X-ray Diffraction has been fully exploited as a probe to investigate crystalline materials. However, very little research has been carried out to unveil its potentialities towards amorphous materials. In this work, we demonstrated the capabilities of Grazing Incidence X-ray Diffraction (GIXRD) as a simple and fast tool to obtain quantitative information about the composition of amorphous mixed oxides. In particular, we evidenced that low angle scattering features, associated with local structure parameters, show a significant trend as a function of the oxide composition. This evolution can be quantified by interpolating GIXRD data with a linear combination of basic analytical functions, making it possible to build up GIXRD peak-sample composition calibration curves. As a case study, the present method was demonstrated on Ta2O5–SiO2 amorphous films deposited by RF-magnetron sputtering. GIXRD results were validated by independent measurement of the oxide composition using Rutherford Backscattering Spectrometry (RBS). These materials are attracting interest in different industrial sectors and, in particular, in photovoltaics as anti-reflection coatings. Eventually, the optical properties measured by spectroscopic ellipsometry were correlated to the chemical composition of the film. The obtained results highlighted not only a correlation between diffraction features and the composition of amorphous films but also revealed a simple and fast strategy to characterize amorphous thin oxides of industrial interest.
We have deposited Ge, SiGe, SiGeSn, AlAs, GaAs, InGaP and InGaAs based structures in the same metalorganic vapor phase epitaxy (MOVPE) growth chamber, in order to study the effect of the cross influence between groups IV and III-V elements on the growth rate, background doping and morphology. It is shown that by adopting an innovative design of the MOVPE growth chamber and proper growth condition, the IV elements growth rate penalization due to As “carry over” can be eliminated and the background doping level in both IV and III-V semiconductors can be drastically reduced. In the temperature range 748–888 K, Ge and SiGe morphologies do not degrade when the semiconductors are grown in a III-V-contaminated MOVPE growth chamber. Critical morphology aspects have been identified for SiGeSn and III-Vs, when the MOVPE deposition takes place, respectively, in a As or Sn-contaminated MOVPE growth chamber. III-Vs morphologies are influenced by substrate type and orientation. The results are promising in view of the monolithic integration of group-IV with III-V compounds in multi-junction solar cells.
Most commercially available InGaP/InGaAs/Ge triple-junction solar cells suffer from current mismatch due to the excess current generated by the Ge sub-cell. Combining epitaxial germanium with III–V materials would enable the realization of lattice-matched four- or five-junction solar cells, where the near-infrared spectrum could be split between two Ge sub-cells instead of one, thereby eliminating current mismatch in these devices and achieving higher conversion efficiency. In this work, we present the first demonstration of a quadruple-junction (4J) InGaP/InGaAs/Ge/Ge device, with all layers sequentially deposited in the same MOVPE growth chamber. The 4J device also features a novel architecture that exploits the “transistor effect” between the two Ge junctions to eliminate the current mismatch in the upper 3J InGaP/GaAs/Ge part. We describe the growth and the cell structure realization strategy developed to overcome—and, where beneficial, to exploit—the cross-contamination between III–V and group IV elements, thus avoiding the need for two separate deposition systems. The structural and electrical characterizations performed to ascertain the 4J device quality are presented. This result represents a key step toward the realization of highly efficient, all-MOVPE-grown, lattice-matched MJ solar structures that combine III–V and group IV alloys.