Jing Liu

Dr. Jing Liu


Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
16 May 2022 in Gels
Verified
Journal Article
Open access
PDF file
ZZZixuan Zheng
Zixuan Zheng
GLGuojie Liang
Guojie Liang
LLLi Li
Li Li
JLJing Liu
Jing Liu
XWXinbo Wang
Xinbo Wang
KLKai Li
Kai Li
The weak inherent non-covalent interactions between carbon aerogel backbone nanoparticles obtained by the pyrolysis of conventional organic aerogel can lead to poor mechanical properties. When applied in the thermal protection system of a high-speed spacecraft, the preparation of carbon aerogel insulation materials with excellent formability and high mechanical strength still remains a huge challenge. This work reports an efficient approach for fabricating carbon foam-reinforced carbon aerogel composites by compounding the nanoporous polyimide aerogel into the microporous pre-carbonized phenolic resin-based carbon foam via vacuum impregnation, gelatinizing and co-carbonization. Benefiting from the co-shrinkage caused by co−carbonization, the thermal insulation capacity of the carbon aerogel and the formability of the pre−carbonized foam are efficiently utilized. The shrinkage, density and carbon yield of aerogels, pre-carbonized foams and the composites at different temperatures were measured to analyze the formation of the interfacial gap within the composite. The co-carbonization mechanism of the polyimide aerogels and phenolic resin-based pre-carbonized foams was analyzed through XPS, TG-MS, and FT-IR. Among the prepared samples, CF30-CPI-1000 °C with small interfacial gaps showed the lowest thermal conductivity, which was as low as 0.56 W/(m·K) at 1900 °C, and the corresponding compressive strength and elastic modulus were as high as 0.532 MPa and 9.091 MPa, respectively.

18 January 2025 in Journal of Hazardous Materials
Verified
Journal Article
Closed access
YXYan Xiang
Yan Xiang
ZWZhoujie Wang
Zhoujie Wang
JLJing Liu
Jing Liu
ZLZhikao Li
Zhikao Li
JWJingyi Wang
Jingyi Wang
Lei XieLei Xie
Lei Xie

25 December 2024 in Journal of Colloid and Interface Science
Verified
Journal Article
Closed access
YXYan Xiang
Yan Xiang
ZWZhoujie Wang
Zhoujie Wang
YZYue Zhao
Yue Zhao
JLJing Liu
Jing Liu
JWJinyi Wang
Jinyi Wang
Lei XieLei Xie
Lei Xie

25 February 2022 in Processes
Verified
Journal Article
Open access
PDF file
HDHaolin Du
Haolin Du
ZLZenghe Li
Zenghe Li
HLHeguo Li
Heguo Li
Yue ZhaoYue Zhao
Yue Zhao
XLXiaopeng Li
Xiaopeng Li
ZJZuohui Ji
Zuohui Ji
Chemical warfare agents (CWA) can poison people through the skin and cause injury, and the use of chemical protective clothing (CPC) is an important way to protect personnel from injury. CPC performance strongly depends on chemical protective materials, and satisfactory protective materials must meet various requirements, including protective performance, physiological comfort, mechanical performance, and cost effectiveness. Here, low-cost materials were used to prepare PVDF sodium sulfonate composite membranes with different contents of modified graphene oxide (GO-SSS). Their tensile properties, contact angle, permeability, and selectivity were tested and analyzed. The results show that when the addition ratio of GO-SSS to the bare membrane is 0.5%, the composite membrane has desirable permeation selectivity of water vapor/CWA simulant vapor and desirable mechanical properties. Hence, our sodium sulfonate composite membrane of PVDF with GO-SSS is an ideal material for potential applications in CPC.