The WGS reaction is an exothermic reaction between carbon monoxide and steam to form carbon dioxide and hydrogen. This reaction, which has been used industrially for more than 100 years, has recently received a great deal of attention from researchers as one of the ways to produce environmentally acceptable hydrogen from fossil fuels in large quantities. For the application of this reaction on an industrial scale, the key is choosing the optimal catalysts that can ensure high CO conversion and have a long lifetime under industrial conditions. Therefore, new types of catalysts are being developed that meet these requirements better than the Fe- and Cu-based catalysts commonly used in the past. The WGSR on a commercial nickel-based catalyst and a laboratory-prepared copper- and cobalt-based catalyst was tested in a laboratory apparatus set up at the University of Chemistry and Technology Prague. The best performance of the laboratory-prepared catalyst was observed for the catalyst with a Cu content of 14.8 wt% and activated in a hydrogen atmosphere. The laboratory-prepared Co-based catalyst showed good WGSR activity in the temperature range of 200–450 °C, although this was always inferior to that of the Cu-based catalyst. When subjected to the feed gas containing 0.4 mole% H2S, the Co-based catalyst showed good resistance to sulphur poisoning. Therefore, Co-based catalysts can be considered good sulphur-tolerant intermediate temperature WGSR catalysts.
A thermal conversion of biomass to hythane using catalysts was studied. Low-temperature pyrolysis of two different types of biomass was performed in a pressure sealed reactor, and the resulting gas with high contents of CO2 and CO was methanized in a hydrogen atmosphere at a pressure of 30 bar. As catalysts, Ni/Al2O3, NiCo/Al2O3 and NiMo/Al2O3 were used and their catalytic activity was evaluated. The NiCo/Al2O3 catalyst showed the highest catalytic activity, Ni/Al2O3 had a lower but comparable one, and NiMo/Al2O3 showed the lowest activity. The resulting hythane contained 70 vol.% CH4 and 10 vol.% H2 (with NiCo/Al2O3 catalyst, HHV 29.20 MJ/m3, LHV 26.32 MJ/m3), or 57 vol.% CH4 and 23 vol% H2 (with Ni/Al2O3, HHV 25.92 MJ/m3, LHV 23.21 MJ/m3) or 47 vol.% CH4 and 27 vol.% H2 (with NiMo/Al2O3, HHV 23.23 MJ/m3, LHV 20.76 MJ/m3). It has been found that secondary reactions of volatile biomass products are of great importance for successful pressure pyrolysis.