Possibilities for partial utilization of carbon dioxide, which is produced by burning fossil fuels, biomass, waste, etc., have been recently sought. The Power-to-Gas (P2G) conception, in which the captured CO2 is converted into methane using hydrogen produced from nonfossil sources, such as water electrolysis using surplus electricity in distribution networks, is one of the ways. However, surplus energy fluctuates strongly during the day and calendar year, which negatively affects the efficiency and financial return of P2G. The article is devoted to the development of a test unit that allows capturing CO2 from flue gases and converting it in-situ to methane (in the same reactor), if an adequate amount of hydrogen is available. Conversely, in the event of H2 shortage, the system produces concentrated CO2 suitable for compression and, for example, geological storage. The paper contains a detailed description of the self-designed test stand, which both simulates the conditions in the considered real operating facility very well (at the TRL 5 level) and is compact enough to be easily transported as a single module to an industrial source of flue gases. Two adsorbents/catalysts based on nickel-modified substrates gamma−Al2O3 and Envisorb B+ were developed. After preliminary laboratory tests including measurements of adsorption capacities, structural stability, optimization of working media dosing, etc., the system was transported to the Ško-Energo, s.r.o. plant. After the installation and activation of the stand and all peripherals, intensive tests are underway at the time of publication of the paper, which verify the laboratory results and will allow the level of technological readiness to be increased to the TRL6 value within the framework of subsequent development. However, the first phase of testing has already provided valuable data on the unit and the designed sorbents/catalysts..The stand has proven to be fully functional in terms of combining CO2 adsorption and its subsequent reaction to methane within a single reactor. The gamma−Al2O3-based sorbent/catalyst showed promising conversion at an average of 72%. In contrast, the material prepared from the commercial adsorbent Envisorb B+ proved unsuitable for the given purpose with a conversion of 2.8% only. Further tests will address the improvement of the still low adsorption capacity (approximately 0.5% by weight) by switching to a higher-pressure level than the atmospheric one used so far.