Temperature-dependent dielectric permittivity of lead-free (LixNa1-x)NbO3 for nominal x = 0.04–0.20, prepared by solid state reaction followed by sintering, was studied to resolve often debated issue pertaining to exactness of morphotropic phase boundary (MPB) location besides structural aspects and phase stability in the system near MPB. Interestingly, a diffuse phase transition has been observed in the dielectric permittivity peak arising from the disorder induced in A-site and structural frustration in the perovskite cell due to Li substitution. A partial phase diagram has been proposed based on temperature-dependent dielectric permittivity studies. The room temperature piezoelectric and ferroelectric properties were investigated and the ceramics with x = 0.12 showed relatively good electrical properties (d33 = 28 pC/N, kp = 13.8%, Qm = 440, Pr = 12.5 μC/cm2, Ec = 43.2 kV/cm, and Tm = 340 °C). These parameter values make this material suitable for piezoelectric resonator and filter applications. Moreover, a high dielectric permittivity (ε′r = 2703) with broad diffuse peak near transition temperature, and low dielectric loss (<4%) over a wide temperature range (50–250 °C) found in this material may also have a potential application in high-temperature multilayer capacitors in automotive and aerospace related industries.
26 October 2017 in Journal of Materials Science: Materials in Electronics
The chemical co-precipitation method was used to synthesize MnFe2O4 nanoparticles. Single cubic phase formation of nanoparticles was confirmed by X-ray diffraction technique. The average particle size of MnFe2O4 nanoparticles was found to be 10.7 nm using Scherrer formula. The ultrafine powder of MnFe2O4 nanoparticles was pressed to design pellet of 10 mm diameter and 1mm thickness. Copper electrodes have been deposited on the surface of pellet using silver paste in the form of capacitor. Fabricated gas sensing device of MnFe2O4 nanoparticles was tested towards SO2 and NO2 gases. Cole-Cole plot of MnFe2O4 was investigated with the help of electrochemical workstation. The performance of the sensors including sensitivity, response and recovery time was also determined. It was observed that the MnFe2O4 nanoparticles are more sensible for NO2 gas as compared to SO2 gas.