beneficial effect is observed with activated PLA, bi-laminate composites fabricated with activated PBS fulfill the benchmark for adhesion strength using less than before, while oxygen permeation analyses exclude plasma-induced etching even at a nanoscale.