Due to its absorption properties in atmosphere, the mid-infrared (mid-IR) region has gained interest for its potential to provide high data capacity in free-space optical (FSO) communications. Here, we experimentally demonstrate wavelength-division-multiplexing (WDM) and mode-division-multiplexing (MDM) in a ~0.5 m mid-IR FSO link. We multiplex three ~3.4 μm wavelengths (3.396 μm, 3.397 μm, and 3.398 μm) on a single polarization, with each wavelength carrying two orbital-angular-momentum (OAM) beams. As each beam carries 50-Gbit/s quadrature-phase-shift-keying data, a total capacity of 300 Gbit/s is achieved. The WDM channels are generated and detected in the near-IR (C-band). They are converted to mid-IR and converted back to C-band through the difference frequency generation nonlinear processes. We estimate that the system penalties at a bit error rate near the forward error correction threshold include the following: (i) the wavelength conversions induce ~2 dB optical signal-to-noise ratio (OSNR) penalty, (ii) WDM induces ~1 dB OSNR penalty, and (iii) MDM induces ~0.5 dB OSNR penalty. These results show the potential of using multiplexing to achieve a ~30X increase in data capacity for a mid-IR FSO link.
In free-space optical communications that use both amplitude and phase data modulation (for example, in quadrature amplitude modulation (QAM)), the data are typically recovered by mixing a Gaussian local oscillator with a received Gaussian data beam. However, atmospheric turbulence can induce power coupling from the transmitted Gaussian mode to higher-order modes, resulting in a significantly degraded mixing efficiency and system performance. Here, we use a pilot-assisted self-coherent detection approach to overcome this problem. Specifically, we transmit both a Gaussian data beam and a frequency-offset Gaussian pilot tone beam such that both beams experience similar turbulence and modal coupling. Subsequently, a photodetector mixes all corresponding pairs of the beams’ modes. During mixing, a conjugate of the turbulence-induced modal coupling is generated and compensates the modal coupling experienced by the data, and thus the corresponding modes of the pilot and data mix efficiently. We demonstrate a 12 Gbit s−1 16-QAM polarization-multiplexed free-space optical link that is resistant to turbulence.
Atmospheric turbulence can cause critical problems in many applications. To effectively avoid or mitigate turbulence, knowledge of turbulence strength at various distances could be of immense value. Due to light-matter interaction, optical beams can probe longitudinal turbulence changes. Unfortunately, previous approaches tended to be limited to relatively short distances or large transceivers. Here, we explore turbulence probing utilizing multiple sequentially transmitted longitudinally structured beams. Each beam is composed of Bessel-Gaussian ( $${{{{{{\rm{BG}}}}}}}_{{{{{{\mathcal{l}}}}}}{{=}}0,{k}_{z}}$$ ) modes with different $${k}_{z}$$ values such that a distance-varying beam width is produced, which results in a distance- and turbulence-dependent modal coupling to $${{{{{\mathcal{l}}}}}}{{{{{\mathscr{\ne }}}}}}0$$ orders. Our simulation shows that this approach has relatively uniform and low errors (<0.3 dB) over a 10-km path with up to 30-dB turbulence-structure-constant variation. We experimentally demonstrate this approach for two emulated turbulence regions (~15-dB variation) with <0.8-dB errors. Compared to previous techniques, our approach can potentially probe longer distances or require smaller transceivers.
Structured electromagnetic (EM) waves have been explored in various frequency regimes to enhance the capacity of communication systems by multiplexing multiple co-propagating beams with mutually orthogonal spatial modal structures (i.e., mode-division multiplexing). Such structured EM waves include beams carrying orbital angular momentum (OAM). An area of increased recent interest is the use of terahertz (THz) beams for free-space communications, which tends to have: (a) larger bandwidth and lower beam divergence than millimeter-waves, and (b) lower interaction with matter conditions than optical waves. Here, we explore the multiplexing of THz OAM beams for high-capacity communications. Specifically, we experimentally demonstrate communication systems with two multiplexed THz OAM beams at a carrier frequency of 0.3 THz. We achieve a 60-Gbit/s quadrature-phase-shift-keying (QPSK) and a 24-Gbit/s 16 quadrature amplitude modulation (16-QAM) data transmission with bit-error rates below 3.8 × 10−3. In addition, to show the compatibility of different multiplexing approaches (e.g., polarization-, frequency-, and mode-division multiplexing), we demonstrate an 80-Gbit/s QPSK THz communication link by multiplexing 8 data channels at 2 polarizations, 2 frequencies, and 2 OAM modes.
In this paper, we experimentally demonstrate the mitigation of atmospheric turbulence effects using phase patterns that apply the inverse transmission matrix for pre-compensation in the 200-Gbit/s free-space orbital angular momentum (OAM) multiplexed optical link. In this link, two OAM channels are multiplexed, each carrying a 100-Gbit/s quadrature-phase shift keying (QPSK) signal. In the uni-directional (forward) link, a combination of two OAM modes is generated using a designed phase pattern in each of the two channels. After the two channels are multiplexed, each OAM mode will carry the combination of signals from both channels. Such beams could perform the inverse function of turbulence induced crosstalk. We explore the link performances including crosstalk and bit error rate (BER) under 6 different turbulence realizations with a Fried parameter of 1-mm. We find the following: (a) the inter-channel crosstalk is reduced by up to 21 dB; (b) the inter-channel crosstalk is below -10 dB for the 6 turbulence realizations when the compensation is applied; (c) a BER below the FEC limit could be realized for the 6 turbulence realizations with an optical signal-to-noise ratio (OSNR) of 16.8 dB for the uni-directional link with the compensation. Moreover, the post-compensation is also investigated for the two 100-Gbit/s OAM-multiplexed backward channels in the bi-directional link. For the backward channels, the phase patterns are used to mitigate turbulence induced crosstalk at the receiver for backward channels, and the inter-channel crosstalk is reduced by up to 16 dB.
In free-space optical (FSO) communications, there are scenarios (e.g., from a ground station to a drone/airplane) in which: (i) the transmitter (Tx) can have a relatively large aperture whereas the receiver (Rx) aperture should preferably be much smaller, and (ii) the distance between the Tx and Rx can vary such that beam divergence will cause a variation in the recovered signal power. In such cases, transmission using a fundamental Gaussian beam can be significantly degraded due to beam truncation caused by a limited-size Rx aperture. Here, we experimentally demonstrate a 1-Gbit/s on-off keying (OOK) FSO transmission link using a structured “pin-like” beam with a limited-size Rx aperture at various distances. The pin-like beam is generated by passing a Gaussian beam through an “Airy-type” phase pattern in the radial direction. When propagating, this structured beam first narrows and then tends to maintain its narrow beam size over a fairly wide range of distances. In comparison to its Gaussian counterpart, our experimental results show that the pin-like beam has ∼13 to 8 dB less power loss at distances ranging from 0.45 m to 0.8 m with an Rx aperture diameter of 1 mm. Moreover, we simulate the propagation of the pin-like beam and show its relatively lower power loss for a wide distance variation in a longer link (e.g., ∼1 km) with a limited-size Rx aperture. Furthermore, our results show that the pin-like beam can have a wider range of low-power-loss distances than a Gaussian beam that is focused to a given distance.