Three-dimensional laser scanning is a novel measurement technique that is frequently used for the documentation of cultural heritage (CH) objects. In the process of 3D scanning, one can obtain computing 3D models of artworks to be documented. It allows one to produce detailed digitized archives of important CH objects. Moreover, the use of 3D scanning enables the digital reconstruction of architectural fragments, sculptures, and other artworks. One more important application of this technique relates to the creation of molds and replicas for replacements of outdoor CH objects in case their preservation requirements do not allow them to remain in their original place due to the influence of environmental factors. One of the most effective ways of creating replicas is the use of laser additive technologies. Therefore, the combination of 3D scanning and additive technologies is a very promising way of preservation of CH. This paper describes several case studies concerned with the combined usage of 3D laser scanning and additive technologies for digital reconstruction and replication and of outdoor sculptures in St. Petersburg city. One of them is the reconstruction of the zinc sculpture “Eva at the fountain” (XIX century, England), which was destroyed during WWII. Its replica was created by means of laser stereolithography. Eventually, one more project is related to the reconstruction of the fragment of the sufficiently damaged cast-iron XIX century monument. This object was reconstructed using two laser technologies: direct metal laser sintering (DMLS), and laser cladding (LC).

Metal additive manufacturing (AM) by Laser-Directed Energy Deposition (L-DED) usually results in the formation of textured columnar grains along the build direction, leading to anisotropic mechanical properties. This can negatively affect the intended application of the product. Anisotropy can be eliminated by modifying the material through an additional exposure to ultrasound (US-assisted) during the L-DED process. In this paper, a multi-track sample was manufactured from AISI H13 (TLS Technik, Bitterfeld-Wolfen, Germany) tool steel by a US-assisted (28 kHz) L-DED process using a specially designed cooling system. The study also included post-process annealing and quenching with the tempering heat treatment of the modified steel, resulting in the retention of the properties, as confirmed by hardness measurements. XRD analysis was used to measure the structural parameters of the unit cell, and the hardness properties were measured in two directions: longitudinally and parallel to the deposition direction. It was found that US-assisted L-DED allows us to obtain a more isotropic structure with an equal size of the coherent scattering region in two printing directions, and to reduce the residual stresses in the material. The anisotropy of the hardness was significantly reduced, with 636 and 640 HV found between the XY and XZ planes. Based on the obtained hardness data, it should be noted that some of the heat treatments studied herein can also result in a decrease in the anisotropy of the properties, similarly to the US-assisted effect.