This paper presents a new family of Class-AB operational transconductance amplifier (OTA) circuits based on single-stage topologies with non-linear current amplifiers. The proposed variable-mirror amplifier (VMA) architecture is mainly characterized by generating all Class-AB current in the output transistors only, by exhibiting very low sensitivity to both technology and temperature deviations, and by avoiding the need for any internal frequency-compensation mechanism. Hence, this family of OTAs is well-suited for low-power switched-capacitor circuits and specifically optimized for switched-OpAmp fast on-off operation and multi-decade load-capacitance specifications. Analytical expressions valid in all regions of operation are presented to minimize VMA settling time in discrete-time circuits. Also, a complete OTA design example integrated in 0.18 μm 1P6M MiM 1.8 V CMOS technology is supplied with detailed simulation and experimental results. Compared to resistor-free state-of-art Class-AB OpAmp and OTA literature, the proposed architecture returns the highest measured figure-of-merit value.

A 2-D wind sensor, based on microelectromechanical systems (MEMS) flow sensors, is presented. The device consists of a cylinder with a channel network connecting the internal flow sensors with the lateral surface. The pressure distribution developed by the wind on the cylinder's surface is thus converted into two air flows from which, due to the special channel configuration, wind speed and direction can be unequivocally determined. Since the MEMS devices are located in the channels, their fragile sensing structures are protected from direct exposure to the wind. Performance estimation based on literature data of pressure distributions indicates that the approach is applicable to a wide wind velocity range. The feasibility of the idea is supported by measurements performed on a prototype.

A compact, low power interface for capacitive sensors, is described. The output signal is a pulse width modulated (PWM) signal, where the pulse duration is linearly proportional to the sensor differential capacitance. The original conversion approach consists in stimulating the sensor capacitor with a triangular-like voltage waveform in order to obtain a square-like current waveform, which is subsequently demodulated and integrated over a clock period. The charge obtained in this way is then converted into the output pulse duration by an approach that includes an intrinsic tunable low pass function. The main non idealities are thoroughly investigated in order to provide useful design indications and evaluate the actual potentialities of the proposed circuit. The theoretical predictions are compared with experimental results obtained with a prototype, designed and fabricated using 0.32 μm CMOS devices from the BCD6s process of STMicroelectroncs. The prototype occupies a total area of 1025× 515 mm² and is marked by a power consuption of 84 μW. The input capacitance range is 0-256 fF, with a resolution of 0.8 fF and a temperature sensitivity of 300 ppm/°C.

A single-chip smart flow sensor based on a thermal principle is presented. The device is fabricated through a commercial complementary metal-oxide-semiconductor (CMOS) process combined with a postprocessing procedure. A configurable electronic interface performing signal reading and nonideality compensation is integrated with the sensing structures on the same chip. The interface implements recently proposed approaches to offset and pressure effect compensation. Detailed experimental results are presented demonstrating correct operation of the proposed microsystem.