A series of polyimide/AlN composite films and polyimide/AlN/BN composite films with different contents were prepared by using polyimide as organic matrix, AlN and BN as inorganic fillers. The filling of the ALN + BN particles increases the dielectric constant, the breakdown strength, and the thermal conductivity of the film. After filling in 9 vol% AlN content, the thermal conductivity of the polyimide/AlN composite film was 0.675 W/(m·K), which was three times that of the pure PI film. The PI/AlN/BN composite film had a thermal conductivity of 0.711 W/(m·K) when the content of AlN and BN was 3 vol% and 6 vol%, When the inorganic packing particles are 3%, the tensile strength loss is small and the breakdown strength is increased to 180 kV/mm. The SEM image of PI film showed that when different contents of AlN particles were added to the matrix, whitening phenomenon may occur due to poor interface bonding ability, and the problem was improved after KH560 modification. The result showed that two fillers with different particle sizes formed a close-packing, which was beneficial to increase the number of thermal conduction paths, thereby improving the thermal conductivity. Overall, this paper prepared a series of PI thin films with high thermal conductivity and high insulation.
28 October 2021 in Journal of Materials Science: Materials in Electronics
Bismaleimide (BMI) resin has great potential in aerospace, electronic, and machinery fields due to its extraordinary thermal stability. Owing to BMI’s lower impact strength, various modified BMI resins have been prepared using CTBN, PEEK, fillers, and hyperbranched polymer to achieve higher impact strength. However, enhancement of toughness causes deterioration of other performance, such as Tg, thermal stability, and brittleness. In this work, BMI resin modified by hyperbranched polyimide (HBPI) was obtained. HBPI designed with flexible segments, unsaturated bonds, and a low degree of branching was synthesized. FT-IR and 13C-NMR were applied to confirm the successful fabrication of HBPI. The mechanical strength and dielectric properties of cured BMI resin containing various levels of HBPI were analyzed systematically. The impact and bending strength were improved significantly with increased HBPI content. When the content of HBPI is 40 wt.%, the impact strength and bending strength reach the maximum value of 32 kJ/mm and 88 MPa. In addition, the BMI cured with HBPI exhibits enhanced bending modulus to the value of 5.9 GPa. Furthermore, the dielectric strength of cured resin was improved to 28.3 kV/mm. The improved mechanical strength and enhanced dielectric properties are attributed to the increasing free volume induced by HBPI. These results indicate the promise of BMI resin modified by HBPI applied in insulating coatings and low dielectric laminates used in high frequency.
In this paper, the effect of field strength on the corona-resistant lifespan of a composite film and the effect of doping on the dielectric properties of the composite film were studied. The method for predicting corona-resistant lifespan under working electric field strength is discussed. Scanning electron microscopy (SEM) was used to characterize the morphology and the structure of the composite film near the breakdown point after corona formation. Fourier transform infrared spectroscopy (FT-IR) was used to characterize the imidiated film, and a conductivity current test was used to calculate the electrical aging threshold of the film. The results showed that the introduction of nano-SiO2 particles could greatly improve the corona-resistant lifespan of the material. At 155 °C, when the applied external electric field strength was extrapolated to 20 kV/mm, the corona-resistant lifespan of the PI/nano-SiO2 three-layer composite film with 10 wt% nano-particle doping was 7472.61 h.