weiping LUO

Dr. weiping LUO

Beijing Jiaotong University, Beijing, China
orcid

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 February 2019 in Journal of Performance of Constructed Facilities
Verified
Journal Article
Closed access
Da Long JinDa Long Jin
Da Long Jin
Dajun YuanDajun Yuan
Dajun Yuan
SLShuya Liu
Shuya Liu
XLXinggao Li
Xinggao Li
WLweiping LUO
weiping LUO
With the extending of existing networks of metro systems, existing subway tunnels are more and more commonly undercrossed by new underground tunnels. Excessive deformation and even damage may occur in existing subway tunnels due to the influence of new tunnel construction. This paper studies a case of two existing subway tunnels undercrossed by four closely spaced tunnels in Shenzhen. The displacement of the existing tunnels, the soil pressure, and the bending moment of the new tunnels are monitored. Considering the multiple soil disturbance, a three-dimensional numerical model is established for the analysis of tunnel settlement induced by multiundercrossing. The calculation results match well with the measured tunnel settlement data and the accuracy of proposed numerical approach is verified. Compared with the vertical displacement of the existing tunnels, the horizontal displacement is less affected by new tunnel construction underneath. The vertical displacement profile of the existing tunnels displays V, U, and W shapes, and the position of maximum displacement always shifts toward the new shield tunnel. Affected by the expansion of the disturbed area in the soil, the construction of two or more tunnels close to each other will lead to the increase of the bending moment of the new tunnels themselves.

12 March 2021 in KSCE Journal of Civil Engineering
Verified
Journal Article
Open access
PDF file
PLPing Lu
Ping Lu
Dajun YuanDajun Yuan
Dajun Yuan
JCJian Chen
Jian Chen
Da Long JinDa Long Jin
Da Long Jin
JWJun Wu
Jun Wu
WLweiping LUO
weiping LUO
When shield tunneling in rock-soil interface (RSI) mixed ground, maintaining the stability of the tunnel face is very challenging. This study aims at the investigation of the face stability of slurry shield tunnels in RSI mixed ground. A new apparatus was developed to simulate pressurized slurry supporting the tunnel face in centrifuge tests. The progressive failure of the tunnel face was triggered with slow decrease of slurry pressure. With two equivalent model tunnels of circular shape and semicircular shape, the variations of soil (water) pressure and the displacement field in front of the tunnel can be obtained simultaneously. The face failure was found to be a local collapse in the upper soil layer. The limit support pressure was picked out at the sudden change of the measured soil or water pressures. Then the classical wedge-prism model was introduced and modified to calculate the limit support pressure for slurry shield tunnels in RSI mixed ground considering the partial collapse. Numerical analysis was applied to verify the theoretical analysis and sensitivity analysis was performed to estimate the influence of different parameters on the theoretical solutions.

1 August 2021 in Frontiers of Structural and Civil Engineering
Verified
Journal Article
Closed access
PDF file
DYDajun Yuan
Dajun Yuan
WLweiping LUO
weiping LUO
DJDalong Jin
Dalong Jin
PLPing Lu
Ping Lu

7 June 2022 in Applied Sciences
Verified
Journal Article
Open access
PDF file
WLweiping LUO
weiping LUO
Dajun YuanDajun Yuan
Dajun Yuan
Da Long JinDa Long Jin
Da Long Jin
PLPing Lu
Ping Lu
JCJian Chen
Jian Chen
GYGongbiao Yang
Gongbiao Yang
To investigate the ground deformation induced by the variation of excess/insufficient support pressure in water-rich sandy soil, a series of centrifuge tests in tunnels located at cover over diameter (C/D) ratios equal to 0.5, 1.0 and 1.5 were carried out. The soil pressure, pore pressure, maximum surface displacement and the ground movement induced by reduced/increased support pressure were investigated. The results show that when the burial depth is large (≥1.5 D), the ground deformation caused by the support pressure is difficult to extend to the surface. When the burial depth is shallow (<1.5 D), the ground disturbance range induced by excess support pressure is approximately fishtail-shaped while it is approximately chimney-shaped induced by insufficient support pressure. For the former, the surface disturbance range can extend horizontally to about twice the buried depth beyond the front of the face and the maximum heave occurred at a distance of approximately buried depth beyond the front of the excavation face. For the latter, the surface disturbance range can extend horizontally to about buried depth beyond the front of the face which was larger than that in dry sandy soil. Based on the centrifuge test, the ground deformation mechanism was analyzed compared with previous studies and a supporting pressure control coefficient was proposed to conduct quantitative analysis of surface displacement induced by support pressure. Finally, the control of support pressure based on the surface displacement was discussed to provide some advice for practical engineering.

24 June 2022 in Applied Sciences
Verified
Journal Article
Open access
PDF file
PLPing Lu
Ping Lu
Dajun YuanDajun Yuan
Dajun Yuan
WLweiping LUO
weiping LUO
Da Long JinDa Long Jin
Da Long Jin
MLMinggao Liu
Minggao Liu
To investigate the mechanical characteristics of shield tunnels when openings are made for the construction of cross passages, a series of centrifugal model tests were conducted. The segmental features of the shield tunnel were simulated in the tests, and the influence of different types of openings, namely, rectangular opening, small circular opening, and big circular opening was compared. External earth pressures, structural deformations, dislocations, and structural stresses were monitored during the tests, while the influence of different buried depths was also investigated. The results show that (1) soil arching effect occurred in the overlying soil due to the deformation of the tunnel, and the earth pressure reduction coefficients can guide the tunnel structural design; (2) vertical deformations of the main tunnel and the dislocations between adjacent rings increased with the opening sizes significantly; (3) significant stress concentration occurred close to the openings, and the compressive stress at the inner surface may even exceed the limit strength of the concrete. In summary, the adverse responses of the tunnel increased with the increase of the buried depth and the opening size. Targeted measures should be taken, such as temporary support, longitudinal connections, and high-strength materials near the openings.

1 January 2025 in Canadian Geotechnical Journal
Verified
Journal Article
Closed access
DJDalong Jin
Dalong Jin
WLweiping LUO
weiping LUO
DYDajun Yuan
Dajun Yuan
LXLujiu Xiang
Lujiu Xiang
JSJicheng Shu
Jicheng Shu
With the widespread application of shield tunneling method in tunnel construction, ensuring the stability of tunnel faces has become increasingly critical. This study develops an innovative three-dimensional failure model for shield tunneling, which integrates an “ellipsoid” and a “logarithmic spiral”. To account for the soil arching effect induced by stress redistribution during tunnel excavation, the model incorporates a curved large principal stress trace. A novel mechanism for the progressive evolution of the failure zone is achieved through the dynamic growth of the ellipsoid, capturing the intricate relationships among excavation-induced soil loss, the height of the loose zone, and the support pressure. Based on the limit equilibrium method and slice discretization technique, a support pressure formula is given to estimate the face stability. Results reveal a three-stage evolution of support pressure: initial decrease, gradual increase, and eventual stabilization as the loose zone expands. Validated through theoretical solutions, model experiments, and sensitivity analysis, this study provides theoretical guidance for tunnel face stability control, reducing risks of excessive deformation or collapse due to over-excavation.