With the wide application of power equipment consisting of high switching frequencies and large current switching devices in the integrated power system on ships, the low-frequency radiation interference caused by the powerful electromagnetic equipment becomes more and more serious. Establishing an equivalent model of radiation interference based on the near-field measurement data is the key to subsequent electromagnetic compatibility design. Due to the large size of the equipment, there will be many measurement points in the near-field measurement area, which leads to long testing times and low modeling efficiency. To solve the above problems, this article first proposes a method of near-field measurement and a modeling method of powerful electromagnetic equipment radiation based on field distribution characteristics. Firstly, the near-field measurement data are obtained by the sparse and uniform sampling of the near-field measurement plane at large sampling intervals. Then, the near-field measuring plane is separated into several regions by the magnetic field’s distribution characteristics. The near-field measurement data required for modeling are obtained by further sampling in the region with a large magnetic field amplitude. Finally, the equivalent radiation model is obtained by the equivalent dipole method. Simulations and experiments show that the method can significantly reduce the amount of measurement data and testing time while improving the efficiency of equivalent radiation modeling and maintaining the accuracy of the modeling.
9 April 2024 in IEEE Transactions on Electromagnetic Compatibility
The 12-phase rectifier circuit has been widely used in ships, subways, and other systems due to its advantages of high voltage level and high power capacity. As the voltage and current levels, the power capacity increases, leading to higher levels of ${{dv}/ {dt}}$ and ${{di} / {dt}}$ , and electromagnetic interference (EMI) becoming increasingly significant. Therefore, it is pivotal to study the mechanism of conducted EMI in the 12-phase rectifier circuit to establish the foundation for the targeted EMI suppression. At present, there is scarce literature on the generation mechanism of conducted EMI in the rectifier circuit with more than three phases . In addition, there is no existing prediction method for conducted EMI in a 12-phase rectifier circuit combined with the actual switching waveform. Therefore, this article proposes a conducted EMI modeling method for arbitrary 12-phase rectifier circuits with the actual switching waveform based on state transition. This method can not only give the theoretical calculation model of differential mode (DM) and common mode (CM) conducted EMI but also achieve the quantitative prediction of DM and CM conducted EMI combined with the actual switching process. A 12-phase rectifier module is taken as an example to validate the proposed method through circuit simulation and experiment. Furthermore, the influence of unbalanced impedance and the unbalanced power supply on the EMI of the 12-phase rectifier circuit is analyzed. Unbalanced impedance will result in more high-frequency harmonics for the DM, and the unbalanced power supply voltage will result in more high-frequency harmonics for both the DM and CM.
1 January 2026 in IEEE Transactions on Industrial Electronics