The most remarkable variable cycle characteristic of the variable cycle engine (VCE) is that it keeps airflow almost constant during subsonic cruise throttling by modulating variable geometries, which can efficiently decrease spillage drag and increase installed thrust. One of the most critical challenges for the modulation lies in completely maintaining airflow, as well as avoiding specific fuel consumption (SFC) degradation during throttling. This has resulted in a need to investigate the modulation regulation of the adaptive cycle engine (ACE) which is a new concept for VCE and has greater potential for flexibly modulating airflow and pressure ratio. Thus, the aim of this paper is to study the variable geometries’ modulation schedule of ACE in maintaining airflow during throttling. A configuration of an ACE concept and its modeling study are first put forward. Then, the control schedule is researched via the combination of sensibility analysis and basic working principle instead of optimizing them directly. Results show that when the net thrust decreases from 100% to about 55% during subsonic cruise and to 32% during the supersonic cruise, the demand airflow of the engine is kept almost constant, which greatly improves the installed performance during throttling.
Gas path fault diagnosis plays an important role in guaranteeing safe, reliable and cost-effective operation for gas turbine engines. Measurements selection is among the most critical issues for diagnostic method implementation. In this paper, an integration approach for optimal measurements selection, which combines finger print diagrams analysis, health parameters correlation analysis, performance estimation uncertainty index analysis and fault cases validation based on genetic algorithm, has been proposed and applied to assess the health condition of a two-spool split flow turbofan in test bed. First, mathematical description of an engine gas path fault diagnosis process was given and the influence coefficient matrix was also calculated based on a well calibrated nonlinear engine performance simulation model. Second, the number of combination candidates was reduced from 782 to 256 and three measurements were picked out using the finger print diagrams analysis and the health parameters correlation analysis. Then, the number of the combination candidates was further narrowed down to 13 using the performance estimation uncertainty index analysis. A nonlinear genetic algorithm fault diagnosis method was applied to test the diagnostic ability of the remaining measurement candidates. Finally, an optimal measurement combination was worked out which demonstrated the effectiveness of the integration approach. This integration approach for optimal measurements selection is also applicable to other type of gas turbine engines.
Under the condition of high altitude and low Mach number, the low Reynolds number greatly affects the performance and aerodynamic stability of aero-engines for high altitude endurance uninhabited aerial vehicles. In order to quantitatively analyze this effect, an iteration simulation method has been employed, in which the aero-engine zero-dimensional simulation is communicated and iterated with the components three-dimensional simulation several turns, until the result is satisfactory. The result shows, under the condition of low Reynolds number, not only the efficiency and the mass flow capacity of the rotational components decline, but also the surge lines of the fan and the compressor move downward. Furthermore, to meet the constraints of different engine components operating together, the matching operation lines of the fan and the compressor move toward the surge line, which leads to the decrease of the surge margin. These simulation results agree well with high altitude experimental results.