Wanchun Ren

Dr. Wanchun Ren


Research Focus & Metrics

Academic Career Length

15Years (2012-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
28 January 2022 in Micromachines
Verified
Journal Article
Open access
PDF file
WRWanchun Ren
Wanchun Ren
JLJintong Li
Jintong Li
GLGuo Li
Guo Li
JCJiarong Chen
Jiarong Chen
SCSi Chen
Si Chen
YGYang Gao
Yang Gao
Magnetic sensors actuated by bulk acoustic wave (BAW) have attracted extensive attention due to the fact of their high sensitivity, GHz-level high frequency, and small size. Different from previous studies, suppression of energy loss and improvement in energy conversion efficiency of the BAW magnetoelectric (ME) sensor were systematically considered during the device design in this work. Finite element analysis models of material (magnetic composite), structure (ME heterostructure), and device (BAW ME magnetic sensor) were established and analyzed in COMSOL software. Additionally, the magnetic composite was prepared by radio frequency magnetron sputtering, and its soft magnetism was characterized by magnetic hysteresis loop and surface roughness. The research results demonstrate that after inserting four layers of 5 nm Al2O3 films, a performance of 86.7% eddy current loss suppression rate, a less than 1.1% magnetostriction degradation rate, and better soft magnetism were achieved in 600 nm FeGaB. Furthermore, compared with other structures, the two-layer piezomagnetic/piezoelectric heterostructure had a better ME coupling performance. Eventually, the design of the BAW ME magnetic sensor was optimized by the resonance-enhanced ME coupling to match the resonance frequency between the magnetic composite and the BAW resonator. When a 54,500 A/m direct current bias magnetic field was applied, the sensor worked at the first-order resonance frequency and showed good performance. Its linearity was better than 1.30%, the sensitivity was as high as 2.33 μmV/A, and the measurement range covered 0–5000 A/m.

8 February 2022 in Micromachines
Verified
Journal Article
Open access
PDF file
SCSi Chen
Si Chen
JLJunru Li
Junru Li
YGYang Gao
Yang Gao
JLJianbo Li
Jianbo Li
HDHongmei Dong
Hongmei Dong
WRWanchun Ren
Wanchun Ren
Implantable medical devices have been facing the severe challenge of wireless communication for a long time. Acoustically actuated magnetoelectric (ME) transducer antennas have attracted lots of attention due to their miniaturization, high radiation efficiency and easy integration. Here, we fully demonstrate the possibility of using only one bulk acoustic wave (BAW) actuated ME transducer antenna (BAW ME antenna) for communication by describing the correspondence between the BAW ME antenna and components of the traditional transmitter in detail. Specifically, we first demonstrate that the signal could be modulated by applying a direct current (DC) magnetic bias and exciting different resonance modes of the BAW ME antenna with frequencies ranging from medium frequency (MF) (1.5 MHz) to medium frequency (UHF) (2 GHz). Then, two methods of adjusting the radiation power of the BAW ME antenna are proposed to realize signal amplification, including increasing the input voltage and using higher order resonance. Finally, a method based on electromagnetic (EM) perturbation is presented to simulate the transmission process of the BAW ME antenna via the finite element analysis (FEA) model. The simulation results match the radiation pattern of magnetic dipoles perfectly, which verifies both the model and our purpose.

26 July 2021 in IEEE Transactions on Magnetics
Verified
Journal Article
Closed access
JLJunru Li
Junru Li
CPChunrui Peng
Chunrui Peng
SCSi Chen
Si Chen
YGYang Gao
Yang Gao
WRWanchun Ren
Wanchun Ren
XHXuefeng He
Xuefeng He
The conductive magnetic film will produce eddy current loss when it works in a high-frequency band, which will reduce the performance of bulk acoustic wave magnetoelectric (BAW ME) devices. If the eddy current loss is not taken into account in the devices modeling, the models will be seriously distorted. Therefore, combining the Maxwell's equations with constitutive relations of ME material, we define the eddy current loss angle as a figure of merit to evaluate the eddy current loss. Then the models of eddy current loss rate of the potential energy and average radiated power are constructed, respectively. The finite element analysis is used to further validate the analytic model. In addition, the effect of isolation layers on eddy current suppression is studied by using the analytical model. The results show that the analytical solutions match with the numerical simulation results perfectly.

15 March 2024 in Digital Signal Processing
Verified
Journal Article
Closed access
YHYi Huang
Yi Huang
GFGui Fu
Gui Fu
WRWanchun Ren
Wanchun Ren
XTXiaoguang Tu
Xiaoguang Tu
ZFZiliang Feng
Ziliang Feng
XZXiaoqiang Zhang
Xiaoqiang Zhang

7 April 2023 in Journal of Magnetism and Magnetic Materials
Verified
Journal Article
Closed access
WRWanchun Ren
Wanchun Ren
JLJintong Li
Jintong Li
SCSi Chen
Si Chen
GWGuifang Wang
Guifang Wang
PZPengcheng Zhu
Pengcheng Zhu
JCJinchuan Chen
Jinchuan Chen

13 September 2025 in Thermochimica Acta
Verified
Journal Article
Closed access
GWGuifang Wang
Guifang Wang
DCDan Chen
Dan Chen
WRWanchun Ren
Wanchun Ren
CLChun Li
Chun Li
BLBaojian Liu
Baojian Liu
JPJunde Pu
Junde Pu