This article presents a linear active disturbance rejection control (LADRC) scheme for two-mass systems (TMSs) based on a singular perturbation (SP) approach. In the proposed scheme, the dynamics of TMSs are separated into a quasi-steady-state system at a slow time scale and a boundary-layer system at a fast time scale via the SP method. The quasi-steady-state model is used as the nominal model to design the LADRC, where internal model control (IMC) rules are employed for prescribed tracking performance. This not only reduces the model order but also makes the gain tuning straightforward, which is crucial for practical use. Based on the boundary-layer model, the active damping method is designed for vibration suppression, which aims at achieving a higher stable bandwidth of the IMC to better attenuate the residual disturbance of linear extended state observer such that the tracking accuracy can be improved. Stability of the full system was analyzed via the extended Tikhonov's theorem. Comparative experiments were carried out to verify the effectiveness of the proposed scheme.
Developing real-time biomechanical feedback systems for in-field applications will transfer human motor skills’ learning/training from subjective (experience-based) to objective (science-based). The translation will greatly improve the efficiency of human motor skills’ learning and training. Such a translation is especially indispensable for the hammer-throw training which still relies on coaches’ experience/observation and has not seen a new world record since 1986. Therefore, we developed a wearable wireless sensor system combining with artificial intelligence for real-time biomechanical feedback training in hammer throw. A framework was devised for developing such practical wearable systems. A printed circuit board was designed to miniaturize the size of the wearable device, where an Arduino microcontroller, an XBee wireless communication module, an embedded load cell and two micro inertial measurement units (IMUs) could be inserted/connected onto the board. The load cell was for measuring the wire tension, while the two IMUs were for determining the vertical displacements of the wrists and the hip. After calibration, the device returned a mean relative error of 0.87% for the load cell and the accuracy of 6% for the IMUs. Further, two deep neural network models were built to estimate selected joint angles of upper and lower limbs related to limb coordination based on the IMUs’ measurements. The estimation errors for both models were within an acceptable range, i.e., approximately ±12° and ±4°, respectively, demonstrating strong correlation existed between the limb coordination and the IMUs’ measurements. The results of the current study suggest a remarkable novelty: the difficulty-to-measure human motor skills, especially in those sports involving high speed and complex motor skills, can be tracked by wearable sensors with neglect movement constraints to the athletes. Therefore, the application of artificial intelligence in a wearable system has shown great potential of establishing real-time biomechanical feedback training in various sports. To our best knowledge, this is the first practical research of combing wearables and machine learning to provide biomechanical feedback in hammer throw. Hopefully, more wearable biomechanical feedback systems integrating artificial intelligence would be developed in the future.
10 December 2021 in IEEE Transactions on Biomedical Engineering
Objective: Adolescent idiopathic scoliosis (AIS) is a common structural spinal deformity and is typically associated with altered muscle properties. However, it is still unclear how muscle activities and the underlying neuromuscular control are changed in the entire scoliotic zone, restricting the corresponding pathology investigation and treatment enhancements. Methods: High-density electromyogram (HD-EMG) was utilized to explore the neuromuscular synergy of back muscle activities. For each of ten AIS patients and ten healthy subjects for comparison, an HD-EMG array was placed on their back from T8 to L4 to record EMG signals when performing five spinal motions (flexion/extension, lateral bending, axial rotation, siting, and standing). From the HD-EMG recordings, muscle synergies were extracted using the non-negative matrix factorization method and the topographical maps of EMG root-mean-square were constructed. Results: For both the AIS and healthy subjects, the experimental results indicated that two muscle synergy groups could explain over 90% of recorded muscle activities for all five motions. During flexion/extension, the patients presented statistically significant higher activations on the convex side in the entire root-mean-square maps and synergy vector maps ( p < 0.05). During lateral bending and axial rotation, the patients exhibited less activated muscles on the dominant actuating side relative to the contralateral side and their synergy vector maps showed a less homogenous and more diffuse distribution of muscle contraction with statistically different centers of gravity. Conclusion: The findings suggest a scoliotic spine might adopt an altered modular muscular coordination strategy to actuate different dominant muscles as adapted compensations for the deformation.
