Metal-organic frameworks (MOFs) are highly crystalline inorganic-organic complexes formed from metal ions or metal clusters and multi-toothed organic ligands. MOFs have great potential for use in antibacterial materials in the biological, environmental, and food antimicrobial fields. They can act as a reservoir of metal ions, releasing them gradually and leading to a sustained antibacterial effect analogous to that proposed for metal oxide nanoparticles (NPs). Herein, UiO-66-NH2 as a type of MOF was first prepared by a facile solvothermal method and then loaded with Ag NPs to form a Ag/UiO-66-NH2 composite and the different materials were synthesized by controlling silver doping amount, which are then applied to an antibacterial test. Works on the synthesis of Ag/UiO-66-NH2 and its antibacterial test were not reported before. The synthesized materials were characterized using the field emission scanning electron microscope (FE-SEM), X-ray diffractometer (XRD), Fourier transform infrared spectroscopy (FT-IR), Brunauer-Emmett-Teller (BET), thermal gravimetric analysis (TGA), and X-ray photoelectron spectroscopy (XPS) techniques. The antibacterial activity of the Ag/UiO-66-NH2 was then assessed against E. coli (gram-negative bacteria) and Staphylococcus aureus (gram-positive bacteria), using the inhibition zone (ZIO) method and optical density (OD) method. The obtained results have shown that the introduction of Ag does not interfere with the crystallization of UiO-66-NH2. The FT-IR spectral profiles recorded for the UiO-66-NH2 samples fabricated under conditions of varying silver ion doping levels are similar to those recorded for UiO-66-NH2. The thermal stability of UiO-66-NH2 containing varying amounts of silver ions was lower than the thermal stability of UiO-66-NH2. However, under these conditions, the specific surface area and pore volume increased. The antibacterial performance of UiO-66-NH2 improved significantly following the process of silver ion doping. The best antibacterial performance was observed when the silver ion content was 4 wt.%. Overall, we synthesized a new nanocomposite material with broad-spectrum bacterial sterilization, which was easy to manufacture.
With the exploring and developing of mineral resources in the Tibet Autonomous Region for many years, a large number of tailings have been produced. A total of 17 tailings samples from borehole cores were collected from different tailings ponds in different regions of Tibet. The results showed that the mineral composition and content of tailings in each research area were different. Among them, quartz was the most abundant mineral in most tailings. The major elements of tailings mainly included Si, Al, Fe, Mg, Mn, Ca, Na, K and so on. S existed in different types of tailings. In the analysis of trace element composition, it was found that the content of some elements had approached the lowest industrial grade, which has potential recycling value, such as Mn, Zn, Pb and P. Through the detection of radioactive elements (Ra-226, Th-232 and K-40), it was shown that there were great differences among different types of tailings, and their different contents would bring potential hazards to the safety of the surrounding environment and human health. Similar results were found in the analysis of particle size characteristics of tailings. These results are of great significance for the future utilization and resource utilization of tailings pond.
It is of great significance to search for efficient, renewable, biodegradable and economical membrane materials. Herein, we developed an organic-inorganic hybrid regenerated cellulose membrane (ZrO2/BCM) with excellent hydrophilic and anti-fouling properties. The membrane was prepared by introducing ZrO2 particles into an N-Methylmorpholine-N-oxide(NMMO)/bamboo cellulose(BC) solution system by the phase inversion method. The physi-chemical structure of the membranes were characterized based on thermal gravimetric analysis (TGA), Fourier transform infrared spectroscopy (ATR-FTIR), field emission scanning electron microscopy (FE-SEM), and X-ray diffraction (XRD). The modified regenerated cellulose membrane has the excellent rejection of bovine serum albumin (BSA) and anti-fouling performance. The membrane flux of ZrO2/BCM is 321.49 (L/m2·h), and the rejection rate of BSA is 91.2%. Moreover, the membrane flux recovery rate after cleaning with deionized water was 90.6%. This new type of separation membrane prepared with green materials holds broad application potential in water purification and wastewater treatment.
In this study, by adding zirconium anhydride (ZrO2) particles to a solution of N–methylmorphorphine–N–oxide (NMMO) and bamboo cellulose (BC), we used interfacial polymerization (IP) to obtain regenerated cellulose nanofiltration membranes (IP–ZrO2/BC–NFMs) that exhibited high water flow and rejection of salts and dyes. During interfacial polymerization, anhydrous piperazine (PIP) was used as the waterborne monomer, and 1,3,5–trimesoyl chloride (TMC) and n–hexane were used as the organic phase. The procedure was adjusted by analyzing the impacts of the concentrations of the water and organic phase monomers and the reaction duration on the performance of the developed IP–ZrO2/BC–NFMs. The chemical structures and morphologies of the as–obtained IP–ZrO2/BC–NFMs were examined using various characterization techniques. The performance of these membranes for removal of inorganic salts and dyes as well as their water flow were investigated. IP–ZrO2/BC–NFMs obtained at a pressure of 0.5 MPa, PIP concentration of 1.5 wt.%, TMC concentration of 0.15 wt.%, and polymerization period of 2 min displayed the highest water flux (55.12 LMH) and the best desalination effect (NaCl rejection rate = 19.15%). Over 90% of both Methyl Blue (MB) and Congo Red (CR) dyes were intercepted. We demonstrated that the addition of ZrO2 to nanofiltration membranes significantly enhanced the water flow of the IP–ZrO2/BC–NFMs as well as the salt ion rejection rate.
The main purpose of this study was to determine the natural radioactivity level of raw radionuclides in the metal tailings of a mine in Lhasa, Tibet, and to conduct sampling and detection in 17 typical metal tailing mines in Lhasa, Tibet. The specific activity concentrations of 226Ra, 232Th, and 40K in the samples were calculated. The total αβχγ radiation, radon concentration, and outdoor absorbed dose rate in the air 1.0 m above the ground were measured. The γ radiation levels affecting miners and their surrounding residents were assessed. The results show that the radiation dose ranges from 0.08 μSv/h to 0.26 μSv/h, and the radon concentration ranges from 10.8 Bq/m3 to 29.6 Bq/m3, which does not exceed the national radiation-related standards, and the environmental hazard risk is low. The specific activity concentration of 226Ra ranged from 8.91 Bq/kg to 94.61 Bq/kg, the specific activity concentration of 232Th ranged from 2.90 Bq/kg to 89.62 Bq/kg, and the specific activity concentration of 40K was less than MDA to 762.89 Bq/kg. The average absorbed dose rate (DO) of the 17 mining areas was 39.82 nGy/h, the average annual effective dose rate (EO) was 0.057 mSv/y. The average external risk index of the 17 mining areas was 0.24, the average internal risk index was 0.34, and the average γ index was 0.31, all of which were less than the maximum permissible limit. This means that the metal tailings from all 17 mining areas were within the limit for γ radiation and, therefore, can be used in bulk as major building materials without posing a significant radiation threat to the residents of the study area.