The residual stress plays an important role in composite flywheel rotors composed of filament windings. The fiber tension during high-prestressed winding is the main source of the rotor deformation and residual stress of composite layers. In this study, the effect of the winding tension gradient on deformation was monitored in real-time. Two types of in-plane winding tension fluctuation methods were developed to investigate the effect of tension on deformation. Online and offline measurements were performed for the strain acquisition. A wireless strain instrument was used for online deformation monitoring and a laser scanner was used for the offline surface reconstruction. Additionally, different filament winding strategies were carried out to improve the efficiency of the winding tension by finite element analysis. The results indicated that the deviation between numerical and experimental results was within 8%. Based on the proposed numerical method, the influence of the in-plane and out-of-plane winding tension gradient distributions on the rotation process of the H-shaped rotor was analyzed. An in-plane winding strategy with variable tension was developed, which increased the initial failure speed by 160%.
The residual stress of metal liners wrapped by composite materials has a significant influence on the service performance of rotating parts, such as flywheel rotors and motor jackets. However, the deformation of the liners, the flow of resins, and the temperature variation during the winding process make it difficult to predict and control this residual stress. In this paper, the process-induced strains were monitored online by a strain gauge with the help of a wireless strain meter. The evolution of this strain during the manufacturing process was fully discussed. A rapid curing resin system was used and its curing properties were tested by differential scanning calorimetry. The mechanical properties of the resin matrix and its composite were characterized. The effect of the curing cycle on the evolution of the residual strain was discussed in detail through comparative experiments. The experimental results show that the use of infrared radiation has a significant advantage regarding residual stress accumulation. This advantage is greater when carbon fiber is used than when glass fiber is used. The prestress in composites of glass fiber and carbon fiber increases by 5.9% and 41.7%, respectively, after cooling.
26 April 2022 in Journal of Thermoplastic Composite Materials
A lap shear test is employed to evaluate the interfacial bonding strength between unidirectional CF/PEEK tapes as quantification of bonding quality. In this study, a novel tab is proposed to ameliorate bonding testing. The crucial role of developed tabs is to avoid the adherend fracture that is typically observed in specimens with conventional tabs. Specimens with different tab, bonding processes, and lap lengths are prepared and tested. Moreover, theoretical analysis is conducted to predict bonding strength, and finite element simulations are also performed for stress distribution in these specimens with different types of tabs. The experimental and theoretical results demonstrate that the full tab is employed in the bonding test, the stress concentration reduces nearly by 6 times, and the failure mode coincides with the expected requirement. Additionally, the highest estimation of bonding strength increases nearly by 69%, and is approximately consistent with the theoretical calculation, up to 98.6%. This tab configuration, with low dependence on processes and joint parameters, describes a straightforward and efficient procedure to meliorate the quantification of the bonding strength, and is found to be applicable in the tape placement process and single-lap-joint assemblies for thermoplastic composites.