Takashi Egawa

Takashi Egawa


Research Focus & Metrics

Academic Career Length

25Years (2002-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
15 March 2005 in Applied Physics Letters
Verified
Journal Article
Closed access
SAS. Arulkumaran
S. Arulkumaran
TETakashi Egawa
Takashi Egawa
SMS. Matsui
S. Matsui
HIH. Ishikawa
H. Ishikawa
Enhancement of breakdown voltage (BV) with the increase of AlN buffer layer thickness was observed in AlGaN∕GaN high-electron-mobility transistors (HEMTs) grown by metalorganic chemical vapor deposition on 4in. Si. The enhancement of device performance with AlN buffer thickness (200 and 300nm) is due to the reduction of electrically active defects from Si substrate. The reduction of defects from Si with the increase of AlN thickness was confirmed by x-ray rocking curve measurements. Not much change has been observed in ON-state BV (BV:ON) values except in devices with 500-nm-thick buffer layer. About 46% enhancement in OFF-state BV (BV:OFF) was observed on 200μm wide HEMTs with 300nm thick AlN buffer layer when compared to HEMTs with 8nm thick AlN buffer layer. The location of junction breakdown in the device was identified as GaN∕AlN∕Si interface. The measured specific on-resistance (Ron) values for 200 and 400μm wide HEMTs with 300nm thick buffer layers were 0.28 and 0.33mΩcm2, respectively. About an order of low Ron was observed when compared with the reported values. The AlGaN∕GaN HEMTs on 4in. Si with thicker AlN buffer layers are suitable for high-power applications.

6 September 2004 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
MMM. Miyoshi
M. Miyoshi
HIH. Ishikawa
H. Ishikawa
TETakashi Egawa
Takashi Egawa
KAK. Asai
K. Asai
MMM. Mouri
M. Mouri
OOO. Oda
O. Oda
Al0.26Ga0.74N∕AlN∕GaN heterostructures with 1-nm -thick AlN interfacial layers were grown on 100-mm -diam epitaxial AlN/sapphire templates and sapphire substrates by metalorganic vapor phase epitaxy. It was found that AlN/sapphire templates significantly enhanced the electron mobility of the two-dimensional electron gas (2DEG) confined at the GaN channel. This can be explained by the high-crystal-quality GaN channel realized by the use of epitaxial AlN/sapphire templates as substrates. The very high Hall mobilities of approximately 2100cm2∕Vs at room temperature and approximately 17000cm2∕Vs at 77K with a 2DEG density of approximately 1×1013∕cm2 were uniformly obtained for AlGaN∕AlN∕GaN heterostructures on 100-mm -diam epitaxial AlN/sapphire templates. The Hall mobility of AlGaN∕AlN∕GaN heterostructures on epitaxial AlN/sapphire templates reached a very high value of 25500cm2∕Vs at 15K .

19 August 2010 in Journal of Physics D: Applied Physics
Verified
Journal Article
Closed access
PDF file
TETakashi Egawa
Takashi Egawa
ASAhmad Shuhaimi
Ahmad Shuhaimi
We report high performance InGaN multiple-quantum well (MQW) light-emitting diodes (LEDs) grown on Si (1 1 1) substrates using metalorganic chemical vapour deposition (MOCVD). A high-temperature thin AlN layer and AlN/GaN multilayers have been used for the growth of a high-quality GaN-based LED structure on Si substrates. Reduction of the high-temperature AlN layer thickness promotes the formation of a tunnel junction at the AlN/Si interface which reduces the LED operating voltage. Optical output power of the LED on Si saturates at a higher injected current density due to higher thermal conductivity of Si than that of a sapphire substrate. At a high injection current, output power of the LED on Si is higher than that of the LED on sapphire. Cross-sectional transmission electron microscopy (TEM) indicates that the active layer of these LEDs consists of a dislocation-free pyramid-shaped (quantum-dot-like) structure. Additionally, the crack-free thin-film LED epilayer region was transferred onto a copper carrier using metal-to-metal bonding and the selective lift-off technique. A LED with high output power, low operating voltage and low series resistance was realized by this technique. Furthermore, optimization of LED on Si by insertion of an Al0.06Ga0.94N/GaN strained-layer superlattice underlayer into the structure exhibits improved internal quantum efficiency (ηiqe) in the MQW, higher optical emission intensity with higher saturation current, lower operation voltage of 3.2 V at 20 mA and a series resistance of 16 Ω, as well as narrower electroluminescence spectra.

1 March 2012 in Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
ZCZ. T. Chen
Z. T. Chen
KFK. Fujita
K. Fujita
JIJ. Ichikawa
J. Ichikawa
TETakashi Egawa
Takashi Egawa
The crystal qualities of InAlN nearly lattice-matched (LM) to GaN with different thicknesses have been investigated by X-ray diffraction (XRD) and transmission electron microscopy (TEM). It was found that the crystal quality of InAlN starts to degrade when the InAlN thickness exceeds several hundred nanometers, forming a structure consisting of two sub-layers with one sub-layer coherent to GaN and the other being degraded. Moreover, the degradation was found to be governed by the threading dislocations (TDs) propagation from the underlying GaN layer, rather than by the misfit strain between InAlN and GaN. Based on TEM observations, the growth evolution of the two-sub-layer structure is proposed, which is different from those conventional mechanisms of crystal-quality degradation in heteroepitaxial material. The results of InAlN nearly LM to GaN are suggested to be helpful in understanding the growths of lattice-mismatched systems of other In-contained III-nitrides, including InGaN/GaN.

23 October 2018 in Discover Nano
Verified
Journal Article
Open access
PDF file
STShuxin Tan
Shuxin Tan
JZJicai Zhang
Jicai Zhang
TETakashi Egawa
Takashi Egawa
GCGang Chen
Gang Chen
LXLuo Xiangdong
Luo Xiangdong
YZYouhua Zhu
Youhua Zhu
The influence of quantum-well (QW) width on electroluminescence properties of AlGaN deep ultraviolet light-emitting diodes (DUV LEDs) was studied at different temperatures. The maximum external quantum efficiency (EQE) ratios of LED with 3.5 nm QW to that with 2 nm increased from 6.8 at room temperature (RT) to 8.2 at 5 K. However, the ratios for LED with 3.5 nm QW to that with 5 nm QW decreased from 4.8 at RT to 1.6 at 5 K. The different changes of EQE ratios were attributed to the decrease of non-radiative recombination and the increase of volume of the active region. From theoretical analysis, the LED with 2-nm wells had a shallowest barrier for electron overflow due to the quantum-confined effect, whereas the LED with 5-nm wells showed the least overlap of electron and hole due to the large internal field. Therefore, the LED with 3.5 nm QW had the highest maximum EQE at the same temperature. As temperature decreased, the current for maximum EQE decreased for all the LEDs, which was believed to be due to the increase of electron which overflowed out of QWs and the decrease of hole concentration. The results were helpful for understanding the combination of polarization effect and electron overflow in DUV LEDs.

21 January 2015 in Applied Physics Express
Verified
Journal Article
Closed access
MMMakoto Miyoshi
Makoto Miyoshi
SFShu Fujita
Shu Fujita
TETakashi Egawa
Takashi Egawa