The influence of quantum-well (QW) width on electroluminescence properties of AlGaN deep ultraviolet light-emitting diodes (DUV LEDs) was studied at different temperatures. The maximum external quantum efficiency (EQE) ratios of LED with 3.5 nm QW to that with 2 nm increased from 6.8 at room temperature (RT) to 8.2 at 5 K. However, the ratios for LED with 3.5 nm QW to that with 5 nm QW decreased from 4.8 at RT to 1.6 at 5 K. The different changes of EQE ratios were attributed to the decrease of non-radiative recombination and the increase of volume of the active region. From theoretical analysis, the LED with 2-nm wells had a shallowest barrier for electron overflow due to the quantum-confined effect, whereas the LED with 5-nm wells showed the least overlap of electron and hole due to the large internal field. Therefore, the LED with 3.5 nm QW had the highest maximum EQE at the same temperature. As temperature decreased, the current for maximum EQE decreased for all the LEDs, which was believed to be due to the increase of electron which overflowed out of QWs and the decrease of hole concentration. The results were helpful for understanding the combination of polarization effect and electron overflow in DUV LEDs.
Memory nonlinear error greatly reduces the performance of analog-to-digital converters (ADCs), and this effect is more serious in a time-interleaved analog-to-digital converter (TIADC) system. In this study, the sinusoidal wave fitting method was adopted and a joint error estimation method was proposed to address the memory nonlinear mismatch problem of the current TIADC system. This method divides the nonlinear error estimation method into two steps: the nonlinear mismatch error is coarsely estimated offline using the least squares (LS) method, and then accurately estimated online using the recursive least squares (RLS) method. After the estimation, digital post-compensation method is adopted. The obtained error parameters are used to reconstruct the error and then the reconstructed error is reduced at the output. This study used a four-channel 16-bit TIADC system with an effective number of bits (ENOB) value of 10.06 bits after the introduction of a memory nonlinearity error, which was increased to 15.42 bits after calibration by the joint error estimation method. As a result, the spurious-free dynamic range (SFDR) increased by 36.22 dB. This error estimation method can improve the error estimation accuracy and reduce the hardware complexity of implementing the error estimation system using a field programmable gate array (FPGA).
In the signal detection of two-dimensional material light modulation spectrum, the modulation signal is very weak and often submerged in the noise, so it is difficult to detect the modulation signal in the research. In order to detect weak modulation signals, according to the principle of digital phase lock amplification, this paper realizes the orthogonal digital phase lock method in MATLAB, and studies the extraction of modulation signals in the optical modulation spectrum. The results show that when the average noise is 20 μV, the digital phase-locked amplifier can effectively extract the modulation signal of 1 μV. When the amplitude, phase and type of modulation signal change, the extraction of modulation signal will not be affected.