This paper reports on the gas sensing properties of CoFe 2 O 4 nanoparticles toward liquefied petroleum gas, ethanol, and ammonia. The gas response of was studied as a function of the particle size, the temperature, and the gas flow rate. The gas response was found to attain a maximum at an intermediate temperature in the order of 250 °C and to drop off toward higher and lower temperatures. The maximum gas response was found to increase as the particle size is reduced from 28.6 to 5.8 nm. It was further observed that the gas response increases linearly as the gas flow rate is increased. The response and recovery time constants were also observed to be flow-rate-dependent: whereas the response times decreased with the gas flow rate, the recovery time constants increased.
Ni(1-x)Zn(x)Fe2O4 (x = 0, 0.5 and 1) ferrite nanoparticles were synthesized by chemical co-precipitation method. X-ray diffraction technique and Rietveld refinement were used to investigate the structural characteristics and determination of the particle size which was found to decrease from 4.9 to 4.1 nm as a function of increasing Zn from 0 to 1.0. Vibrating sample magnetometer was used to study magnetic properties of nickel zinc ferrite nanoparticles. Field-dependent magnetization measurements (M-H curve) at 300 K revealed that Zn substitutions on inverse spinel nickel ferrites enhance the magnetic properties. Magnetization as a function of temperature showed the superparamagnetic behavior of Ni(1-x)Zn(x)Fe2O4 (x = 0,0.5 and 1) nanoparticles. Dielectric permittivity and a.c. conductivity were measured as a function of frequency from 100 kHz to 1 MHz at certain temperatures. The observed response in a.c. conductivity as a function of log of frequency of these nickel zinc ferrite systems was believed to be due to the presence of Maxwell-Wagner type interfacial polarization and hopping of electron by means of quantum mechanical tunneling.
1 September 2013 in Sensors and Actuators A: Physical