The production of novel materials and value-added chemicals from lignin has received considerable attention in recent years. Due to its abundant occurrence in nature, there is a growing interest in utilizing lignin as a feedstock for functional materials production, for example aerogels. Much like in the synthesis of phenol-based resins, the vacant ortho positions of the aromatic rings in lignin can crosslink with formaldehyde and form polymeric gels. After drying the hydrogels with supercritical CO₂, highly porous aerogels are obtained. Current study focuses on the preparation and thorough parametrization of organosolv lignins from different types of lignocellulosic biomass (aspen, pine, and barley straw) as well as their utilization for the preparation of lignin-5-methylresorcinol-formaldehyde aerogels. The thorough structural characterization of the obtained aerogels was carried out by gas adsorption, IR spectroscopy, and scanning electron microscopy. The obtained lignin-based monolithic mesoporous aerogels had specific surface areas and total pore volumes in the upward ranges of 450 m²/g and 1.4 cm³/g, respectively.

The current study is focused on the in situ synthesis of a carbon aerogel (CA)-based solid-phase microextraction (SPME) fiber coating on stainless steel wire and evaluation of the suitability of CAs as SPME coating materials for the analysis of selected organophosphorus pesticides (OPPs) contained in environmental samples. A CA-based coating was obtained by pyrolyzing organic aerogels, which were prepared by the sol–gel polymerization of formaldehyde and 5-methylresorcinol, an oil shale processing by-product. The results demonstrated, for the first time, the in situ synthesis of a CA-based SPME fiber coating on stainless steel wire and its suitability for the extraction and preconcentration of six OPPs. Main parameters affecting the extraction efficiency were investigated and optimized. The direct immersion (DI)-SPME procedure combined with gas chromatography-mass spectrometry (GC-MS) for the simultaneous analysis of selected OPPs was successfully applied to the efficient and sensitive determination of analytes of interest in environmental matrices of honey and natural water samples. The developed CA-coated SPME fiber showed good linearity (R² = 0.981–0.994), low detection limits (0.11–0.83 μg L⁻¹) and satisfactory single fiber and fiber-to-fiber reproducibilities (8.8–12.3%, n = 5 and 11.4–17.2%, n = 3). The performance of the CA-coating was compared with that of commercially available SPME fiber coatings.

The aim of the present study was to examine three different Galium species from the native population of Estonia, Galium verum, Galium aparine, and Galium mollugo, to characterise their non-volatile and volatile phytochemical composition and antioxidant activity. The main groups of bioactive compounds in the plants were quantified by colorimetric tests, showing high concentrations of polyphenols (up to 27.2 ± 1.5 mg GAE/g), flavonoids (up to 7.3 ± 0.5 mg QE/g) and iridoids (up to 40.8 ± 2.9 mg AE/g). The species were compared using HPLC-DAD-MS/MS, revealing some key differences in the phytochemical makeup of the extracts. The most abundant compound in the extracts of Galium verum blossoms and herb was found to be asperuloside, in Galium aparine herb, asperulosidic acid, and in Galium mollugo herb, chlorogenic acid. Additionally, the composition of volatile compounds was analysed by SPME-GC-MS. The degree of variability between the samples was high, but three volatiles, hexanal, anethole, and β-caryophyllene, were quantified (≥1%) in all analysed samples. The antioxidative activity of all extracts was evaluated using the ORAC_FL method, demonstrating that the Galium species from Estonia all exhibit strong antioxidant capacity (up to 9.3 ± 1.2 mg TE/g). Out of the extracts studied, Galium verum blossoms contained the highest amounts of bioactives and had the strongest antioxidant capacity.

