SnPb solder was widely used in electronic packaging for aerospace devices due to its high reliability. However, its creep resistance is poor and can be improved by adding alloying elements. The effects of Sb content on the microstructure, tensile, and creep properties of eutectic SnPb solder were investigated. Sb addition effectively improved the mechanical properties of the SnPb solder. When Sb content exceeds 1.7 wt.%, SbSn intermetallic compounds (IMCs) occurred. And increasing the Sb content increased the tensile strength. Furthermore, Sb addition decreased the steady-state creep rate and increased the stress exponent n, suggesting that the creep resistance had been enhanced, which may be attributed to the hindrance of dislocation movement by SbSn IMCs, as well as the reduction in phase boundaries, which consequently reduced grain boundary sliding.
24 August 2020 in Journal of Materials Science: Materials in Electronics
A good quality of SiO2/SiC coating was successfully fabricated on carbon fiber fabric by a novel electrolytic plasma spraying method, where Na2SiO3·9H2O aqueous solution was used as an electrolyte. In this study, we discussed the effect of spraying distance on the coating. The microstructure and composition coating were characterized by scanning electron microscopy with energy-dispersive spectroscopy and XPS, respectively. An effective coating can be easily prepared within several tens of seconds through this approach by adjusting the spraying distance. Results show that the sample oxidation resistance temperature was up to 1000 °C while the spraying distance was 15 mm, and tensile strength increased by 73 MPa after heat treatment at 900 °C for 20 min. The study provides additional insights into the feasibility of modification of carbon fiber fabric. Meanwhile, this method can be expected to extend to the fabrication of other oxide coatings or the modification of the surfaces of other complicated and/or large-scale easily oxidized materials.
This manuscript reported the synthesis of Al2O3 coating onto quartz fiber fabric by plasma electrolysis spray for enhanced thermal conductivity and stability. The nano- and micro-sized clusters were partially observed on the coating, while most coating was relatively smooth. It was suggested that the formation of a ceramic coating was followed as the nucleation-growth raw, that is, the formation of the coating clusters was dependent on the fast grow-up partially, implying the inhomogeneous energy distribution in the electrolysis plasma. The deposition of the Al2O3 coating increased the tensile strength from 19.2 to 58.1 MPa. The thermal conductivity of the coated quartz fiber was measured to be 1.17 W m−1 K−1, increased by ~45% compared to the bare fiber. The formation mechanism of the Al2O3 coating was preliminarily discussed. The thermally conductive quartz fiber with high thermal stability by plasma electrolysis spray will be widely used in flexible thermal shielding and insulation materials.
In this study, electroless nickel plating and electrodeposition were used to deposit thin films on the polymer lattice template prepared by 3D printing, then seven Octet hollow nickel lattice materials with different structural parameters were synthesized by etching process at the expense of the polymer backbone. The microstructure and properties of the Octet structure nickel lattice were characterized by X-ray diffraction, Electron backscattering diffraction and transmission electron microscopy. According to the results, the average grain size of the electrodeposition Ni lattice material was 429 nm, and (001) weak texture was found along the direction of the film deposition. The lattice deformation mode changed with the increase of the lattice length-to-diameter ratio, and it shifted from the lattice deformation layer-by-layer and the overall deformation to the shear deformation in the 45° direction. The strength, modulus and energy absorption properties of the Octet lattice increased with the density, and they were exponentially related to density. In the relative density range of 0.7~5%, Octet hollow Ni lattices with the same density conditions but different structural parameters showed similar compressive strength and elasticity modulus; the energy absorption capacity, however, was weakened as the length-to-diameter ratio increased.
1 December 2014 in Surface and Coatings Technology