The surface of high-performance poly(ethylene terephthalate) (PET) fibers is difficult to wet and impossible to chemically bond to different matrices. Sizing applied on the fiber surface usually improves fiber wetting, but prevents good adhesion between a matrix and the fiber surface. The present study demonstrates that the plasma treatment performed by Surface dielectric barrier discharge (Surface DBD) can lead to improved adhesion between sized PET fabric and polyurethane (PU) or poly(vinyl chloride) (PVC) coatings. Moreover, it points out that this plasma treatment can outperform current state-of-the-art adhesion-promoting treatment. Plasma treatment of sized fabric was carried out in various gaseous atmospheres, namely N2, N2 + H2O, N2 + AAc (acrylic acid) and CO2. The adhesion was assessed by a peel test, while wettability was evaluated using strike-through time and wicking rate tests. Changes in fiber surface morphology and chemical composition were determined using scanning electron microscopy (SEM) and X-ray photoelectron spectroscopy (XPS), respectively. Only the CO2 plasma treatment resulted in improved adhesion. As indicated by the analyses, increased surface roughness and the incorporation of specific oxygen-containing groups were responsible for enhanced adhesion. The results presented were obtained using a plasma reactor suitable only for batch-wise treatment. As continuous treatment is expected to provide higher homogeneity and, therefore, even better adhesion, a scaled-up Surface DBD plasma system allowing continuous treatment is presented as well.
Renewable energy sources such as photovoltaic (PV) technologies are considered to be key drivers towards climate neutrality. Thin-film PVs, and particularly copper indium gallium selenide (CIGS) technologies, will play a crucial role in the turnaround in energy policy due to their high efficiencies, high product flexibility, light weight, easy installation, lower labour-intensiveness, and lower carbon footprint when compared to silicon solar cells. Nonetheless, challenges regarding the CIGS fabrication process such as moderate reproducibility and process tolerance are still hindering a broad market penetration. Therefore, cost-efficient and easily implementable in-line process control methods are demanded that allow for identification and elimination of non-conformal cells at an early production step. As part of this work, a practical approach towards industrial in-line photoluminescence (PL) imaging as a contact-free quality inspection tool is presented. Performance parameters of 10 CIGS samples with 32 individually contacted cells each were correlated with results from PL imaging using green and red excitation light sources. The data analysis was fully automated using Python-based image processing, object detection, and non-linear regression modelling. Using the red excitation light source, the presented PL imaging and data processing approach allows for a quantitative assessment of the cell performance.
Copper indium gallium selenide (CIGS) thin film photovoltaic devices are in the early stages of large-scale commercialization. Their high performance, uniformity, reliability, and a low carbon footprint make them an attractive alternative to standard silicon solar cells. Due to the complex processing required and the associated manufacturing costs, reliable in-line quality control technology is needed. By identifying defective cells early in production, faulty batches can be excluded from further processing, saving resources and costs. We show that micro-Raman spectroscopy (RS) and hyper-spectral imaging (HSI) are powerful tools for quality control and process improvement. Distinctive features in the Raman spectra allow the estimation of the copper to gallium plus indium (CGI) ratio, which is an important criterion for the cell’s efficiency. With HSI in the visible and near infrared range (VNIR) and the near-infrared spectral range (NIR) in combination with machine learning techniques, the layer thickness and CGI ratio are accurately predicted.