A compact tri-band, low profile, and lightweight antenna is proposed for 2.4/5 GHz WLAN and Ku-band applications. The antenna geometry was a radiating rectangular patch surrounded by a wide circular slot with an inverted-L strip connected to one side of the slot. It was mounted on a copper layer of a single side FR4 substrate with a dielectric constant of 4.3 and a height of 1.6 mm. It was fed by a 50-Ω coplanar waveguide. This design was very compact (40 × 40 × 1.6 mm3). Simulated and actual measurements of an antenna setup in the laboratory verified that the antenna’s bidirectional radiation pattern completely covered the three transmission bands: 2.4–2.485 GHz, 5.15–5.825 GHz and 13.4–17.7 GHz with less than 10-dB return loss and maximum gains of 2.35 dBi, 4.41 dBi and 4.71 dBi, respectively. Wireless communication for the self-navigated vehicle, for one example, is fully supported by this single antenna.
This paper proposes the implementation of and experimentation with GPR for real-time automatic detection of buried IEDs. GPR, consisting of hardware and software, was implemented. A UWB antenna was designed and implemented, particularly for the operation of the GPR. The experiments were conducted in order to demonstrate the real-time automatic detection of buried IEDs using GPR with an R-CNN algorithm. In the experiments, the GPR was mounted on a pickup truck and a maintenance train in order to find the IEDs buried under a road and a railway, respectively. B-scan images were collected using the implemented GPR. R-CNN-based detection for the hyperbolic pattern, which indicates the buried IED, was performed along with pre-processing, for example, using zero offset removal, and background removal and filtering. Experimental results in terms of detecting the hyperbolic pattern in B-scan images were shown and verified that the proposed GPR system is superior to the conventional one using region analysis processing-based detection. Results also showed that pre-processing is required in order to improve and/or clean the hyperbolic pattern before detection. The GPR can automatically detect IEDs buried under roads and railways in real time by detecting the hyperbolic pattern appearing in the collected B-scan image.
This research presents a far-field (FF) antenna with near-field communication (NFC) capability for 3G/4G/LTE mobile devices. The integrated far-and near-field communication (FNFC) antenna was fabricated using conductive silver ink on polyethylene terephthalate (PET) flexible substrate. The FF segment of the antenna is operable in the frequency range of 1.8-2.1 GHz, and the NFC antenna is of dual loop and operable at 13.56 MHz. In the antenna realization, simulations were performed and, to validate, an antenna prototype was fabricated. The experimental results revealed that the FF antenna achieved an impedance bandwidth of 37% (1.52-2.21 GHz), given |S11| of less than -6 dB, with the minimum and maximum efficiency of 92.1% and 98%. The experimental gains are 1.76-2.08 dBi across the target operating frequency band, with near-omnidirectional radiation pattern. The simulation and experimental results are in good agreement. Moreover, the FNFC antenna achieves strong magnetic field distributions in Hx, Hy, and Hz orientations and holds promising potential for 3G/4G/LTE applications.
28 April 2016 in International Journal of RF and Microwave Computer-Aided Engineering
This paper presents a rectifying antenna (rectenna) which can harvest the wireless power at 2.45 GHz band. The proposed antenna is designed to convert the wireless RF signal into DC power. The antenna structure consists of four printed dipoles located perpendicularly to one another to combine the pattern and increase the gain. The compact antenna radiates unidirectional pattern with the high gain. The rectifying circuit part is designed based on voltage diode with stub matching circuit.