Ultrasonic treatment is effective in deagglomerating and dispersing nanoparticles in various liquids. However, the exact deagglomeration mechanisms vary for different nanoparticle clusters, owing to different particle geometries and inter-particle adhesion forces. Here, the deagglomeration mechanisms and the influence of sonotrode amplitude during ultrasonication of multiwall carbon nanotubes in de-ionized water were studied by a combination of high-speed imaging and numerical modeling. Particle image velocimetry was applied to images with a higher field of view to calculate the average streaming speeds distribution. These data allowed direct comparison with modeling results. For images captured at higher frame rates and magnification, different patterns of deagglomeration were identified and categorized based on different stages of cavitation zone development and for regions inside or outside the cavitation zone. The results obtained and discussed in this paper can also be relevant to a wide range of carbonaceous and other high aspect ratio nanomaterials.
Multiwalled carbon nanotubes (MWCNTs) are decorated with Pt nanoparticles by a “layer-by-layer” approach using poly (sodium 4-styrene sulfonate) (PSS) and poly (diallyl dimethylammonium chloride) (PDDA). Transmission electron microscopy (TEM) images and Energy Dispersive X-ray (EDX) analysis of the samples confirm Pt deposition on surfaces of CNTs. Dispersibility and dispersion stability of MWCNTs in the solvents are enhanced when MWCNTs are coated with Pt nanoparticles. Mg AZ91 composites reinforced with MWCNTs are then produced by a melt stirring process. Compression tests of the composites show that adding 0.05% wt Pt-coated MWCNTs in AZ91 improves the composite’s mechanical properties compared to the pure AZ91 and pristine MWCNT/AZ91. Fracture surface analysis of the composite using a scanning electron microscope (SEM) shows individual pulled out MWCNTs in the case of the Pt-coated MWCNT/AZ91 composites. This finding can be attributed to the uniform dispersion of Pt-coated MWCNTs in Mg due to the improved wettability of Pt-coated MWCNTs in Mg melts. The study of the pull-out behaviour of pristine and Pt-coated CNTs from an Mg matrix using molecular dynamics simulation supports this interpretation.
20 July 2024 in International Journal of Mechanical Sciences
This study investigates the mesoscale deagglomeration mechanisms of multi-walled carbon nanotubes (MWCNTs) in aqueous solutions with and without added surfactant (Triton X-100), using high-speed imaging and numerical simulations. High-speed observations revealed that within the cavitation zone (CZ, defined as the region of high bubble intensity), the addition of surfactant had no obvious effects on deagglomeration behaviour, with most agglomerates remaining intact and only occasional fragmentation events observed. In contrast, in regions outside the CZ, surfactant addition significantly increased the number and stability of microbubble clusters, leading to more frequent interactions with MWCNT agglomerates. Numerical simulations performed under matched experimental conditions confirmed a spatial variation in bubble dynamics, with enhanced microbubble formation and persistence in surfactant-containing solutions, particularly at distances away from the sonotrode. These findings provide direct mechanistic evidence that surfactant not only stabilises dispersed CNTs but also facilitates microbubble-mediated deagglomeration outside the CZ. The results highlight the role of structured bubble activity in extending the effective dispersion region during ultrasonication, offering insight into the optimisation of CNT processing in surfactant-assisted systems.