The constantly rising number of limb stroke survivors and amputees has motivated the development of intelligent prosthetic/rehabilitation devices for their arm function restoration. The device often integrates a pattern recognition (PR) algorithm that decodes amputees’ limb movement intent from electromyogram (EMG) signals, characterized by neural information and symmetric distribution. However, the control performance of the prostheses mostly rely on the interrelations among multiple dynamic factors of feature set, windowing parameters, and signal conditioning that have rarely been jointly investigated to date. This study systematically investigated the interaction effects of these dynamic factors on the performance of EMG-PR system towards constructing optimal parameters for accurately robust movement intent decoding in the context of prosthetic control. In this regard, the interaction effects of various features across window lengths (50 ms~300 ms), increments (50 ms~125 ms), robustness to external interferences and sensor channels (2 ch~6 ch), were examined using EMG signals obtained from twelve subjects through a symmetrical movement elicitation protocol. Compared to single features, multiple features consistently achieved minimum decoding error below 10% across optimal windowing parameters of 250 ms/100 ms. Also, the multiple features showed high robustness to additive noise with obvious trade-offs between accuracy and computation time. Consequently, our findings may provide proper insight for appropriate parameter selection in the context of robust PR-based control strategy for intelligent rehabilitation device.
Introduction: The brain functional network can describe the spontaneous activity of nerve cells and reveal the subtle abnormal changes associated with brain disease. It has been widely used for analyzing early Alzheimer's disease (AD) and exploring pathological mechanisms. However, the current methods of constructing functional connectivity networks from functional magnetic resonance imaging (fMRI) heavily depend on the software toolboxes, which may lead to errors in connection strength estimation and bad performance in disease analysis because of many subjective settings.Methods: To solve this problem, in this paper, a novel Adversarial Temporal-Spatial Aligned Transformer (ATAT) model is proposed to automatically map 4D fMRI into functional connectivity network for early AD analysis. By incorporating the volume and location of anatomical brain regions, the region-guided feature learning network can roughly focus on local features for each brain region. Also, the spatial-temporal aligned transformer network is developed to adaptively adjust boundary features of adjacent regions and capture global functional connectivity patterns of distant regions. Furthermore, a multi-channel temporal discriminator is devised to distinguish the joint distributions of the multi-region time series from the generator and the real sample.Results: Experimental results on the Alzheimer's Disease Neuroimaging Initiative (ADNI) proved the effectiveness and superior performance of the proposed model in early AD prediction and progression analysis.Discussion: To verify the reliability of the proposed model, the detected important ROIs are compared with clinical studies and show partial consistency. Furthermore, the most significant altered connectivity reflects the main characteristics associated with AD.Conclusion: Generally, the proposed ATAT provides a new perspective in constructing functional connectivity networks and is able to evaluate the disease-related changing characteristics at different stages for neuroscience exploration and clinical disease analysis.
27 April 2021 in IEEE Transactions on Neural Systems and Rehabilitation Engineering
Motor evoked potential (MEP), which was elicited by transcranial magnetic stimulation (TMS), has been widely used to detect corticospinal projection from TMS cortical site to trunk muscles. It can help to find the stimulation hotspot in the scalp. However, it fails to precisely describe coordinated activities of trunk muscle groups with only single-channel myoelectric signal. In this study, we aimed to use high-density surface electromyography (sEMG) to explore the effect of cortical TMS on lumbar paravertebral muscles in healthy subjects. The cortical site at 1 cm anterior and 4 cm lateral to vertex was chosen to simulate using a single-pulse TMS with different intensities and forward-bending angles. A high-density electrode array (45 channels) was placed on the surface of lumbar paravertebral muscles to record sEMG signals during a TMS experiment. MEP signals elicited by TMS were extracted from 45-channel recordings and one topographic map of the MEP amplitudes with six spatial features was constructed at each sampling point. The results showed TMS could successfully evoke an oval area with high intensity in the MEP topographic map, while this area mainly located in ipsilateral side of the TMS site. Intensity features related to the high intensity area rose significantly with TMS intensity and forward-bending angle increasing, but location features showed no change. The optimal stimulation parameters were 80% of maximum stimulator output (MSO) for TMS intensity and 30/60 degree for forward-bending angle. This study provided a potentially effective mapping tool to explore the hotspot for transcranial stimulation on trunk muscles.