In the modern digital world, electronic devices are being widely employed for various applications where thermal performance represents a significant technical challenge due to continued miniaturization, high heat generated in the system, and non-uniform high-temperature causing failure. Phase change materials (PCMs) owing to the immense heat of fusion are primarily considered for thermal management, but their insulating properties hedge their applications in electronics cooling. Nano-enhanced phase change materials (NePCMs) have the ability to improve the thermal conductivity of PCM, decrease system temperature and escalate the operating time of devices. Accordingly, the current study focused on the experimental investigations for the thermal performance of three heat sinks (HS) with different configurations such as a simple heat sink (SHS), a square pin-fins heat sink (S_pfHS), and Cu foam integrated heat sink (Cu_fmHS) with various alumina nanoparticles mass concentrations (0.15, 0.20 and 0.25 wt%) incorporated in PCM (RT-54HC) and at heat flux (0.98–2.94 kW/m²). All HSs reduced the base temperature with the insertion of NePCM compared to the empty SHS. The experimental results identified that the thermal performance of Cu_fmHS was found to be superior in reducing base temperature and enhancing working time at two different setpoint temperatures (SPTs). The maximum drop in base temperature was 36.95%, and a 288% maximum working time enhancement was observed for Cu_fmHS. Therefore, NePCMs are highly recommended for the thermal management of the electronic cooling system.

Atmospheric water harvesting (AWH) can provide clean and safe drinking water in remote areas. The present study provides a comprehensive review of adsorption-based AWH by using the scientometric approach. The publication types are mainly composed of articles and reviews, accounting for 75.37% and 11.19% of the total, respectively. Among these publications, ~95.1% were published in English and came from 154 different journals which demonstrates that researchers have shown a great interest in this field. However, much less contribution has been received thus far on this topic from Pakistan. Therefore, this study aims to explore a solar-driven adsorption-based AWH system in terms of varying relative humidity (RH), solar irradiance, and various types of adsorbent materials. Geospatial mapping and Monte Carlo simulations are carried out to integrate the operational parameters of the system and materials with Pakistan’s climatic conditions to forecast the AWH potential (L/m²/d). Probability distribution of 100,000 trials is performed by providing lower, mode, and upper values of the independent parameters. The possible outcomes of the adsorbed volume of water are determined by generating random values for the independent parameters within their specified distribution. It was found that MIL-101 (Cr) achieved the highest water-harvesting rate (WHR) of 0.64 to 3.14 (L/m²/d) across Pakistan, whereas the WHR was lowered to 0.58 to 1.59, 0.83 to 0.94, and 0.45 to 1.26 (L/m²/d) for COF-432, zeolite, and silica gel, respectively. Furthermore, parameter optimization and sensitivity analysis are performed to finalize the boundary conditions of the adsorption-based AWH system by ensuring the maximum volume values within the desired specification limits (1–4 L/m²/d).

Industrial applications often require welded joints of dissimilar metals to perform reliably under adverse working conditions. Such conditions demand high resistance to failure modes, such as fatigue, corrosion, and creep. In applications involving intense vibrational and cyclic loading conditions, high strength-to-weight ratio metals, including aluminum, are more vulnerable to fatigue failure. This study investigates the fatigue strength of base metals and tungsten inert gas welded joints of the two most widely used aluminum alloys, AA7075 and AA2024, under four-point rotating bending. For the comparative study, these dissimilar alloys were joined together by using two different filler rods, AA4047 and AA4043, under similar welding conditions. SN curves for all the samples were generated through the experimental iterations. A comparison of different results shows that welded samples have better fatigue strength than the base metals, while, as a filler, AA4047 has better resistance to fatigue fracture than AA4043.