In present-day mechanized garlic seeding, high missing rates and low qualified percentages of single seeds are common problems; thus, a finger clip plate garlic seed-metering device was designed in this study. First, the structure and working principle of the seed-metering device were studied. Subsequently, the critical component parameters of the seed-metering device were determined using theoretical calculations; then, EDEM software was used in single-factor simulation experiments to analyze the effects of opening the diameter of the seed-collecting spoon, the operating speed of the seeding tray, and the population number on the seed-filling performance. Finally, a Box–Behnken center combination experiment was conducted with the population, opening the diameter of the seed-collecting spoon, and rotating the speed of the seeding tray as experiment factors, with the single-seed filling rate, qualified percent, and missing rate as evaluation indicators. A three-factor and three-level orthogonal test was conducted to establish the mathematic regression model of the experiment factors and evaluation indicators, as well as to realize the parameter optimization. After rounding, the laboratory validation test was carried out with 240~280 seeds, a 26 mm seed scoop-opening diameter, and a 28 r/min operating speed. The average qualified rate, missing rate, and reply rate of single seeds were 91.86%, 2.71%, and 5.43%, respectively, which is basically consistent with the forecast results of regression model.

To improve the problem of low seeding efficiency facing the single-row planting mode traditionally used in China, this study aimed to design a novel three-row pneumatic precision metering device. The working principle and main structure were introduced in the paper. The three main factors affecting the seeding performance comprised of vacuum pressure, angular velocity of the metering tray, and taper angle of the sucking hole. A Box-Behnken experiment design having the qualified index and missed seeding index as the experimental index was used, and the results indicated that optimal performance of the metering device was achieved when the vacuum pressure was 2.16 kPa, the angular velocity of the metering tray was 29.43 rpm, and the taper angle of the sucking hole was 61.51°. The qualified index of the inner, middle, and outer ring was 95.12%, 94.68% and 94.24% respectively, while the missed seeding index of the inner, middle, and outer ring was 3.67%, 3.12% and 2.58% respectively under the optimal combination of parameters. The bench test results were basically consistent with the optimized results. This paper can provide support for the design of a three-row pneumatic precision metering device for Brassica chinensis.