A novel folded slot antenna is proposed for the design of high-gain and compact endfire arrays. This study shows that a planar slot antenna retains bi-directional radiation characteristics when folded into a compact structure. A folded slot antenna was designed in order to obtain a high endfire gain of 6 dBi. The proposed slot antenna's high gain makes it a good candidate for designing endfire arrays with vertical polarization. A series-fed technique is proposed in order to design two-element endfire and backfire arrays. Subsequently, an eight-element endfire array is proposed by combining endfire and backfire two-element arrays. The eight-element array is capable of producing a high endfire gain of 13.2 dBi with a size of ${1.80\lambda_{0} \times 1.40\lambda_{0}}$ , which is less than half the size of the existing endfire antennas with similar vertically polarized gain.
2 September 2019 in IEEE Antennas and Wireless Propagation Letters
A new quasi-magnetic-electric circularly-polarized (CP) patch antenna with wide bandwidth is proposed. The proposed antenna has a low-profile structure with a single feed, and provides CP radiation with a stable gain. It consists of a shorted bowtie patch antenna that works as an equivalent magnetic current source, and a bowtie dipole that acts as an electric current source. With a single feed, the two orthogonal current sources are combined to generate a circular polarization. For the proposed antenna, measurement results show that an impedance bandwidth of 31.7% and a 3-dB axial ratio bandwidth of 15.3% are achieved. The antenna has a gain of about 7 dBic in the band of interest, and a cross-polarization level of about −19 dB at the central frequency.
20 July 2018 in IEEE Transactions on Industrial Electronics
To support different standards simultaneously within a wireless communication system, the research on dual-/multi-band components has been conducted extensively. However, the operating frequencies of existing works are usually fixed resulting in a low flexibility. To solve this problem, a highly reconfigurable coupler whose two operating frequencies can be controlled independently, is proposed for the first time. Based on the analysis of a basic configuration, the conditions for realizing the desired independent frequency tuning can be obtained. To realize this unique property, varactors loaded coupled line sections are introduced on a conventional branch line coupler. Owing to the symmetrical structure of the proposed coupler, explicit theoretical analysis can be conducted. For demonstration, two reconfigurable couplers were designed, fabricated and measured. The first coupler can provide frequency tunability from 3.4 to 4.2 GHz at the upper band with lower band fixed at 2.4 GHz. The other one can not only provide a tunable frequency from 1.3 to 1.6 GHz at the lower band with higher band fixed at 3.4 GHz, but also give a tunable higher band from 2.9 to 3.4 GHz with lower band fixed at 1.55 GHz. The measured results agree well with the simulated results, validating the proposed design methodologies.
29 June 2014 in International Journal of Antennas and Propagation
A new center-fed circular patch antenna with two coupled annular rings is presented. When the two annular rings are coupled properly, a wide band from 5.45 GHz to 7.16 GHz is achieved with a monopole-like radiation pattern. Measured results show that the antenna with a low profile of 0.027 wavelengths (at 5.45 GHz) has a bandwidth of 27.1% and a measured maximum gain of 6 dBi. The radiation pattern is omnidirectional and remains relatively stable within the operating band.
27 December 2022 in IEEE Transactions on Network and Service Management
Deep learning-assisted indoor fingerprint localization based on frequent data collection is motivating renewed interest via crowdsourcing. Uploading raw training data may cause exposure of privacy in crowdsourcing. Federated Learning (FL) is thus introduced into indoor localization since its advantages in privacy protection. Nevertheless, most current FL-based indoor localization studies do not consider deploying systems in real wireless environments. Furthermore, transmission latency and outages caused by unreliable wireless networks are ignored. In addition, centralized FL-based indoor localization is adopted in most studies while decentralized FL-based indoor localization system is seldomly considered. In this paper, a decentralized Federated Learning (DFL)-based indoor localization system over wireless D2D networks is proposed for mitigating effects from single point of failure and communication bottleneck from centralized FL. Moreover, unreliable wireless links are further considered. To reduce the transmission latency, a greedy-based scheduling policy is devised to select DFL participants via jointly considering channel condition and scheduling fairness. For the possible transmission outages, a maximum distribution similarity-based successive model decoding aggregation algorithm is proposed to aggregate models more robustly and the corresponding theoretical analysis is provided. Experimental results based on real-world dataset collected by us show that proposed methods achieve better performance both in reducing latency and localization error than baseline schemes.
20 January 2023 in IEEE Antennas and Wireless Propagation Letters
This letter presents a higher-order finite-difference (FD) and Padé approximations method for the three-dimensional (3D) parabolic equation (PE) to predict radio-wave propagation. This method uses a 4 $^{\boldsymbol {th}}$ -order FD approximation of the differential operator in the transverse direction and a higher-order Padé approximation of the operator in the propagation direction. The 4 $^{th}$ -order FD and higher-order Padé (4FDHP) method is then derived. The Leontovich impedance boundary for the 4FDHP method and boundary for the 2 $^{nd}$ -order FD and higher-order Padé (2FDHP) method are also derived. The important problem of the propagation angle of the different approximations for the 3D-PE is investigated. Simulated results show that the proposed 4FDHP method achieves a larger propagation angle and higher accuracy than those of the 2FDHP method and the Mitchell-Fairweather alternative-direction-implicit (MF-ADI) method.