A low-profile broadband metasurface antenna (MSA) with dual-linear polarization is proposed. The proposed MSA mainly consists of a 4 4 grid-slotted patch array, two pairs of orthogonally printed feeding dipole strip, two vertically grounded and orthogonally placed microstrip shaped feeding structures, and an intact ground plane. It is demonstrated that the strip-excited MSA excites a leaky wave mode, a surface wave mode and a dipole mode to provide a wide operational bandwidth. The prototype, with an overall size of 0.65 0 0.65 0 0.07 0 (0 is the wavelength in free space at the center operating frequency) was fabricated and measured. Three modes with broadside radiation patterns for each port are simultaneously excited to create a wide impedance bandwidth 36% with the average gain value 9.3 dBi. Moreover, the port-to-port isolation and the cross-polarization discrimination (XPD) are, respectively, higher than 25 dB and 26dB.
2 June 2020 in IEEE Transactions on Antennas and Propagation
Because of the large wavelength in VHF band, conventional design concepts for flush-mounted VHF band antenna arrays over aircraft platforms meet many challenges. This paper presents an approach for the design of VHF aircraft-integrated antenna arrays with switchable beams by using the characteristic modes (CMs) of the aircraft platform. The CMs of the aircraft platform provide the modal significances, modal currents, and modal radiation fields of each mode. An in-depth investigation over the useful CMs information is performed to prove the feasibility of design VHF band antenna array using the CMs of the platform. Switchable radiation patterns with horizontal polarization are then synthesized from these CMs. The switchable beams and polarization constraint make it more challenging than CM based fixed power pattern synthesis. The polarized switchable beam synthesis is carried out with a multi-objective evolutionary algorithm. A trade-off among the synthesized current distributions for different beam steering angles is made to determine the optimal current excitation locations for antenna array development. Meanwhile, a novel bandwidth enhanced triple-couple-line coupling element is proposed to allow aircraft platform flush mounted designs. A scaled model of the proposed aircraft-integrated antenna array system was fabricated to experimentally verify the effectiveness of the proposed approach.
Magnetic sensors actuated by bulk acoustic wave (BAW) have attracted extensive attention due to the fact of their high sensitivity, GHz-level high frequency, and small size. Different from previous studies, suppression of energy loss and improvement in energy conversion efficiency of the BAW magnetoelectric (ME) sensor were systematically considered during the device design in this work. Finite element analysis models of material (magnetic composite), structure (ME heterostructure), and device (BAW ME magnetic sensor) were established and analyzed in COMSOL software. Additionally, the magnetic composite was prepared by radio frequency magnetron sputtering, and its soft magnetism was characterized by magnetic hysteresis loop and surface roughness. The research results demonstrate that after inserting four layers of 5 nm Al2O3 films, a performance of 86.7% eddy current loss suppression rate, a less than 1.1% magnetostriction degradation rate, and better soft magnetism were achieved in 600 nm FeGaB. Furthermore, compared with other structures, the two-layer piezomagnetic/piezoelectric heterostructure had a better ME coupling performance. Eventually, the design of the BAW ME magnetic sensor was optimized by the resonance-enhanced ME coupling to match the resonance frequency between the magnetic composite and the BAW resonator. When a 54,500 A/m direct current bias magnetic field was applied, the sensor worked at the first-order resonance frequency and showed good performance. Its linearity was better than 1.30%, the sensitivity was as high as 2.33 μmV/A, and the measurement range covered 0–5000 A/m.
19 October 2018 in IEEE Antennas and Wireless Propagation Letters
In this letter, we propose a wideband, low-profile phased array with vertically polarized end-fire radiation patterns. The array consists of four identical log-periodic top-hat monopole antennas (LPTMAs) and could be completely embedded within a shallow cavity for sight invisible integrated installation on metallic platforms. Simulation results show that the proposed array operates over a wide frequency band of 1.0-3.0 GHz for active VSWR < 2.0. It also possesses end-fire radiation patterns with $\pm$ 45° beam scanning capability in the horizontal plane. Prototypes of the proposed LPTMA and a uniformly spaced linear array (1×4) are fabricated and validated in experiments. Measured results are in good agreement with the simulation results. The measured results demonstrate that the proposed end-fire scanning array is attractive for applications that require wideband beam scanning, excellent aerodynamic and stealth performances.
A small size wideband (2–6 GHz) circularly‐polarised log‐periodic Koch fractal antenna (LPKFA) is proposed. The circular polarisation is produced by using a pair of unequal length crossed‐dipoles, and the wideband property is achieved based on the concept of the log‐periodic dipole antenna without a matching network. In addition, Koch‐shaped dipoles are used as the radiation elements in the design.
1 January 2013 in International Journal of Antennas and Propagation
A novel high-performance circularly polarized (CP) antenna is proposed in this paper. Two separate antennas featuring the global positioning system (GPS) dual-band operation (1.575 GHz and 1.227 GHz for L1 band and L2 band, resp.) are integrated with good isolation. To enhance the gain at low angle, a new structure of patch and two parasitic metal elements are introduced. With the optimized design, good axial ratio and near-hemispherical radiation pattern are obtained.