Metal-organic frameworks (MOFs) are highly crystalline inorganic-organic complexes formed from metal ions or metal clusters and multi-toothed organic ligands. MOFs have great potential for use in antibacterial materials in the biological, environmental, and food antimicrobial fields. They can act as a reservoir of metal ions, releasing them gradually and leading to a sustained antibacterial effect analogous to that proposed for metal oxide nanoparticles (NPs). Herein, UiO-66-NH2 as a type of MOF was first prepared by a facile solvothermal method and then loaded with Ag NPs to form a Ag/UiO-66-NH2 composite and the different materials were synthesized by controlling silver doping amount, which are then applied to an antibacterial test. Works on the synthesis of Ag/UiO-66-NH2 and its antibacterial test were not reported before. The synthesized materials were characterized using the field emission scanning electron microscope (FE-SEM), X-ray diffractometer (XRD), Fourier transform infrared spectroscopy (FT-IR), Brunauer-Emmett-Teller (BET), thermal gravimetric analysis (TGA), and X-ray photoelectron spectroscopy (XPS) techniques. The antibacterial activity of the Ag/UiO-66-NH2 was then assessed against E. coli (gram-negative bacteria) and Staphylococcus aureus (gram-positive bacteria), using the inhibition zone (ZIO) method and optical density (OD) method. The obtained results have shown that the introduction of Ag does not interfere with the crystallization of UiO-66-NH2. The FT-IR spectral profiles recorded for the UiO-66-NH2 samples fabricated under conditions of varying silver ion doping levels are similar to those recorded for UiO-66-NH2. The thermal stability of UiO-66-NH2 containing varying amounts of silver ions was lower than the thermal stability of UiO-66-NH2. However, under these conditions, the specific surface area and pore volume increased. The antibacterial performance of UiO-66-NH2 improved significantly following the process of silver ion doping. The best antibacterial performance was observed when the silver ion content was 4 wt.%. Overall, we synthesized a new nanocomposite material with broad-spectrum bacterial sterilization, which was easy to manufacture.
With the exploring and developing of mineral resources in the Tibet Autonomous Region for many years, a large number of tailings have been produced. A total of 17 tailings samples from borehole cores were collected from different tailings ponds in different regions of Tibet. The results showed that the mineral composition and content of tailings in each research area were different. Among them, quartz was the most abundant mineral in most tailings. The major elements of tailings mainly included Si, Al, Fe, Mg, Mn, Ca, Na, K and so on. S existed in different types of tailings. In the analysis of trace element composition, it was found that the content of some elements had approached the lowest industrial grade, which has potential recycling value, such as Mn, Zn, Pb and P. Through the detection of radioactive elements (Ra-226, Th-232 and K-40), it was shown that there were great differences among different types of tailings, and their different contents would bring potential hazards to the safety of the surrounding environment and human health. Similar results were found in the analysis of particle size characteristics of tailings. These results are of great significance for the future utilization and resource utilization of tailings pond.
It is of great significance to search for efficient, renewable, biodegradable and economical membrane materials. Herein, we developed an organic-inorganic hybrid regenerated cellulose membrane (ZrO2/BCM) with excellent hydrophilic and anti-fouling properties. The membrane was prepared by introducing ZrO2 particles into an N-Methylmorpholine-N-oxide(NMMO)/bamboo cellulose(BC) solution system by the phase inversion method. The physi-chemical structure of the membranes were characterized based on thermal gravimetric analysis (TGA), Fourier transform infrared spectroscopy (ATR-FTIR), field emission scanning electron microscopy (FE-SEM), and X-ray diffraction (XRD). The modified regenerated cellulose membrane has the excellent rejection of bovine serum albumin (BSA) and anti-fouling performance. The membrane flux of ZrO2/BCM is 321.49 (L/m2·h), and the rejection rate of BSA is 91.2%. Moreover, the membrane flux recovery rate after cleaning with deionized water was 90.6%. This new type of separation membrane prepared with green materials holds broad application potential in water purification and wastewater treatment.
A Fe-doped NiMoO4 pre-catalyst with lattice defects induced by NH3 treatment shows bulk and rapid reconstruction to distorted γ-Ni(Fe)OOH with improved intrinsic activity for water oxidation.
Water scarcity and water pollution have become increasingly severe, and therefore, the purification of water resources has recently garnered increasing attention. Given its position as a major water resource, the efficient purification of drinking water is of crucial importance. In this study, we adopted a phase transition method to prepare ZrO2/BCM (bamboo cellulose membranes), after which we developed IP-ZrO2/BC-NFM (bamboo cellulose nanofiltration membranes) through interfacial polymerization using piperazine (PIP) and tricarbonyl chloride (TMC). Subsequently, we integrated these two membranes to create a combined “ultrafiltration + nanofiltration” membrane process for the treatment of drinking water. The membrane combination process was conducted at 25 °C, with ultrafiltration at 0.1 MPa and nanofiltration at 0.5 MPa. This membrane combination, featuring “ultrafiltration + nanofiltration,” had a significant impact on reducing turbidity, consistently maintaining the post-filtration turbidity of drinking water at or below 0.1 NTU. Furthermore, the removal rates for CODMN and ammonia nitrogen reached 75% and 88.6%, respectively, aligning with the standards for high-quality drinking water. In a continuous 3 h experiment, the nanofiltration unit exhibited consistent retention rates for Na2SO4 and bovine serum protein (BSA), with variations of less than 5%, indicating exceptional separation performance. After 9 h of operation, the water flux of the nanofiltration unit began to stabilize, with a decrease rate of approximately 25%, demonstrating that the “ultrafiltration + nanofiltration” membrane combination can maintain consistent performance during extended use. In conclusion, the “ultrafiltration + nanofiltration” membrane combination exhibited remarkable performance in the treatment of drinking water, offering a viable solution to address issues related to water scarcity and water pollution.
Cellulose membranes have the advantages of good hydrophilicity, excellent mechanical properties, and biodegradability. Therefore, they are the first choice to replace petroleum polymer membranes. In this study, cellulose (BC) and chitosan (CS) were used as raw materials, and N-methylmorpholine-N-oxide (NMMO) was used as solvent. A new kind of cellulose nanofiltration membrane (BC-NFM), cellulose/chitosan nanofiltration membrane (BC/CS-NFM), and interfacial polymerized cellulose/chitosan composite nanofiltration membrane (IP-BC/CS-NFM) were successfully prepared by NaOH hydrolysis and chloroacetic acid carboxymethylation modification, piperazine (PIP), and 1,3,5-trimellitic chloride (TMC) interfacial polymerization, respectively. These two methods were used for the preparation of cellulose nanofiltration membranes for the first time.We also studied their structure, separation performance and their capacity to remove typical pollutants. The results showed that obvious holes appeared on the surface of the nanofiltration membrane obtained by alkali hydrolysis and chloroacetic acid carboxymethylation modification, and the cross-section showed a spongelike structure. The surface of the nanofiltration membrane obtained by interfacial polymerization formed a rough and dense separation layer. The rejection rates of the three kinds of nanofiltration membranes were all over 30% for monovalent salt ions, over 60% for divalent salt ions, over 92% for methyl orange, and over 98% for methyl blue. They had good removal effects for typical pollutants in drinking water.