Hydrostatic extrusion, as a quite rarely applied technique, is used for the deformation of the Zr-based metallic glass/porous tungsten phase composite prepared by pressure infiltration. The fracture strength increases from for the as-cast composite to for the as-extruded composite. An apparent work hardening behavior was also observed in the as-extruded composite. The improved mechanical properties of the as-extruded composite are proposed to contribute to the stable interface between the metallic glass phase and the tungsten phase and the high dislocation density of the tungsten phase.
A good quality of SiO2/SiC coating was successfully fabricated on carbon fiber fabric by a novel electrolytic plasma spraying method, where Na2SiO3·9H2O aqueous solution was used as an electrolyte. In this study, we discussed the effect of spraying distance on the coating. The microstructure and composition coating were characterized by scanning electron microscopy with energy-dispersive spectroscopy and XPS, respectively. An effective coating can be easily prepared within several tens of seconds through this approach by adjusting the spraying distance. Results show that the sample oxidation resistance temperature was up to 1000 °C while the spraying distance was 15 mm, and tensile strength increased by 73 MPa after heat treatment at 900 °C for 20 min. The study provides additional insights into the feasibility of modification of carbon fiber fabric. Meanwhile, this method can be expected to extend to the fabrication of other oxide coatings or the modification of the surfaces of other complicated and/or large-scale easily oxidized materials.
24 December 2008 in Journal of Alloys and Compounds
This manuscript reported the synthesis of Al2O3 coating onto quartz fiber fabric by plasma electrolysis spray for enhanced thermal conductivity and stability. The nano- and micro-sized clusters were partially observed on the coating, while most coating was relatively smooth. It was suggested that the formation of a ceramic coating was followed as the nucleation-growth raw, that is, the formation of the coating clusters was dependent on the fast grow-up partially, implying the inhomogeneous energy distribution in the electrolysis plasma. The deposition of the Al2O3 coating increased the tensile strength from 19.2 to 58.1 MPa. The thermal conductivity of the coated quartz fiber was measured to be 1.17 W m−1 K−1, increased by ~45% compared to the bare fiber. The formation mechanism of the Al2O3 coating was preliminarily discussed. The thermally conductive quartz fiber with high thermal stability by plasma electrolysis spray will be widely used in flexible thermal shielding and insulation materials.
The manuscript reported the synthesis of Al2O3 nano-coating onto quartz fiber by plasma electrolysis spray for enhanced thermal conductivity and stability. The nano- and micro-sized clusters were partially observed on the coating, while most coating was relatively smooth. It was suggested that the formation of a ceramic coating was followed as the nucleation-growth raw, that is, the formation of the coating clusters was dependent on the fast grow-up partially, implying the inhomogeneous energy distribution in the electrolysis plasma. The deposition of the Al2O3 coating increased the annealing tensile strength from 19.2 MPa to 58.1 MPa. The thermal conductivity of the coated quartz fiber was measured to be 1.17 W m-1 K-1, increased by ~45% compared to the bare fiber. The formation mechanism of the Al2O3 coating was preliminarily discussed. We believe that the thermally conductive quartz fiber with high thermal stability by plasma electrolysis spray will find a wide range of applications in industries.