Contactless ultrasound is a novel, easily implemented, technique for the Ultrasonic Treatment (UST) of liquid metals. Instead of using a vibrating sonotrode probe inside the melt, which leads to contamination, we consider a high AC frequency electromagnetic coil placed close to the metal free surface. The coil induces a rapidly changing Lorentz force, which in turn excites sound waves. To reach the necessary pressure amplitude for cavitation with the minimum electrical energy use, it was found necessary to achieve acoustic resonance in the liquid volume, by finely tuning the coil AC supply frequency. The appearance of cavitation was then detected experimentally with an externally placed ultrasonic microphone and confirmed by the reduction in grain size of the solidified metal. To predict the appearance of various resonant modes numerically, the exact dimensions of the melt volume, the holding crucible, surrounding structures and their sound properties are required. As cavitation progresses the speed of sound in the melt changes, which in practice means resonance becomes intermittent. Given the complexity of the situation, two competing numerical models are used to compute the soundfield. A high order time-domain method focusing on a particular forcing frequency and a Helmholtz frequency domain method scanning the full frequency range of the power supply. A good agreement is achieved between the two methods and experiments which means the optimal setup for the process can be predicted with some accuracy.
A high frequency tuned electromagnetic induction coil is used to induce ultrasonic pressure waves leading to cavitation in alloy melts. This presents an alternative ‘contactless’ approach to conventional immersed probe techniques. The method can potentially offer the same benefits of traditional ultrasonic treatment (UST) such as degassing, microstructure refinement and dispersion of particles, but avoids melt contamination due to probe erosion prevalent in immersed sonotrodes, and it can be used on higher temperature and reactive alloys. An added benefit is that the induction stirring produced by the coil, enables a larger melt treatment volume. Model simulations of the process are conducted using purpose-built software, coupling flow, heat transfer, sound and electromagnetic fields. Modelling results are compared against experiments carried out in a prototype installation. Results indicate strong melt stirring and evidence of cavitation accompanying acoustic resonance. Up to 63% of grain refinement was obtained in commercial purity (CP-Al) aluminium and a further 46% in CP-Al with added Al–5Ti–1B grain refiner.
This article demonstrates, through finite element analysis, the possibility to manufacture sub-30 nm polymeric channels using electrostatic induced lithography. Channels with a width of 25 nm, a depth of 50 nm and an inter-channel wall of 28 nm can be obtained by this patterning process. The influence of operational parameters such as the filling factor, the aspect ratio of the master electrode, the applied voltage and the gap between the two electrodes and initial film thickness has been studied in detail to define the fabrication limits of this process in the case of periodic nanostructures. Conclusions for such nanostructures can be generalised to other shapes manufactured from polymers.
Ultrasonic treatment is effective in deagglomerating and dispersing nanoparticles in various liquids. However, the exact deagglomeration mechanisms vary for different nanoparticle clusters, owing to different particle geometries and inter-particle adhesion forces. Here, the deagglomeration mechanisms and the influence of sonotrode amplitude during ultrasonication of multiwall carbon nanotubes in de-ionized water were studied by a combination of high-speed imaging and numerical modeling. Particle image velocimetry was applied to images with a higher field of view to calculate the average streaming speeds distribution. These data allowed direct comparison with modeling results. For images captured at higher frame rates and magnification, different patterns of deagglomeration were identified and categorized based on different stages of cavitation zone development and for regions inside or outside the cavitation zone. The results obtained and discussed in this paper can also be relevant to a wide range of carbonaceous and other high aspect ratio nanomaterials.