Xinggao Li

Prof. Xinggao Li

Beijing Jiaotong University, Key Laboratory of Urban Underground Engineering of Ministry of Education
orcid

Research Focus & Metrics

Academic Career Length

18Years (2009-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 April 2012 in Journal of Construction Engineering and Management
Verified
Journal Article
Closed access
XLXinggao Li
Xinggao Li
XCXiangsheng Chen
Xiangsheng Chen
Grouting control of shield tunneling is of paramount importance to reduce settlements of existing tunnels below-passed by shield tunneling along a curved alignment and in crowded urban areas. The methodology and scheme of the grouting control of shield tunneling is illustrated taking the first Earth Pressure Balanced (EPB) shield below-crossing existing interval tunnels from Kexueguan station to Dajuyuan station of the Shenzhen metro line No. 1, for example. A combination methodology of the “observational method” and the “predefined design method” was set up to deal with parameters concerning the grouting control of shield tunneling. Some parameters of the grouting control were predefined or suggested before the below-crossing, and other parameters might be adjusted during construction on the basis of the “observational method.” The scheme primarily consists of preparation work before the below-crossing, automatic motoring system used in operation tunnels, simultaneous backfilling grouting and gro...

18 August 2023 in Engineering Failure Analysis
Verified
Journal Article
Closed access
HLHanyuan Li
Hanyuan Li
XLXinggao Li
Xinggao Li
HLHao Liu
Hao Liu

1 February 2019 in Journal of Performance of Constructed Facilities
Verified
Journal Article
Closed access
Da Long JinDa Long Jin
Da Long Jin
Dajun YuanDajun Yuan
Dajun Yuan
SLShuya Liu
Shuya Liu
XLXinggao Li
Xinggao Li
WLweiping LUO
weiping LUO
With the extending of existing networks of metro systems, existing subway tunnels are more and more commonly undercrossed by new underground tunnels. Excessive deformation and even damage may occur in existing subway tunnels due to the influence of new tunnel construction. This paper studies a case of two existing subway tunnels undercrossed by four closely spaced tunnels in Shenzhen. The displacement of the existing tunnels, the soil pressure, and the bending moment of the new tunnels are monitored. Considering the multiple soil disturbance, a three-dimensional numerical model is established for the analysis of tunnel settlement induced by multiundercrossing. The calculation results match well with the measured tunnel settlement data and the accuracy of proposed numerical approach is verified. Compared with the vertical displacement of the existing tunnels, the horizontal displacement is less affected by new tunnel construction underneath. The vertical displacement profile of the existing tunnels displays V, U, and W shapes, and the position of maximum displacement always shifts toward the new shield tunnel. Affected by the expansion of the disturbed area in the soil, the construction of two or more tunnels close to each other will lead to the increase of the bending moment of the new tunnels themselves.

28 April 2020 in KSCE Journal of Civil Engineering
Verified
Journal Article
Open access
PDF file
YYYi Yang
Yi Yang
XLXinggao Li
Xinggao Li
WSWei-Lin Su
Wei-Lin Su
The rheological properties of sands conditioned with different conditioners and injection ratios were examined. The conditioned sands were prepared with a 40% and 60% volume injection ratio of a bentonite slurry or a carboxymethyl cellulose (CMC) solution. The experiment results show that the tested bentonite-conditioned sand exhibits the characteristics of a Herschel-Bulkley fluid at shear rates in the range of 0–10 s−1 while the CMC-conditioned sand conforms to the power law model. The flow curves of all of the samples show a marked shear-thinning behavior. They also indicated that the existence of a yield stress (τ0) depends only on the rheological behavior of the conditioner and that the yield stress (τ0 if present) and the plastic viscosity (μp) increase with an increase in the volumetric concentration of the sand. Furthermore, to characterize the thixotropy of the conditioned sand, experiments were carried out by using three loading histories with shear rate accelerations of 0.1, 0.2 and 0.4 s−1/s. In the measured results, the thixotropy of the conditioned sand is heavily dependent on the recent flow history. Based on the experimental data, a simple thixotropic prediction model was developed to analyze and predict the transient flow curves of bentonite-conditioned sands.

1 September 2021 in Engineering Failure Analysis
Verified
Journal Article
Closed access
XLXinggao Li
Xinggao Li
DYDajun Yuan
Dajun Yuan
XJXingqi Jiang
Xingqi Jiang
FWFei Wang
Fei Wang

22 March 2022 in Applied Sciences
Verified
Journal Article
Open access
PDF file
HLHanyuan Li
Hanyuan Li
XLXinggao Li
Xinggao Li
YYYi Yang
Yi Yang
YLYang Liu
Yang Liu
MMMingzhe Ma
Mingzhe Ma
Fault dislocation severely threatens the safety of a tunnel structure. Formerly, researchers mainly engaged in the mechanical response of mountain tunnels crossing the fault fracture zone. In contrast, few studies have focused on the structural stress characteristics and joint deformation of the cross-fault shield tunnels. There is an apparent difference between segmental tunnels and mountain tunnels with respect to mechanical properties. In the current study, a three-dimensional numerical model of cross-fault segmental tunnels is established based on the theory of concrete plastic damage constitutive relations using the finite element program ABAQUS. The numerical calculation results are compared with the model test results for validation. Subsequently, the relevant factors affecting the mechanical response of the shield tunnel crossing the active fault are analyzed. The results illustrate that when normal fault dislocation occurs, the shield tunnel structure is initially damaged appearing in the circumferential joints, which is prone to large tension deformation. Otherwise, when reverse faulting occurs by the same displacement, the shield tunnel structure is initially damaged at the arch haunch of the segments, and the deformation of the longitudinal joints is relatively slight. Under the same fault displacement, the bearing capacity of the segmental lining subjected to the reverse fault dislocation is more significant than that of the normal fault dislocation. Both the soil elastic modulus and the vertical distance between the top of the fault and the tunnel exert a considerable impact on the structural damage of the segmental tunnels, bolt stress, and joint deformation. The fault dip angle does not affect the mechanical characteristics of the shield tunnel structure when subjected to normal fault displacement. In reverse faulting cases, with the increase of the fault dip angle, the tunnel structural failure mode transforms from the transverse compression failure of the segments to the shear failure of the circumferential joints.