Pavo Dubček

Pavo Dubček


Research Focus & Metrics

Academic Career Length

20Years (2007-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
10 July 2022 in Materials
Verified
Journal Article
Open access
PDF file
KJKrunoslav Juraić
Krunoslav Juraić
PDPavo Dubček
Pavo Dubček
Mario BohačMario Bohač
Mario Bohač
Andreja GajovićAndreja Gajović
Andreja Gajović
SBSigrid Bernstorff
Sigrid Bernstorff
Davor GracinDavor Gracin
Davor Gracin
Fluorine-doped tin oxide thin films (SnO2:F) are widely used as transparent conductive oxide electrodes in thin-film solar cells because of their appropriate electrical and optical properties. The surface morphology of these films influences their optical properties and therefore plays an important role in the overall efficiencies of the solar cells in which they are implemented. At rough surfaces light is diffusely scattered, extending the optical path of light inside the active layer of the solar cell, which in term improves light absorption and solar cell conversion efficiency. In this work, we investigated the surface morphology of undoped and doped SnO2 thin films and their influence on the optical properties of the films. We have compared and analysed the results obtained by several complementary methods for thin-film surface morphology investigation: atomic force microscopy (AFM), transmission electron microscopy (TEM), and grazing-incidence small-angle X-ray scattering (GISAXS). Based on the AFM and TEM results we propose a theoretical model that reproduces well the GISAXS scattering patterns.

19 June 2022 in Crystals
Verified
Journal Article
Open access
PDF file
KLKristina Tomić Luketić
Kristina Tomić Luketić
JHJuraj Hanžek
Juraj Hanžek
CMCatalina G. Mihalcea
Catalina G. Mihalcea
PDPavo Dubček
Pavo Dubček
Andreja GajovićAndreja Gajović
Andreja Gajović
MKMarko Karlusic
Marko Karlusic
The aim of this experimental work was to investigate the influence of the ion beam charge state on damage production in nanomaterials. To achieve this, we employed Raman spectroscopy, atomic force microscopy, and transmission electron microscopy to investigate nanomaterials irradiated by a 23 MeV I beam. We found a significant influence of the ion charge state on damage production in monolayer graphene, but found no evidence of this effect in bilayer and trilayer graphene, nor in graphite. Furthermore, we found no evidence of this effect in CaF2 and SiO2 nanocrystals irradiated with the same ion beam.

13 March 2022 in Materials
Verified
Journal Article
Open access
PDF file
JHJuraj Hanžek
Juraj Hanžek
PDPavo Dubček
Pavo Dubček
SFStjepko Fazinić
Stjepko Fazinić
KLKristina Tomić Luketić
Kristina Tomić Luketić
MKMarko Karlusic
Marko Karlusic
High-energy heavy ion irradiation can produce permanent damage in the target material if the density of deposited energy surpasses a material-dependent threshold value. It is known that this threshold can be lowered in the vicinity of the surface or in the presence of defects. In the present study, we established threshold values for Al2O3, MgO and CaF2 under the above-mentioned conditions, and found those values to be much lower than expected. By means of atomic force microscopy and Rutherford backscattering spectrometry in channelling mode, we present evidence that ion beams with values of 3 MeV O and 5 MeV Si, despite the low density of deposited energy along the ion trajectory, can modify the structure of investigated materials. The obtained results should be relevant for radiation hardness studies because, during high-energy ion irradiation, unexpected damage build-up can occur under similar conditions.

2 September 2022 in Sustainability
Verified
Journal Article
Open access
PDF file
KJKrunoslav Juraić
Krunoslav Juraić
Mario BohačMario Bohač
Mario Bohač
JPJasper Plaisier
Jasper Plaisier
AHAden Hodzic
Aden Hodzic
PDPavo Dubček
Pavo Dubček
Andreja GajovićAndreja Gajović
Andreja Gajović
In this work, we have investigated the potential dual application of TiO2 thin films as a photocatalyst for ammonia degradation, and as a UV light blocking layer in c-Si photovoltaics. For this purpose, we deposited a series of TiO2 thin films on a glass substrate by reactive magnetron sputtering and analysed the influence of the deposition parameters (O2/Ar working gas content and pressure) on the structural, optical and photocatalytic properties. All samples are nanocrystalline anatase TiO2 and have a uniform surface (RMS roughness < 5 nm) in a wide range of magnetron sputtering deposition parameters. They are transparent in the Vis/NIR spectral range and strongly absorb light in the UV range above the optical bandgap energy (3.3 eV), which makes them suitable for the use as UV blocking layers and photocatalysts. The photocatalytic properties were studied in a mini-photocatalytic wind tunnel reactor by examining ammonia degradation. A kinetic study was performed to estimate the reaction rate constants for all samples. The intrinsic reaction rate constant confirmed the crucial role of surface morphology in ammonia decomposition efficiency.

6 September 2007 in Solar Energy Materials and Solar Cells
Verified
Journal Article
Closed access
ATAleksandra Turković
Aleksandra Turković
BOBojan Orel
Bojan Orel
MLM Luciclavcevic
M Luciclavcevic
PDPavo Dubček
Pavo Dubček
ZOZorica Crnjak Orel
Zorica Crnjak Orel
SBSigrid Bernstorff
Sigrid Bernstorff