Lyme disease, caused by Borrelia burgdorferi sensu lato infection, is the most widespread vector-borne illness in the Northern Hemisphere. Unfortunately, using targeted antibiotic therapy is often an ineffective cure. The antibiotic resistance and recurring symptoms of Lyme disease are associated with the formation of biofilm-like aggregates of B. burgdorferi. Plant extracts could provide an effective alternative solution as many of them exhibit antibacterial or biofilm inhibiting activities. This study demonstrates the therapeutic potential of Plantago major and Plantago lanceolata as B. burgdorferi inhibitors. Hydroalcoholic extracts from three different samples of each plant were first characterised based on their total concentrations of polyphenolics, flavonoids, iridoids, and antioxidant capacity. Both plants contained substantial amounts of named phytochemicals and showed considerable antioxidant properties. The major non-volatile constituents were then quantified using HPLC-DAD-MS analyses, and volatile constituents were quantified using HS-SPME-GC-MS. The most prevalent non-volatiles were found to be plantamajoside and acteoside, and the most prevalent volatiles were β-caryophyllene, D-limonene, and α-caryophyllene. The B. burgdorferi inhibiting activity of the extracts was tested on stationary-phase B. burgdorferi culture and its biofilm fraction. All extracts showed antibacterial activity, with the most effective lowering the residual bacterial viability down to 15%. Moreover, the extracts prepared from the leaves of each plant additionally demonstrated biofilm inhibiting properties, reducing its formation by 30%.

Lignin is Nature’s major source of aromatic chemistry and is by many seen as the green entry-point alternative to the fossil-based chemical industry. Due to its chemically recalcitrant structure, the utilization of lignin is challenging, wherein enzymes might be the key to overcome this challenge. Here, we focus on the characterization of dye-decolorizing peroxidases from Streptomyces coelicolor A3(2) (ScDyPs) in the context of enzymatic modification of organosolv lignins from aspen and Miscanthus × giganteus. In this study, we show that the ScDyPB can remodel organosolv lignins from grassy biomass, leading to higher molecular weight species, while ScDyPAs can deconstruct hardwood lignin, leading to an overall reduction in its molecular weight. Additionally, we show that ScDyPB is effective in polymerizing low-molecular-weight phenolics, leading to their removal from the solution.

The oleaginous yeast Rhodotorula toruloides is a natural producer of lipids and carotenoids. However, its potential as a producer of extracellular biopolymers remains unexplored. Hence, we aimed to evaluate the R. toruloides CCT0783 for extracellular biopolymer production. We found that the carbon-to-nitrogen ratio influenced exopolysaccharide (EPS) production, reaching 5.84 ± 0.45 g/L under glucose-rich conditions. We characterized the crude biopolymer using FTIR and GC-MS, identifying polysaccharide peaks, wherein EPS consisted of (%) glucose (88.83 ± 4.87), galactose (5.50 ± 1.50), mannose (4.80 ± 1.57), and xylose and arabinose (0.87 ± 0.04) monomers. The dried EPS also contained a fractional presence of protein (1.0%). Interestingly, inorganic, but not organic, nitrogen metabolism was associated with the acidification of the culture environment and simultaneous EPS production. A comparison of cultivation conditions revealed that EPS was produced when metabolic activity contributed to the culture media acidification to a pH of approximately 2. Finally, a comparative bioinformatics analysis allowed us to map the putative EPS biosynthesis and transport pathways, as well as regulators of intracellular pH maintenance. In conclusion, our study demonstrates R. toruloides’ potential as an extracellular microbial biopolymer producer, enabling its consideration for extracellular bioproduction, besides its typically reported intracellular products. IMPORTANCE: Microbial biopolymers have been extensively studied for their impact on the environment and on health. However, developing a biotechnology process for producing such biopolymers remains challenging despite their potential for valuable applications. Considering this opportunity, we investigated the oleaginous yeast Rhodotorula toruloides as a producer of extracellular biopolymers, which, to date, is mostly used as a cell factory for intracellular bioproducts, namely, lipids and carotenoids. Our study identifies the conditions and maps pathways that allow exopolysaccharide (EPS) production in this yeast. These biopolymers, besides highlighting R. toruloides potential for extracellular production, could be deployed in diverse applications, from gelling agents in pharmaceuticals to emulsifiers in the food industry. Furthermore, our comparative bioinformatics analysis provides a foundational resource that could enable the development of Rhodotorula cell factories for extracellular bioproduction.